3.8 Article

An Experimental Study on the Effect of Stroke-to-Bore Ratio of Atkinson DISI Engines with Variable Valve Timing

期刊

SAE INTERNATIONAL JOURNAL OF ENGINES
卷 11, 期 6, 页码 1183-1193

出版社

SAE INT
DOI: 10.4271/2018-01-1419

关键词

Stroke-to-bore ratio; DISI engine; Atkinson cycle; LIVC; Variable valve timing; Design of experiment

资金

  1. Advanced Automotive Research Center (AARC) at Seoul National University
  2. Institute of Advanced Machinery and Design (IAMD) at Seoul National University
  3. Seoul National University [0420-20160109]
  4. Hyundai Motor Group [0420-20160109]

向作者/读者索取更多资源

In this study, fundamental questions in improving thermal efficiency of spark-ignition engine were revisited, regarding two principal factors, that is, stroke-to-bore (S/B) ratio and valve timings. In our experiment, late intake valve closing (LIVC) camshaft and variable valve timing (VVT) module for valve timing control were equipped in the single-cylinder, direct-injection spark-ignition (DISI) engine with three different S/B ratios (1.00, 1.20, and 1.47). In these three setups, displacement volume and compression ratio (CR) were fixed. In addition, the tumble ratio for cylinder head was also kept the same to minimize the flow effect on the flame propagation caused by cylinder head while focusing on the sole effect of changing the S/B ratio. The experiments were performed in two steps: Firstly, univariate analysis based on the basic input variables-intake camshaft timing, exhaust camshaft timing, and start of injection (SOI)-was conducted to understand the effect of each variable in various load conditions of each S/B ratio. Secondly, design of experiment (DoE) was conducted to find the point of the optimum indicated thermal efficiency of each engine, considering the mutual effect among these input variables. The optimum results showed that at low-load operation (net indicated mean effective pressure (IMEP) 4.5 bar), the values of indicated efficiency are in the order of S/B ratio 1.20 > 1.00 > 1.47, mainly attributed by increased cooling and exhaust loss at higher S/B ratio (i.e., 1.47). However, in case of IMEP 6.5 bar, knock occurrence at lower S/B ratio (i.e., 1.00) led to retarded ignition timing, incurring higher exhaust loss and slower burning rate. In consequence, the best values of the net indicated specific fuel consumption (nisfc) at IMEP 6.5 bar are in the order of S/B ratio 1.20 > 1.47 > 1.00; changing S/B ratio from 1.0 to 1.2 improved nisfc by 1.36%, while changing S/B ratio from 1.2 to 1.47 degraded nisfc by 1.11%.

作者

我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。

评论

主要评分

3.8
评分不足

次要评分

新颖性
-
重要性
-
科学严谨性
-
评价这篇论文

推荐

暂无数据
暂无数据