Surface Texture after Turning for Various Workpiece Rigidities

In the paper, we present an analysis of the surface texture of turned parts with L/D (length/diameter) ratios of 6 and 12 and various rigidity values. The studies were carried out on samples made of S355JR steel and AISI 304 stainless steel. A detailed analysis of 2D surface profiles was carried out by using a large number of parameters that allowed us to distinguish significant differences in the surface microgeometry, which confirmed that determining surface characteristics from one height parameter (Ra-arithmetical mean height) is far from sufficient. The obtained results indicate significantly better roughness and waviness values of the AISI 304 steel surfaces in terms of its size, periodicity, and regularity. Therefore, the turning process of AISI 304 shafts with low rigidity allows one to be able to achieve better quality texture and have a positive effect on the general properties of a workpiece. In all tested samples, surface irregularities decreased along with the distance from the tailstock. The shafts with an L/D ratio of 12 had worse surfaces in the first two sections due to lower rigidity. The results received close to the three-jaw chuck, regardless of the L/D ratio and material type, demonstrated similar waviness and roughness parameters and profiles.

Automated summary

The study analyzed the surface texture of turned parts with different rigidity values and L/D ratios, showing that AISI 304 stainless steel surfaces have significantly better roughness and waviness values compared to other materials. Low rigidity AISI 304 shafts can achieve higher quality texture and have a positive impact on overall performance, with surface irregularities decreasing along with the distance from the tailstock.