期刊
JOURNAL OF ORAL REHABILITATION
卷 44, 期 10, 页码 791-799出版社
WILEY
DOI: 10.1111/joor.12543
关键词
articulating paper; dental occlusion; occlusal equilibration; occlusal force; T-Scan; bite force
Studies have explored occlusal marking interpretation, repeatability and accuracy. But, when an occlusion detection product is interposed between teeth, direct tooth-tooth occlusal contact relationships are replaced by tooth-material-tooth structures. Thus, the marks cannot reflect the original contacts. This has been shown for single tooth pair contacts. The purpose of this laboratory study was to similarly examine full dentitions. A dentiform was set into Class I centric occlusion with the mandible supported by a load cell. The maxillary arch was guided by precision slides. As the weighted (similar to 52 N) upper assembly was lowered onto and raised off the mandibular arch, the loads on the mandible were measured. With and without (control) occlusal marking material, the steps were as follows: (cleaning - control 1 material 1)... (cleaning - control 6 - material 6). The six materials were as follows: Accufilm I and II, Rudischhauser Thick and Thin, Hanel Articulating Silk and T-Scan. Then, the six sets of (cleaning - control - material) measurements were repeated with the mandibular assembly shifted, in turn, by 0.1 mm in the Anterior, Posterior, Right and Left directions. The five (Centric and four 0.1 mm shifted) occlusal relationships produced grossly different tooth-tooth (control) load profiles. And, in general, these controls were affected, in different ways, by the marking products. Among the five conventional products, the Rudischhausers fared the worst and the electronic T-Scan was an extreme outlier. Thus, in general, popular occlusal detection products alter the occlusal contact forces, and therefore, their markings cannot characterise the actual occlusion.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据