Fabrication of a high strength ultra-fine grained Al-Mg-SiC nanocomposite by multi-step friction-stir processing

In this study, multi-step friction-stir processing (FSP) was employed to fabricate an ultra-fine grained (UFG) Al matrix nanocomposite with simultaneously enhanced indentation hardness and tensile properties. For this aim, about 3.5 vol.% of SiC nanoparticles were incorporated within an Al-Mg alloy matrix by applying up to five cumulative overlapping FSP passes. Dispersion of nanoparticles at the stirred zone (SZ) and their interfaces with the aluminum matrix were studied by using scanning and electron backscattered electron microscopy. The results showed that the grain and sub-grain structures of the SZ were refined down to about 1.4 pm and less than 1 gm respectively, as a result of dynamic recrystallization (DRX) during FSP. The distribution of grains and their orientations was significantly affected by the presence of SiC nanoparticles during FSP. SiC nanoparticles provided both direct and indirect influences on the strengthening of Al-matrix based on the Orowan looping and grain refinement mechanisms, respectively. The morphology and distribution of precipitates were both broken down and partially dissolved during FSP as well. The processed UFGed nanocomposite exhibited drastically improved hardness, yield stress (YS) and ultimate tensile strength (UTS) by up to 140%, 75% and 60%, respectively, as compared to the annealed Al-Mg alloy. Fractographic features revealed a combined ductile brittle rupture behavior, while the ductile portion was more significant and preserved the elongation of nanocomposite up to about 30%. Finally, the tensile flow behavior of the processed nanocomposite was described using a dislocation-based model which 'suggests that grain boundary strengthening is the dominant mechanism involved.