☆ 4.7 Article

Water vapor effects on the oxidation resistance of modified potassium silicate coating at high temperature

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2024)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Computer Science, Interdisciplinary Applications

Piecewise affine model identification and predictive control for ultra-supercritical circulating fluidized bed boiler unit

Chen Yang et al.

Summary: In this paper, an improved subspace identification method based on the steady-state points' deviations data was proposed to identify piecewise affine model, fully considering the form of the nonlinear model after linearization. The method demonstrates better adaptability to strong nonlinear systems with identification normalized root mean square error mostly less than 10% for each working condition. A widely applicable framework for complex system control is established, combining with the mixed logic dynamic model and performing canonical form realization to transfer local models into the same state basis. The effectiveness of the framework is validated through predictive control on the boiler-turbine system of the 660-MW ultrasupercritical circulating fluidized bed unit.

COMPUTERS & CHEMICAL ENGINEERING (2023)

添加到收藏夹

Article Materials Science, Multidisciplinary

An organic silicone composite coating for protection of Ti-6Al-4V alloy: Oxidation behavior at 600 C in dry air

Yiliang Lu et al.

Summary: A new organic silicone composite coating modified by Al, ZrO2, quartz and PbO-SiO2-Al2O3 glass powders was developed to protect Ti-6Al-4V alloy. The coating was oxidized at 600 degrees C, forming an inorganic composite coating composed of amorphous silica framework and fillers, which effectively reduced the oxidation rate of the alloy. The formation of Al2SiO5 in the coating was attributed to the reaction between Al and glass. The glass powders with a softening point of 385 degrees C was found to improve the protective properties of the coating by filling the cavities formed by oxidation of organic components.

CORROSION SCIENCE (2023)

添加到收藏夹

Article Chemistry, Multidisciplinary

Corrosion protection of carbon steel using a combination of Zr conversion coating and subsequent zinc-rich silicate coating with a flake ZnAl alloy

Nguyen Hoang et al.

Summary: This study investigates the use of zirconium pretreatment and partial replacement of spherical zinc with flake ZnAl alloy to enhance the corrosion protection properties of zinc-rich silicate coatings on steel. The results show that the zirconium pre-treated layer with (3-aminopropyl)triethoxysilane improves the corrosion protection of the bare steel. Additionally, the inclusion of flake ZnAl pigment significantly improves corrosion resistance and prolongs the duration of cathodic protection in the coatings.

ARABIAN JOURNAL OF CHEMISTRY (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Influence of cooling rate on δ-ferrite/γ-austenite formation and precipitation behavior of 18Cr-Al-Si ferritic heat-resistant stainless steel

Yingbo Zhang et al.

Summary: The formation and precipitation behavior of delta-ferrite/gamma-austenite in 18Cr-Al-Si FHSS during solidification were investigated. It was found that the cooling rate affects the phase transformation process, and gamma-austenite first precipitated at the delta-ferrite phase boundaries and then appeared within the delta-ferrite phase, with some of it transforming into martensite.

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2022)

添加到收藏夹

Article Materials Science, Ceramics

Effect of Al2O3 content on microstructure and oxidation behavior of silicate enamel coatings on a Ni-based superalloy at 1000?C

Fengjie Li et al.

Summary: This study investigated the microstructural evolution and cyclic oxidation behavior of silicate enamel coating with different contents of Al2O3 on K444 superalloy. The results showed that high content of Al2O3 can effectively inhibit crystal precipitation and mass loss, and enhance oxidation resistance and bonding strength through the formation of a continuous alumina scale at the interface.

CERAMICS INTERNATIONAL (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Effect of 6-ferrite on the corrosion resistance of the 9Cr high nitrogen heat-resistant martensitic-steel

Liang Liang et al.

Summary: It has been found that 6-ferrite can accelerate the formation of adherent corrosion layer in high nitrogen heat-resistant martensitic steel, thereby improving the corrosion resistance of the steel.

MATERIALS LETTERS (2022)

添加到收藏夹

Article Materials Science, Ceramics

Effects of adhesive modulus and curing conditions on curing behavior of silicate based ceramic coatings on carbon fiber reinforced resin matrix composites

Meimei Ji et al.

Summary: In the preparation of ceramic coatings on carbon fiber reinforced epoxy resin matrix composite surface using sodium silicate, the modulus of adhesive, curing agent, temperature, and time all significantly influence the curing behavior of the coatings. It was found that coatings with a modulus of 2.7 of silicate adhesive were dense and continuous, with SiO2 as a better curing agent than Na2SiF6. Curing at 100 degrees C for an extended time improved the characteristics of the coatings.

CERAMICS INTERNATIONAL (2021)

添加到收藏夹

Article Materials Science, Ceramics

A study into enhanced oxidation resistance and its mechanism in Cr1-xAlxN/CrN/Cr multilayer films deposited on 9-12 % Cr heat-resistant steel

Wen-Sheng Yang et al.

Summary: The Cr1-xAlxN/CrN/Cr multilayer films were deposited on 9-12% Cr heat-resistant steel using DCMS with various Al contents. It was found that Al atoms substituted for Cr atoms without changing the crystal structure. The Al doping decreased lattice constants, hindered grain growth, reduced film roughness, and enhanced oxidation resistance by forming an amorphous oxide surface layer.

