☆ 4.7 Article

Tailoring phase fractions of T' and η' phases in dual-phase strengthened Al-Zn-Mg-Cu alloy via ageing treatment

TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2022)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Nanoscience & Nanotechnology

The effect of pre-ageing/stretching on the ageing-hardening behavior of Al-Zn-Mg-Cu alloys correlated with Zn/Mg ratio

Yan Zou et al.

Summary: Pre-ageing and pre-stretching can significantly affect the precipitation during artificial ageing in Al-Zn-Mg-Cu alloys, leading to improvements in strength and hardness. The effects of pre-ageing are consistent in enhancing strength, while pre-stretching shows varying effects depending on the alloy composition. Both pre-ageing and pre-stretching are effective ways to reduce PFZ width by promoting precipitation near the grain boundary.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Giant hardening response in AlMgZn(Cu) alloys

Lukas Stemper et al.

Summary: This study presents a thermomechanical processing concept that utilizes the full industrial application potential of AlMgZn(Cu) alloys. The beneficial linkage of alloy design and processing achieves a balance between high mechanical strength and good formability while addressing the need for economically feasible processing times. The alloys investigated show high formability and a rapid hardening response, with significant enhancement by the addition of Cu, after short pre-aging treatments and final heat treatments.

ACTA MATERIALIA (2021)

添加到收藏夹

Article Nanoscience & Nanotechnology

Effect of Ag on aging precipitation behavior and mechanical properties of aluminum alloy 7075

Yichang Wang et al.

Summary: The addition of silver increased the hardness and strength of aluminum alloy 7075 by more than 10%, due to a higher number density of fine aggregates.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2021)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Strengthening of aluminium alloy 7005 through imposition of severe plastic deformation supplemented by different ageing treatments

R. Bakhshi et al.

Summary: The study shows that a superior strengthening effect is achieved through the imposition of severe plastic deformation supplemented by post-deformation natural ageing. The yield strength of the alloy increases to over 400 MPa, which is about one-third higher than the value obtained after the usual T6 treatment. This superior strength is mainly attributed to grain refinement, increased dislocation density, and an increased volume fraction of precipitates during natural ageing.

TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Investigation on microstructure and mechanical properties of Al-Zn-Mg-Cu alloys with various Zn/Mg ratios

Yan Zou et al.

Summary: The study investigated the effects of Zn/Mg ratios on the microstructure and mechanical properties of Al-Zn-Mg-Cu alloys aged at 150 degrees C. It was found that an increase in Zn/Mg ratios significantly accelerates the aging process, with the co-existence of T' phase and eta' phase beneficial to the high strength of the alloys.

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2021)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Effects of nano-sized TiB2 particles and Al3Zr dispersoids on microstructure and mechanical properties of Al-Zn-Mg-Cu based materials

Hong-yu Xiao et al.

Summary: This study investigates the effects of TiB2 and Zr on the microstructure, aging response, and mechanical properties of hot-extruded Al-Zn-Mg-Cu based materials. It was found that TiB2 can refine grain size and enhance hardness, while Zr primarily inhibits grain growth. Both additives have some positive impacts on aging kinetics and hardness.

TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2021)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Quench sensitivity and microstructures of high-Zn-content Al-Zn-Mg-Cu alloys with different Cu contents and Sc addition

Ying-hao Peng et al.

Summary: The study found that 7xxx aluminum alloys with high zinc content and Sc addition exhibit higher hardness and increased quench sensitivity. Increasing zinc and copper content leads to higher density of eta and T phases, while Sc addition promotes the formation of Y phase and more eta phases. Compared to the 7085 alloy, simultaneous increase in zinc content and decrease in copper content can enhance hardness and reduce quench sensitivity.

TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2021)

添加到收藏夹

Article Nanoscience & Nanotechnology

Quantified contribution of β and β′ precipitates to the strengthening of an aged Al-Mg-Si alloy

Mingjun Yang et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)

添加到收藏夹

Article Chemistry, Physical

Effect of ageing temperature on microstructure, mechanical property and corrosion behavior of aluminum alloy 7085

Yan Zou et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2020)

添加到收藏夹

Article Chemistry, Physical

Formation of solute nanostructures in an Al-Zn-Mg alloy during long-term natural aging

Jizi Liu et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2020)

添加到收藏夹

Article Chemistry, Physical

Effects of aging treatment on the precipitation behaviors and mechanical properties of Al-5.0Mg-3.0Zn-1.0Cu cast alloys

Hua-Ping Tang et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Age-hardening response of AlMgZn alloys with Cu and Ag additions

Lukas Stemper et al.

