☆ 4.6 Article

CFD-DEM simulation of heat transfer in spout-fluid beds

CHEMICAL ENGINEERING RESEARCH & DESIGN (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Engineering, Chemical

A comprehensive comparison of Two-Fluid Model, Discrete Element Method and experiments for the simulation of single- and multiple-spout fluidized beds

Behrad Esgandari et al.

Summary: In this study, a two-fluid model (TFM) and a computational fluid dynamics coupled to discrete element method (CFD-DEM) approach are employed to investigate the hydrodynamics of single and multiple-spout fluidized beds. The simulations are validated against experimental data and the results show good agreement between the TFM and CFD-DEM approaches in terms of volume fraction, solids velocities, solids fluxes, and granular temperature.

CHEMICAL ENGINEERING SCIENCE (2023)

添加到收藏夹

Review Engineering, Chemical

Gas jet penetration in gas-solid fluidized and jetting-fluidized beds-A review

Pierre Sauriol et al.

Summary: The high velocity injection of gas in a particulate system leads to the formation of a gas-solid structure characterized by enhanced momentum, mass, and heat transfers. This review focuses on the empirical correlations developed to predict the jet penetration length and half-angle at various operating conditions in different bed configurations in gas-solid fluidized beds. It also discusses the advances in modeling efforts, scale-up issues, and proposes an iterative approach for designing and scaling up injection systems in a gas-solid fluidized bed.

POWDER TECHNOLOGY (2023)

添加到收藏夹

Article Engineering, Chemical

Solid-fluid mixing behavior of conical spouted beds with internal devices

A. Atxutegi et al.

Summary: This study investigates the effect of draft tubes and fountain confiners on the gas and solids mixing behavior in conical spouted beds. The results show that these devices significantly improve the gas residence time and particle cycle time distributions, especially when high inlet gas flow rates are desired.

ADVANCED POWDER TECHNOLOGY (2023)

添加到收藏夹

Article Engineering, Chemical

CFD simulation of the ethylbenzene dehydrogenation reaction in the fixed bed reactor with a cylindrical catalyst of various sizes

Sergei A. Solovev et al.

Summary: In this paper, the Discrete Element Method was utilized to investigate the impact of catalytic granule size on the efficiency of a bed reactor for the ethylbenzene dehydrogenation reaction. The analysis included an evaluation of catalyst total surface area and porosity effects in relation to particle size. Results showed varying reaction product concentration, pressure drops, and reactor productivity for different particle sizes investigated.

CHEMICAL PRODUCT AND PROCESS MODELING (2022)

添加到收藏夹

Article Engineering, Chemical

Particle shape effect on hydrodynamics and heat transfer in spouted bed: A CFD-DEM study

E. Dianyu et al.

Summary: By investigating the effects of particle shape on hydrodynamics and heat transfer in a spouted bed, this study found that prolate spheroids form the largest bubbles and rise the highest, while oblate spheroids exhibit better heat transfer performance. Compared to spherical particles, ellipsoidal spheroids have better mobility and heat transfer efficiency.

PARTICUOLOGY (2022)

添加到收藏夹

Review Engineering, Chemical

On the drag force closures for multiphase flow modeling

Hamid Reza Norouzi et al.

Summary: This article investigates the accuracies, implementation issues, and limitations of drag force models for various systems, collecting data points from multiple sources to evaluate their performance. A comprehensive discussion on the accuracy and application of these models, specifically on mono-dispersed and poly-dispersed spherical particles, is provided in the article.

CHEMICAL PRODUCT AND PROCESS MODELING (2022)

添加到收藏夹

Article Engineering, Chemical

Fluidization of elongated particles-Effect of multi-particle correlations for drag, lift, and torque in CFD-DEM

Ivan Mema et al.

Summary: This study compared the performance of multi-particle correlations and single-particle correlations in predicting particle orientation and velocity in CFD-DEM simulations of elongated particles in a fluidized bed. The results demonstrated that multi-particle correlations improve the accuracy of prediction and highlight the importance of including hydrodynamic torque.

AICHE JOURNAL (2021)

添加到收藏夹

Article Engineering, Chemical

Gas-solid mixing and heat transfer performance in alternating spout deflection

Yuanhe Yue et al.

Summary: In this study, the alternating spout deflection (ASD) is compared with the spout-fluidisation (SF) flow pattern in terms of gas-solid hydrodynamics, mixing, and heat transfer performance using a Computer Fluid Dynamic-Discrete Element Method (CFDDEM) model. The ASD shows advantages in terms of particle packing state, mixing performance, and heat transfer efficiency compared to SF.

CHEMICAL ENGINEERING SCIENCE (2021)

添加到收藏夹

Article Chemistry, Multidisciplinary

Fine particle flow pattern and region delimitation in fountain confined conical spouted beds

Mikel Tellabide et al.

Summary: A novel borescopic technique combined with pressure fluctuation signal monitoring has been used to study solid flow dynamics in confined conical spouted beds. The study reveals characteristics of particle velocity distribution under different configurations and outlines interfaces within the spout-annulus and fountain core-periphery. Among the configurations analyzed, the system without draft tube exhibits the highest vertical particle velocities, showing unique spout expansion patterns compared to literature correlations.

JOURNAL OF INDUSTRIAL AND ENGINEERING CHEMISTRY (2021)

添加到收藏夹

Article Engineering, Chemical

CFD-DEM analysis of the spouted fluidized bed with non-spherical particles

Behrad Esgandari et al.

