4.7 Article

Size-effects in tensile fracture of rejuvenated and annealed metallic glass

相关参考文献

注意:仅列出部分参考文献,下载原文获取全部文献信息。
Article Materials Science, Multidisciplinary

Anelastic-like nature of the rejuvenation of metallic glasses by cryogenic thermal cycling

Miguel B. Costa et al.

Summary: Cryogenic thermal cycling (CTC) is an effective method to improve the room-temperature plasticity and toughness of metallic glasses. However, the effects of CTC are still not well understood, especially the unexpected behavior of stored energy in metallic glasses during CTC. This study applies CTC to bulk metallic glasses based on Pd, Pt, Ti, or Zr, and evaluates the effects on calorimetric and mechanical properties. The results show that the CTC-induced effects decay over time and the properties return to their original state. A model is proposed to explain the CTC-induced effects as the accumulation of anelastic strain. The implications for data analysis and future research on CTC effects are highlighted.

ACTA MATERIALIA (2023)

Article Multidisciplinary Sciences

Size-dependent vitrification in metallic glasses

Valerio Di Lisio et al.

Summary: The glass transition temperature of metallic glasses can be depressed by up to 40 K by reducing the sample size to below 10 & mu;m, allowing the attainment of glasses with low energy states. The properties of bulk metallic glasses are profoundly affected by reducing the sample size. By systematically reducing the length scale of gold and platinum-based metallic glasses, the vitrification behavior and atomic mobility were studied, revealing size-dependent vitrification kinetics in micrometer-sized glasses.

NATURE COMMUNICATIONS (2023)

Article Nanoscience & Nanotechnology

Strain-hardening under uniaxial tension in a rejuvenated bulk metallic glass

W. H. Zhou et al.

Summary: A rejuvenated Zr-based bulk metallic glass was tested in tension and exhibited strain-hardening behavior. The plastic strain at failure reached 0.9%, which is considered high for metallic glasses. Comparisons with other alloys showed that the hardening rate of the metallic glass decreases rapidly with increasing strain, limiting its tensile plastic strain to approximately 1%. Rejuvenation delayed early catastrophic failure and resulted in changes in the fracture surface morphology.

SCRIPTA MATERIALIA (2022)

Article Materials Science, Multidisciplinary

Review of Thermoplastic Drawing with Bulk Metallic Glasses

Shweta Jagdale et al.

Summary: This study summarizes recent advancements in the thermoplastic drawing of bulk metallic glasses. By combining drawing with templated embossing, arrays of high-aspect-ratio nanostructures can be fabricated, which was not possible with previous drawing methods limited to single fibers. Two-step drawing allows the production of challenging metallic glass structures such as vertically aligned nanowires, nanoscale tensile specimens, hollow microneedles, helical shafts, and micro-yarns, which are difficult to fabricate using other thermoplastic forming techniques. These geometries have the potential for new applications in sensors, optical absorption, transdermal drug delivery, and high-throughput characterization. The review focuses on the development of experimental setups, quantitative descriptions of the drawing process, and the versatility of the drawing methodology.

METALS (2022)

Article Nanoscience & Nanotechnology

Size-temperature equivalence in tensile deformation of metallic glass

Chandra Sekhar Meduri et al.

Summary: The study revealed that the fracture morphology of metallic glass specimens changes with size and temperature, possibly due to thermal effects. An empirical model based on shear band heating and velocity formulations can qualitatively describe the effects of size and temperature on fracture morphology. Plastic deformation in nanoscale samples is spatially localized and does not progress to the propagation stage due to lack of heat content.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2021)

Article Chemistry, Physical

Effect of time on the isothermal viscosity of metallic glass supercooled liquids

Akib Jabed et al.

Summary: The viscosity of metallic glasses remains constant during thermoplastic forming operations, but increases with annealing time in the supercooled liquid state. The rate of increase is largely independent of temperature and type of glass former. Higher viscosity increase is observed in the outer parts of samples experiencing higher shear rates during molding. The changes in effective viscosity of remaining amorphous phase are attributed to crystal nucleation and growth contributions.

JOURNAL OF ALLOYS AND COMPOUNDS (2021)

Article Materials Science, Multidisciplinary

The effect of thermal cycling on the fracture toughness of metallic glasses

Jittisa Ketkaew et al.

ACTA MATERIALIA (2020)

Article Materials Science, Multidisciplinary

Origin of serrated flow in bulk metallic glasses

Xie Xie et al.

JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS (2019)

Article Materials Science, Multidisciplinary

Effects of notches on the deformation behavior of submicron sized metallic glasses: Insights from in situ experiments

R. Lakshmi Narayan et al.

ACTA MATERIALIA (2018)

Article Multidisciplinary Sciences

Extreme rejuvenation and softening in a bulk metallic glass

J. Pan et al.

NATURE COMMUNICATIONS (2018)

Article Chemistry, Physical

Non-localized deformation in Cu-Zr multi-layer amorphous films under tension

C. Zhong et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2016)

Article Chemistry, Multidisciplinary

Brittle-to-Ductile Transition in Metallic Glass Nanowires

D. Sopu et al.

NANO LETTERS (2016)

Article Materials Science, Multidisciplinary

Sample size and preparation effects on the tensile ductility of Pd-based metallic glass nanowires

Jun Yi et al.

ACTA MATERIALIA (2015)

Article Chemistry, Multidisciplinary

Shear-Band Dynamics in Metallic Glasses

Robert Maass et al.