ACTA MATERIALIA (2020)

添加到收藏夹

Article Nanoscience & Nanotechnology

Effect of trace Er on the microstructure and properties of Al-Zn-Mg-Cu-Zr alloys during heat treatments

Yichang Wang et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Microstructure and mechanical properties of 7075 aluminum alloy during complex thixoextrusion

Jian Liu et al.

TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Co-precipitation of T' and η' phase in Al-Zn-Mg-Cu alloys

Yan Zou et al.

MATERIALS CHARACTERIZATION (2020)

添加到收藏夹

Article Nanoscience & Nanotechnology

Reversion and re-aging of a peak aged Al-Zn-Mg-Cu alloy

Huan Zhao et al.

SCRIPTA MATERIALIA (2020)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Precipitation kinetics of GP zones, metastable η′ phase and equilibrium η phase in Al-5.46wt.%Zn-1.67wt.%Mg alloy

A. Khalfallah et al.

TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2019)

添加到收藏夹

Review Chemistry, Physical

Recent advances in ageing of 7xxx series aluminum alloys: A physical metallurgy perspective

Abolfazl Azarniya et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2019)

添加到收藏夹

Article Chemistry, Physical

The effect of Cu and Sc on the localized corrosion resistance of Al-Zn-Mg-X alloys

Li Liu et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2019)

添加到收藏夹

Article Microscopy

Coherent strain of Guinier-Preston II zone in an Al-Zn-Mg-Cu alloy

Xiaohu Hou et al.

MICRON (2019)

添加到收藏夹

Article Nanoscience & Nanotechnology

Microstructure and strength of a novel heat-resistant aluminum alloy strengthened by T-Al6Mg11Zn11 phase at elevated temperatures

Naoki Takata et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)

添加到收藏夹

Article Nanoscience & Nanotechnology

Influence of Zn on the distribution and composition of heterogeneous solute-rich features in peak aged Al-Mg-Si-Cu alloys

M. X. Guo et al.

SCRIPTA MATERIALIA (2019)

添加到收藏夹

Article Materials Science, Multidisciplinary

Atomic scale HAADF-STEM study of η′ and η1 phases in peak-aged Al-Zn-Mg alloys

Artenis Bendo et al.

JOURNAL OF MATERIALS SCIENCE (2018)

添加到收藏夹

Article Nanoscience & Nanotechnology

Nano-scale precipitate evolution and mechanical properties of 7085 aluminum alloy during thermal exposure

Pan Dai et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)

添加到收藏夹

Article Nanoscience & Nanotechnology

Improved bake-hardening response of Al-Zn-Mg-Cu alloy through pre-aging treatment

Yun-Soo Lee et al.

SCRIPTA MATERIALIA (2018)

添加到收藏夹

Article Nanoscience & Nanotechnology

Structure-property models in Al-Zn-Mg-Cu alloys: A critical experimental assessment of shape castings

Reza Ghiaasiaan et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)

添加到收藏夹

Article Chemistry, Physical

Improved age-hardening response and altered precipitation behavior of Al-5.2Mg-0.45Cu-2.0Zn (wt%) alloy with pre-aging treatment

Cheng Cao et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2017)

添加到收藏夹

Article Nanoscience & Nanotechnology

Evaluation of strain fields caused by the η′ phase in an Al-Zn-Mg-Cu alloy

Xiaohu Hou et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)

添加到收藏夹

Article Engineering, Industrial

Non-isothermal ageing of an Al-8Zn-2Mg-2Cu alloy for enhanced properties

J. T. Jiang et al.

JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2016)

添加到收藏夹

Article Materials Science, Multidisciplinary

Influence of length-scales on spatial distribution and interfacial characteristics of B4C in a nanostructured Al matrix

Lin Jiang et al.

ACTA MATERIALIA (2015)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Microstructure and mechanical properties of high strength Al-Zn-Mg-Cu alloys used for oil drill pipes

Chun Feng et al.

TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2015)

添加到收藏夹

Article Chemistry, Physical

A high-strength AlZnMg alloy hardened by the T-phase precipitates

X. B. Yang et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2014)

添加到收藏夹

Article Materials Science, Multidisciplinary

Experiment and multiscale modeling of the coupled influence of constituents and precipitates on the ductile fracture of heat-treatable aluminum alloys

G Liu et al.

ACTA MATERIALIA (2005)

添加到收藏夹

Article Materials Science, Multidisciplinary

Early-stage precipitation in Al-Zn-Mg-Cu alloy (7050)

G Sha et al.

ACTA MATERIALIA (2004)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.