4.7 Article

Autoignition of methane/coal particle/air mixture under constant-volume conditions

相关参考文献

注意:仅列出部分参考文献,下载原文获取全部文献信息。
Article Energy & Fuels

Influence of pressure and dilution gas on the explosion behavior of methane-oxygen mixtures

Yada Leo et al.

Summary: This study investigates the influence of initial pressure and dilution gas on the explosion behavior of CH4-O2 mixtures. The experimental results show that the maximum explosion pressure and the maximum explosion pressure change rate increase linearly with the initial pressure. The influence of dilution gas on the explosion intensities and flame speed is in the order of CO2, N2, Ar, and He.
Article Energy & Fuels

Numerical evaluation of the influence of initial pressure/temperature on the explosion properties and soot formation of methane/coal volatiles mixtures

Minggao Yu et al.

Summary: In this study, a model based on chemical reaction kinetics was established to describe both chain reactions and product growth for methane/coal volatiles explosions. The impact of initial temperature and pressure on the deflagration features of the mixtures was calculated. Simulation results showed that the initial pressure had a significant positive effect on Pmax, while the initial temperature had a negative effect on Pmax but a positive effect on Tmax. The sensitivity of primary elementary reactions to initial temperature was greater than that to initial pressure. Increasing both initial pressure and temperature would promote the growth of C(B) and accelerate the formation of soot particles.
Article Thermodynamics

Effects of dilute coal char particle suspensions on propagating methane detonation wave

Jingtai Shi et al.

Summary: This study investigates the impact of particle concentration and size on the propagation of methane detonation wave in coal particle suspensions. It also examines the structure and coupling of hybrid detonation and the influence of coal particle surface reactions on gas chemistry. The findings are valuable for the prevention and suppression of methane/coal dust hybrid detonation.

COMBUSTION AND FLAME (2023)

Article Thermodynamics

Aluminum combustion in strong convective flows

Stany Gallier

Summary: This paper investigates the behavior of aluminum combustion in high-speed flows and identifies a transition from diffusion-limited to kinetic-limited combustion regimes. The combustion mass rate increases with Reynolds number Red and is accurately described by the Ranz-Marshall correlation when Red is estimated at flame conditions. A Damkohler number Da* is proposed to characterize this diffusion/kinetic regime, and a correction on the burning time is suggested based on Da*. This study confirms the existence of a flow-induced transitional regime for aluminum combustion with significant implications for the burning time of aluminum droplets in strong convective flows.

COMBUSTION AND FLAME (2023)

Article Thermodynamics

Detailed chemistry modeling of rotating detonations with dilute n-heptane sprays and preheated air

Shan Jin et al.

Summary: The utilization of liquid fuels is crucial for the commercialization of rotating detonation engines (RDE). This study conducts simulations to analyze the combustion process of rotating detonation with dilute n-heptane sprays and preheated air. The results reveal the heterogeneous mixture in the refill zone, consisting of evaporating droplets, vapor, and air.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2023)

Article Thermodynamics

Transmission of hydrogen detonation across a curtain of dilute inert particles

Yong Xu et al.

Summary: This study simulated the transmission of a hydrogen detonation wave in an inert particle curtain using the Eulerian-Lagrangian approach. By utilizing a detailed chemical mechanism and a two-dimensional computational domain, parametric studies were conducted to examine the effects of particle sizes, concentrations, and curtain thicknesses on the propagation and extinction of the detonation wave. The results revealed different propagation modes and highlighted the importance of factors such as particle concentration and curtain thickness. The study also analyzed the evolution of curtain morphologies and the influence of curtain thickness on characteristic time.

COMBUSTION AND FLAME (2023)

Article Thermodynamics

Interactions between a propagating detonation wave and circular water cloud in hydrogen/air mixture

Yong Xu et al.

Summary: Interactions between a propagating hydrogen/air detonation wave and a circular water cloud were investigated. The study examined the effects of droplet and cloud properties on the peak pressure trajectory of the detonation wave. Three propagation modes were identified: perturbed propagation, leeward re-detonation, and detonation extinction. The analysis also explored two-phase fluid interfacial instability and evaluated the influences of droplet concentration on cloud morphology and vorticity evolution.

COMBUSTION AND FLAME (2022)

Article Thermodynamics

Effect of ammonia/oxygen/nitrogen equivalence ratio on spherical turbulent flame propagation of pulverized coal/ammonia co-combustion

Yu Xia et al.

Summary: This paper reports the fundamental mechanism of flame propagation for pulverized coal/ammonia co-combustion, with experiments clarifying the effects of equivalence ratio of ammonia-oxidizer mixture on flame propagation velocity. Results suggest that the flame propagation velocity of pulverized coal/ammonia was higher than that of pure coal combustion, with variations depending on the equivalence ratio. The unique mechanism includes three competing effects, explaining the relationship between flame propagation velocity and equivalence ratio in ammonia lean and rich conditions.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2021)

Article Thermodynamics

Effect of fuel ratio of coal on the turbulent flame speed of ammonia/coal particle cloud co-combustion at atmospheric pressure

Khalid Hadi et al.

