相关参考文献
注意:仅列出部分参考文献,下载原文获取全部文献信息。Measurement of machining forces and surface roughness in turning of AISI 304 steel using alumina-MWCNT hybrid nanoparticles enriched cutting fluid
Anuj Kumar Sharma et al.
MEASUREMENT (2020)
Numerical and experimental analysis of turbulent flow and heat transfer of minimum quantity lubrication in a turning process using discrete phase model
W. El-Bouri et al.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2019)
Multi-point coupling for tool point receptance prediction
Tony Schmitz et al.
JOURNAL OF MANUFACTURING PROCESSES (2019)
An Investigation on Tool Flank Wear Using Alumina/MoS2 Hybrid Nanofluid in Turning Operation
Anuj Kumar Sharma et al.
ADVANCES IN MANUFACTURING ENGINEERING AND MATERIALS, ICMEM 2018 (2019)
A real-time tool failure monitoring system based on cutting force analysis
Xuechun Shi et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2018)
A novel approach for real-time prediction and prevention of tool chipping in intermittent turning machining
M. Hassan et al.
CIRP ANNALS-MANUFACTURING TECHNOLOGY (2018)
Review of tool condition monitoring methods in milling processes
Yuqing Zhou et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2018)
Prediction of temperature distribution over cutting tool with alumina-MWCNT hybrid nanofluid using computational fluid dynamics (CFD) analysis
Anuj Kumar Sharma et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2018)
Influence of graphene and multi-walled carbon nanotube additives on tribological behaviour of lubricants
Rabesh Kumar Singh et al.
INTERNATIONAL JOURNAL OF SURFACE SCIENCE AND ENGINEERING (2018)
Influence of graphene-based nanofluid with minimum quantity lubrication on surface roughness and cutting temperature in turning operation
Rabesh Kumar Singh et al.
MATERIALS TODAY-PROCEEDINGS (2018)
Development of a dynamic surface roughness monitoring system based on artificial neural networks (ANN) in milling operation
AmirMahyar Khorasani et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2017)
Machining chatter in continuous facing under a constant nominal cutting speed: Tool vibration with time-varying delay
Raja Kountanya et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE (2016)
Tool life estimation based on acoustic emission monitoring in end-milling of H13 mould-steel
O. Olufayo et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2015)
TSK-type FLC using a combined LR and GA: Surface roughness prediction in ultraprecision turning
Arup Kumar Nandi
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2006)
Statistical wavelet-based method for structural health monitoring
Z Sun et al.
JOURNAL OF STRUCTURAL ENGINEERING (2004)