Summary: The hydrodynamics of spouted fluidized beds containing spherical and sphero-cylindrical particles with an aspect ratio of 4 were studied using the CFD-DEM technique. The simulation results showed differences in bubble properties, solid circulation rate, and particle transition behavior between the two types of particles. The CFD-DEM approach was found to be a promising method for investigating fluid dynamics and particle behaviors in spouted fluidized beds.

CANADIAN JOURNAL OF CHEMICAL ENGINEERING (2021)

添加到收藏夹

Article Engineering, Chemical

On the treatment of bed-to-wall heat transfer in CFD-DEM simulations of gas-fluidized beds

Xin Liu et al.

Summary: The study investigates the heat transfer mechanism near the confining walls in fluidized beds using two approaches, validating them with experimental results and comparing their performance in predicting overall particle temperature distribution, parameter sensitivity, and mesh resolution.

CHEMICAL ENGINEERING SCIENCE (2021)

添加到收藏夹

Article Engineering, Chemical

Hydrodynamic and Heat Transfer Study of a Fluidized Bed by Discrete Particle Simulations

Lijing Mu et al.

PROCESSES (2020)

添加到收藏夹

Review Engineering, Chemical

Review and implementation of CFD-DEM applied to chemical process systems

Shahab Golshan et al.

CHEMICAL ENGINEERING SCIENCE (2020)

添加到收藏夹

Article Engineering, Chemical

A CFD-DEM model for the simulation of direct reduction of iron-ore in fluidized beds

M. E. Kinaci et al.

CHEMICAL ENGINEERING SCIENCE (2020)

添加到收藏夹

Article Engineering, Chemical

Particle-scale study of spout deflection in a flat-bottomed spout fluidized bed

Yuanhe Yue et al.

CHEMICAL ENGINEERING SCIENCE (2019)

添加到收藏夹

Article Mechanics

Drag, lift and torque correlations for non-spherical particles from Stokes limit to high Reynolds numbers

Sathish K. P. Sanjeevi et al.

INTERNATIONAL JOURNAL OF MULTIPHASE FLOW (2018)

添加到收藏夹

Article Thermodynamics

Numerical simulation of heat transfer in packed pebble beds: CFD-DEM coupled with particle thermal radiation

Hao Wu et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2017)

添加到收藏夹

Article Thermodynamics

Extension of a coarse grained particle method to simulate heat transfer in fluidized beds

Liqiang Lu et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2017)

添加到收藏夹

Article Engineering, Chemical

A recurrence CFD study of heat transfer in a fluidized bed

T. Lichtenegger et al.

CHEMICAL ENGINEERING SCIENCE (2017)

添加到收藏夹

Article Engineering, Chemical

A modified cohesion model for CFD-DEM simulations of fluidization

Yile Gu et al.

POWDER TECHNOLOGY (2016)

添加到收藏夹

Article Engineering, Environmental

Comparison of CFD-DEM heat transfer simulations with infrared/visual measurements

A. V. Patil et al.

CHEMICAL ENGINEERING JOURNAL (2015)

添加到收藏夹

Article Engineering, Environmental

A study of heat transfer in fluidized beds using an integrated DIA/PIV/IR technique

Amit V. Patil et al.

CHEMICAL ENGINEERING JOURNAL (2015)

添加到收藏夹

Article Engineering, Chemical

Bed-to-surface heat transfer in conical spouted beds of biomass-sand mixtures

Juan F. Saldarriaga et al.

POWDER TECHNOLOGY (2015)

添加到收藏夹

Article Engineering, Chemical

Computational study of particle temperature in a bubbling spout fluidized bed with hot gas injection

A. V. Patil et al.

POWDER TECHNOLOGY (2015)

添加到收藏夹

Article Engineering, Environmental

Influences of operating parameters on the hydrodynamics of a 3-D spout-fluid bed based on DEM modeling approach

Shiliang Yang et al.

CHEMICAL ENGINEERING JOURNAL (2014)

添加到收藏夹

Article Thermodynamics

Transient gas-to-particle heat transfer measurements in a spouted bed

Steven L. Brown et al.

EXPERIMENTAL THERMAL AND FLUID SCIENCE (2013)

添加到收藏夹

Article Thermodynamics

Models, algorithms and validation for opensource DEM and CFD-DEM

Christoph Kloss et al.

PROGRESS IN COMPUTATIONAL FLUID DYNAMICS (2012)

添加到收藏夹

Article Mechanics

Drag law for monodisperse gas-solid systems using particle-resolved direct numerical simulation of flow past fixed assemblies of spheres

S. Tenneti et al.

INTERNATIONAL JOURNAL OF MULTIPHASE FLOW (2011)

添加到收藏夹

Article Engineering, Chemical

A new computational method for studying heat transfer in fluid bed reactors

Z. Y. Zhou et al.

POWDER TECHNOLOGY (2010)

添加到收藏夹

Article Engineering, Chemical

Particle Scale Study of Heat Transfer in Packed and Bubbling Fluidized Beds

Z. Y. Zhou et al.

AICHE JOURNAL (2009)

添加到收藏夹

Article Engineering, Chemical

PEPT and discrete particle simulation study of spout-fluid bed regimes

J. M. Link et al.

AICHE JOURNAL (2008)

添加到收藏夹

Review Engineering, Chemical

Review of discrete particle modeling of fluidized beds

N. G. Deen et al.

CHEMICAL ENGINEERING SCIENCE (2007)

添加到收藏夹

Article Engineering, Chemical

Flow regimes in a spout-fluid bed: A combined experimental and simulation study

JM Link et al.

CHEMICAL ENGINEERING SCIENCE (2005)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.