4.1 Article

A simple and reliable microfabrication process for a programmable microvalve array

相关参考文献

注意:仅列出部分参考文献,下载原文获取全部文献信息。
Article Multidisciplinary Sciences

Microvalve array fabrication using selective PDMS (polydimethylsiloxane) bonding through Perfluorooctyl-trichlorosilane passivation for long-term space exploration

Zachary Estlack et al.

Summary: This study presents a method to selectively bond polydimethylsiloxane (PDMS) using chemical passivation, solving the issue of PDMS sticking during long-term space exploration. By transferring vaporized perfluorooctyl-trichlorosilane (PFTCS) onto PDMS or glass substrates, a programmable microfluidic array (PMA) for long-term space missions can be successfully fabricated.

SCIENTIFIC REPORTS (2022)

Article Chemistry, Analytical

A fully integrated isotachophoresis with a programmable microfluidic platform

Adam Shebindu et al.

Summary: This study introduces a programmable microfluidic platform (PMP) combined with isotachophoresis (ITP) for fully automated optimization of multiple analytes. By utilizing lifting-gate microvalve technology, a two-dimensional microvalve array was designed and fabricated to seamlessly integrate with an ITP chip for automated buffer selection and repetitive ITP procedures. The optimal buffer combination of 40mM borate and 100mM Tris-HCl successfully preconcentrated all analytes during a single ITP run.

TALANTA (2021)

Article Engineering, Electrical & Electronic

A pneumatically controlled microfluidic rectifier enabling zero backflow under pulsatile flow regime

Ali Khodayari Bavil et al.

Summary: The article introduces a pneumatically controlled microfluidic rectifier (PCMR) developed based on the concept of a transistor, which can prevent backflow in pulsatile flow. The study shows that by adjusting the gate pressure on the PCMR, zero backflow can be achieved, albeit at the cost of pumping efficiency, enabling laminar flow.

JOURNAL OF MICROMECHANICS AND MICROENGINEERING (2021)

Article Engineering, Electrical & Electronic

Accounting for PDMS shrinkage when replicating structures

Morten Hannibal Madsen et al.

JOURNAL OF MICROMECHANICS AND MICROENGINEERING (2014)

Article Engineering, Electrical & Electronic

Mechanical characterization of bulk Sylgard 184 for microfluidics and microengineering

I. D. Johnston et al.

JOURNAL OF MICROMECHANICS AND MICROENGINEERING (2014)

Article Biochemical Research Methods

A reliable and programmable acoustofluidic pump powered by oscillating sharp-edge structures

Po-Hsun Huang et al.

LAB ON A CHIP (2014)

Article Chemistry, Analytical

Lifting Gate Polydimethylsiloxane Microvalves and Pumps for Microfluidic Control

Jungkyu Kim et al.

ANALYTICAL CHEMISTRY (2012)

Article Biochemical Research Methods

Rapid prototyping of microfluidic systems using a PDMS/polymer tape composite

Jungkyu Kim et al.

LAB ON A CHIP (2009)

Article Physics, Applied

Scaling properties of a low-actuation pressure microfluidic valve

V Studer et al.

JOURNAL OF APPLIED PHYSICS (2004)

Article Multidisciplinary Sciences

Monolithic microfabricated valves and pumps by multilayer soft lithography

MA Unger et al.

SCIENCE (2000)