ADVANCED FUNCTIONAL MATERIALS (2015)

Article Multidisciplinary Sciences

Rejuvenation of metallic glasses by non-affine thermal strain

S. V. Ketov et al.

NATURE (2015)

Review Materials Science, Multidisciplinary

The fracture of bulk metallic glasses

B. A. Sun et al.

PROGRESS IN MATERIALS SCIENCE (2015)

Article Multidisciplinary Sciences

Work-Hardening Induced Tensile Ductility of Bulk Metallic Glasses via High-Pressure Torsion

Soo-Hyun Joo et al.

SCIENTIFIC REPORTS (2015)

Article Materials Science, Multidisciplinary

Effect of ion irradiation on tensile ductility, strength and fictive temperature in metallic glass nanowires

D. J. Magagnosc et al.

ACTA MATERIALIA (2014)

Article Chemistry, Multidisciplinary

Room Temperature Homogeneous Ductility of Micrometer-Sized Metallic Glass

Dominik Toennies et al.

ADVANCED MATERIALS (2014)

Article Chemistry, Multidisciplinary

Mechanisms of Failure in Nanoscale Metallic Glass

X. Wendy Gu et al.

NANO LETTERS (2014)

Review Materials Science, Multidisciplinary

Shear bands in metallic glasses

A. L. Greer et al.

MATERIALS SCIENCE & ENGINEERING R-REPORTS (2013)

Article Multidisciplinary Sciences

Approaching the ideal elastic limit of metallic glasses

Lin Tian et al.

NATURE COMMUNICATIONS (2012)

Article Materials Science, Multidisciplinary

Propagation dynamics of individual shear bands during inhomogeneous flow in a Zr-based bulk metallic glass

R. Maass et al.

ACTA MATERIALIA (2011)

Review Chemistry, Physical

Direct measurements of shear band propagation in metallic glasses - An overview

S. X. Song et al.

INTERMETALLICS (2011)

Article Materials Science, Multidisciplinary

Compression testing of metallic glass at small length scales: Effects on deformation mode and stability

Ashwini Bharathula et al.

ACTA MATERIALIA (2010)

Article Physics, Applied

Tensile fracture morphologies of bulk metallic glass

R. T. Qu et al.

JOURNAL OF APPLIED PHYSICS (2010)

Article Nanoscience & Nanotechnology

Ion irradiation enhances the mechanical performance of metallic glasses

R. Raghavan et al.

SCRIPTA MATERIALIA (2010)

Article Nanoscience & Nanotechnology

Ta-particulate reinforced Zr-based bulk metallic glass matrix composite with tensile plasticity

Z. Zhu et al.

SCRIPTA MATERIALIA (2010)

Article Materials Science, Multidisciplinary

Embrittlement of Zr-based bulk metallic glasses

G. Kumar et al.

ACTA MATERIALIA (2009)

Article Materials Science, Multidisciplinary

Size-dependent shear fracture and global tensile plasticity of metallic glasses

F. F. Wu et al.

ACTA MATERIALIA (2009)

Article Nanoscience & Nanotechnology

Micropillar compression studies on a bulk metallic glass in different structural states

A. Dubach et al.

SCRIPTA MATERIALIA (2009)

Article Materials Science, Multidisciplinary

Size-independent strength and deformation mode in compression of a Pd-based metallic glass

B. E. Schuster et al.

ACTA MATERIALIA (2008)

Article Physics, Applied

Effect of sample size on deformation in amorphous metals

C. A. Volkert et al.

JOURNAL OF APPLIED PHYSICS (2008)

Article Multidisciplinary Sciences

Designing metallic glass matrix composites with high toughness and tensile ductility

Douglas C. Hofmann et al.

NATURE (2008)

Article Materials Science, Multidisciplinary

Plastic flow and failure resistance of metallic glass: Insight from in situ compression of nanopillars

Z. W. Shan et al.

PHYSICAL REVIEW B (2008)

Article Materials Science, Multidisciplinary

Theory of shear banding in metallic glasses and molecular dynamics calculations

Futoshi Shimizu et al.

MATERIALS TRANSACTIONS (2007)

Article Chemistry, Physical

Tensile ductility and necking of metallic glass

H. Guo et al.

NATURE MATERIALS (2007)

Review Materials Science, Multidisciplinary

Overview No.144 - Mechanical behavior of amorphous alloys

Christopher A. Schuh et al.

ACTA MATERIALIA (2007)

Article Nanoscience & Nanotechnology

Plasticity and microstructure of Zr-Cu-Al bulk metallic glasses

G. Kumar et al.

SCRIPTA MATERIALIA (2007)

Article Physics, Multidisciplinary

Work-hardenable ductile bulk metallic glass

J Das et al.

PHYSICAL REVIEW LETTERS (2005)

Article Materials Science, Multidisciplinary

Intrinsic plasticity or brittleness of metallic glasses

JJ Lewandowski et al.

PHILOSOPHICAL MAGAZINE LETTERS (2005)

Article Materials Science, Multidisciplinary

Shear band spacing under bending of Zr-based metallic glass plates

RD Conner et al.

ACTA MATERIALIA (2004)

Article Materials Science, Multidisciplinary

Difference in compressive and tensile fracture mechanisms of Zr59CU20Al10Ni8Ti3 bulk metallic glass

ZF Zhang et al.

ACTA MATERIALIA (2003)

Article Materials Science, Multidisciplinary

Cold-rolled Zr50Cu30Ni10Al10 bulk amorphous alloys with tensile plastic elongation at room temperature

Y Yokoyama et al.

MATERIALS TRANSACTIONS (2002)