Experimental Investigation on a Novel Polyelectrolyte Molecular Deposition Film for Improved Injectivity in Low-Permeability Reservoirs

Acrylamide and dimethyl diallyl ammonium chloride were used as monomers to synthesize a polyelectrolyte molecular deposition film (PMDF) injection agent for solving the problem of high injection pressure of water wells in low-permeability reservoirs. The structure of the PMDF injection agent was determined through IR and H-1 nuclear magnetic resonance (NMR). The performance evaluation results show a change of wettability from hydrophilic to neutral wetting with the contact angle changing from 22.32 to 73.31 degrees because of agent injection. It can also change the negative zeta-potential on the surface of the sand to a positive value. For comparison, core displacement experiments involving the commercial Gemini surfactant DF-G reveal that the effects of the depressurization of PMDF are more obvious than those of DF-G. The adsorption stability of the former is better than that of the latter. Especially, under a high-speed water flow of 30 pore volume (PV) injection, the depressurization rate of PMDF is still as high as 43.59%. Finally, the oil-water relative permeability curves and core nuclear magnetic resonance (NMR) experiments demonstrate that the PMDF treatment can reduce the irreducible water saturation, which indicated that the porosity of the flowable part of the core increased and the swept volume was increased. The suitable range of PMDF according to NMR pore-radius distribution within a low-permeability reservoir: the flowable partial pore required the throat radius greater than 0.01 mu m.