Summary: The study focused on the impact of coal fuel ratio on turbulent flame speed of ammonia/coal particle cloud co-combustion. Results showed that low equivalence ratio co-combustion with ammonia resulted in significantly faster flame speeds compared to pure coal or pure ammonia combustion, while high-fuel-ratio coals showed lower flame speeds compared to pure ammonia combustion. The study proposes a flame propagation mechanism for the co-combustion, highlighting the role of local equivalence ratio and radiation heat flux in influencing flame speed.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2021)

Article Thermodynamics

Reaction modeling study on the combustion of aluminum in gas phase: The Al + O2 and related reactions

Masatoshi Saba et al.

Summary: A detailed chemical kinetic model of aluminum oxidation in gas phase has been constructed using quantum chemical calculations and experimental data to determine the primary oxidation pathway and important intermediates and transition states in the reactions.

COMBUSTION AND FLAME (2021)

Article Energy & Fuels

Eulerian-Lagrangian modelling of detonative combustion in two-phase gas-droplet mixtures with OpenFOAM: Validations and verifications

Zhiwei Huang et al.

Summary: RYrhoCentralFoam is a hybrid Eulerian-Lagrangian solver developed based on OpenFOAM (R) for simulating detonative combustion in two-phase gas-liquid mixtures with high accuracy and diverse functionalities.
Article Engineering, Chemical

Influence of thermal radiation on layered dust explosions

Swagnik Guhathakurta et al.

Summary: The study utilized multidimensional unsteady numerical simulations to investigate the impact of gray radiation on the propagation and structure of layered coal dust explosions. Results indicated that the gray radiation significantly influences the dust flame propagation but can have differing effects depending on the scenario.

JOURNAL OF LOSS PREVENTION IN THE PROCESS INDUSTRIES (2021)

Article Engineering, Environmental

Hybrid CH4/coal dust explosions in a 20-L spherical vessel

Shi-xiang Song et al.

PROCESS SAFETY AND ENVIRONMENTAL PROTECTION (2019)

Article Engineering, Environmental

Lower flammability limits of hybrid mixtures containing 10 micron coal dust particles and methane gas

Chris T. Cloney et al.

PROCESS SAFETY AND ENVIRONMENTAL PROTECTION (2018)

Review Engineering, Chemical

Estimation of the deflagration index Kst for dust explosions: A review

Anna Fumagalli et al.

JOURNAL OF LOSS PREVENTION IN THE PROCESS INDUSTRIES (2016)

Article Engineering, Chemical

Structure and flame speed of dilute and dense layered coal-dust explosions

Ryan W. Houim et al.

JOURNAL OF LOSS PREVENTION IN THE PROCESS INDUSTRIES (2015)

Article Thermodynamics

Numerical simulation of dilute and dense layered coal-dust explosions

Ryan W. Houim et al.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2015)

Article Thermodynamics

A comparison of various models in predicting ignition delay in single-particle coal combustion

Babak Goshayeshi et al.

COMBUSTION AND FLAME (2014)

Article Thermodynamics

Transported PDF modeling of pulverized coal jet flames

Xin-Yu Zhao et al.

COMBUSTION AND FLAME (2014)

Article Construction & Building Technology

CFD modelling of ventilation and dust flow behaviour above an underground bin and the design of an innovative dust mitigation system

Ting Ren et al.

TUNNELLING AND UNDERGROUND SPACE TECHNOLOGY (2014)

Article Thermodynamics

Influence of coal dust on premixed turbulent methane-air flames

Scott R. Rockwell et al.

COMBUSTION AND FLAME (2013)

Article Thermodynamics

PDF modeling and simulations of pulverized coal combustion - Part 2: Application

Michael Stoellinger et al.

COMBUSTION AND FLAME (2013)

Article Engineering, Chemical

Methane-air detonation experiments at NIOSH Lake Lynn Laboratory

R. K. Zipf et al.

JOURNAL OF LOSS PREVENTION IN THE PROCESS INDUSTRIES (2013)

Review Thermodynamics

Oxy-fuel combustion of pulverized coal: Characterization, fundamentals, stabilization and CFD modeling

Lei Chen et al.

PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2012)

Article Engineering, Chemical

Modelling the effect of particle size on dust explosions

A. Di Benedetto et al.

CHEMICAL ENGINEERING SCIENCE (2010)

Article Thermodynamics

Aluminum Particle Combustion in High-Speed Detonation Products

V. Tanguay et al.

COMBUSTION SCIENCE AND TECHNOLOGY (2009)

Article Thermodynamics

Modelling pulverised coal combustion using a detailed coal combustion model

RI Backreedy et al.

COMBUSTION SCIENCE AND TECHNOLOGY (2006)

Article Thermodynamics

Modes of reaction front propagation from hot spots

XJ Gu et al.

COMBUSTION AND FLAME (2003)

Article Energy & Fuels

Modelling coal combustion: the current position

A Williams et al.

Article Mechanics

Modeling and numerical simulation of particulate flows by the Eulerian-Lagrangian approach

NA Patankar et al.

INTERNATIONAL JOURNAL OF MULTIPHASE FLOW (2001)

Article Engineering, Chemical

Experimental mine and laboratory dust explosion research at NIOSH

MJ Sapko et al.

JOURNAL OF LOSS PREVENTION IN THE PROCESS INDUSTRIES (2000)