CERAMICS INTERNATIONAL (2021)

添加到收藏夹

Article Materials Science, Ceramics

Effects of the chemistry of coating and substrate on the steam oxidation kinetics of environmental barrier coatings for ceramic matrix composites

K. N. Lee et al.

Summary: NASA improved the lifespan of EBCs by modifying the chemistry of Gen 2 EBC, leading to a reduction in TGO thickness. Researchers also found correlations between the chemistry of EBC and CMC, and the growth rates of TGO.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Protection of 304 stainless steel by nano-modified silicone coating in cyclically alternate corrosion environment

Yiliang Lu et al.

Summary: A nano-modified silicone-based composite coating was developed to protect 304 stainless steel under cyclically alternate corrosion conditions. The coating consists of a continuous amorphous SiO2 matrix, dispersive Al, Al2O3, TiO2 and ZrO2 particles, and discrete voids, which significantly improved the corrosion resistance of 304SS in environments containing NaCl deposit and oxygen at 400 degrees Celsius.

CORROSION SCIENCE (2021)

添加到收藏夹

Article Chemistry, Multidisciplinary

Interaction of Aluminum Metaphosphates in the Setting of Potassium Silicate Solutions in Terms of the Crystalline Phase Composition.

Ali Masoudi Alavi et al.

CHEMISTRYOPEN (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Enhanced oxidation and corrosion inhibition of 1Cr11Ni2W2MoV stainless steel by nano-modified silicone-based composite coatings at 600°C

Yao Du et al.

CORROSION SCIENCE (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Hot Deformation Characteristic and Optimization of Processing Parameters for 0.1C-18Cr-1Al-1Si Ferritic Heat Resistant Stainless Steel

Yingbo Zhang et al.

MATERIALS TRANSACTIONS (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Kinetics of foaming process of potassium silicate gel at high temperature

Lei Xu et al.

MATERIALS LETTERS (2020)

添加到收藏夹

Article Instruments & Instrumentation

Low infrared emissivity of the Cr39Ni7C/inorganic silicate coatings with excellent heat-resistant

Bo Zhang et al.

INFRARED PHYSICS & TECHNOLOGY (2018)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Initial Stage Oxidation and Surface Morphology of Modified 9Cr-1Mo Steel at High Temperatures in Air

M. Archana et al.

TRANSACTIONS OF THE INDIAN INSTITUTE OF METALS (2017)

添加到收藏夹

Article Nanoscience & Nanotechnology

Evaluation of creep rupture strength of high nitrogen ferritic heat-resistant steels using small punch creep testing technique

Naveena et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2016)

添加到收藏夹

Article Materials Science, Multidisciplinary

Microstructure and oxidation behavior of a SiC-Al2O3-glass composite coating on Ti-47Al-2Cr-2Nb alloy

Wenbo Li et al.

CORROSION SCIENCE (2014)

添加到收藏夹

Article Materials Science, Multidisciplinary

Oxidation inhibition of γ-TiAl alloy at 900°C by inorganic silicate composite coatings

Cheng Wang et al.

CORROSION SCIENCE (2013)

添加到收藏夹

Article Chemistry, Multidisciplinary

Synergistic effect of potassium metal siliconate on silicate conversion coating for corrosion protection of galvanized steel

Jaekyu Min et al.

JOURNAL OF INDUSTRIAL AND ENGINEERING CHEMISTRY (2012)

添加到收藏夹

Article Materials Science, Multidisciplinary

Anti-corrosion performance of waterborne Zn-rich coating with modified silicon-based vehicle and lamellar Zn(Al) pigments

Liuyan Zhang et al.

PROGRESS IN NATURAL SCIENCE-MATERIALS INTERNATIONAL (2012)

添加到收藏夹

Review Chemistry, Applied

Improving the corrosion protection properties of organically modified silicate-epoxy coatings by incorporation of organic and inorganic inhibitors

A. C. Balaskas et al.

PROGRESS IN ORGANIC COATINGS (2011)

添加到收藏夹

Article Materials Science, Multidisciplinary

Effects of water vapour on isothermal oxidation of chromia-forming alloys in Ar/O2 and Ar/H2 atmospheres

N. K. Othman et al.

CORROSION SCIENCE (2009)

添加到收藏夹

Article Materials Science, Ceramics

Phase evolution on heat treatment of sodium silicate water glass

Raghavan Subasri et al.

JOURNAL OF NON-CRYSTALLINE SOLIDS (2008)

添加到收藏夹

Review Materials Science, Multidisciplinary

The oxidation behaviour of metals and alloys at high temperatures in atmospheres containing water vapour: A review

S. R. J. Saunders et al.

PROGRESS IN MATERIALS SCIENCE (2008)

添加到收藏夹

Article Chemistry, Applied

Monitoring the structure of water soluble silicates

Istvan Halasz et al.

CATALYSIS TODAY (2007)

添加到收藏夹

Article Materials Science, Multidisciplinary

Enhanced oxidation of the 9%Cr steel P91 in water vapour containing environments

J. Ehlers et al.

CORROSION SCIENCE (2006)

添加到收藏夹

Article Materials Science, Coatings & Films

An investigation into fire protection and water resistance of intumescent nano-coatings

Zhenyu Wang et al.

SURFACE & COATINGS TECHNOLOGY (2006)

添加到收藏夹

Article Materials Science, Ceramics

Alumina volatility in water vapor at elevated temperatures

EJ Opila et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2004)

添加到收藏夹

Review Chemistry, Applied

Effects of particle sizes and shapes of zinc metal on the properties of anticorrosive coatings

A Kalendová

PROGRESS IN ORGANIC COATINGS (2003)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Evidence for chromium evaporation influencing the oxidation of 304L: The effect of temperature and flow rate

H Asteman et al.

OXIDATION OF METALS (2002)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.