☆ 4.7 Article

Hydrodynamics of a cold circulating fluidized bed for methanol-to-olefins (MTO) process: experimental and computational investigation

SCIENTIFIC REPORTS (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Engineering, Chemical

Comparative analysis on gas-solid drag models in MFIX-DEM simulations of bubbling fluidized bed

Ruiyu Li et al.

Summary: MFIX-DEM simulations were used to study a bubbling fluidized bed (BFB), and the performance of nine drag models was assessed. The results showed that most drag models were consistent with experimental and DNS results. It is recommended to use drag models derived from DNS or CFD-DEM data for simulations.

CHINESE JOURNAL OF CHEMICAL ENGINEERING (2023)

添加到收藏夹

Article Energy & Fuels

Reactive simulation of gas-catalyst thermochemical properties in a pilot-plant catalytic MTO fluidized bed

Jin Liang et al.

Summary: A multiphase particle-in-cell model was used to simulate the reactive multiphase flow patterns and reaction behaviors inside a pilot-plant MTO fluidized reactor. The results show that the thermochemical properties of catalytic particles and gas phase thermal characteristics have high heat transfer coefficient in the crucial reaction zone and freeboard zone. Gas-solid hydrodynamics and gas concentrations exhibit non-uniform distribution. The reactant gas flow rate has a significant impact on product distributions and gas thermal properties. Increasing reaction pressure enhances heat transfer. The vertical dispersion coefficient of catalyst is two orders of magnitude larger than the horizontal ones.

FUEL (2023)

添加到收藏夹

Article Engineering, Chemical

Analysis of the overall pressure balance loop for a methanol-to-olefins dual fluidized bed reactor-regenerator

Bijan Hejazi et al.

Summary: The development of a comprehensive reactor model is crucial for the design and scale-up of the methanol-to-olefins process in a dual fluidized bed reactor. This model should combine suitable reaction kinetics with hydrodynamic models that accurately describe the gas-solid contact in fluidized bed reactors. In this study, we coupled our previously developed kinetic models of the MTO fluidized bed reactor and regenerator with overall mass, energy, and pressure balances to ensure smooth circulation of catalyst particles between the two fluidized beds. The integrated model was then used to determine the geometric dimensions of a demo-scale MTO DFB configuration and to obtain the mass distribution of catalyst particles throughout the entire system, including the connecting pipes.

PARTICUOLOGY (2023)

添加到收藏夹

Article Chemistry, Multidisciplinary

Computational fluid dynamics simulation of methanol to olefins in stage circulating fluidized bed riser: Effect of reactor stage parameters on product yields

Chaiwat Soanuch et al.

Summary: The study simulated conventional and stage fluidized bed reactors for methanol to olefins (MTO) conversion using computational fluid dynamics and validated the reaction rates. The parameters of the reactor stages were examined, showing that the circulating fluidized bed riser can affect olefin yield.

KOREAN JOURNAL OF CHEMICAL ENGINEERING (2021)

添加到收藏夹

Article Engineering, Chemical

An Assessment of Drag Models in Eulerian-Eulerian CFD Simulation of Gas-Solid Flow Hydrodynamics in Circulating Fluidized Bed Riser

Mukesh Upadhyay et al.

CHEMENGINEERING (2020)

添加到收藏夹

Article Engineering, Chemical

Borescopic particle image velocimetry in bubbling gas-solid fluidized beds

M. Banaei et al.

PARTICUOLOGY (2019)

添加到收藏夹

Article Engineering, Chemical

CFD simulations of a full-loop CFB reactor using coarse-grained Eulerian-Lagrangian dense discrete phase model: Effects of modeling parameters

Adnan Muhammad et al.

POWDER TECHNOLOGY (2019)

添加到收藏夹

Article Engineering, Environmental

On the hydrodynamics of a pseudo two-dimensional two-zone gas-solid fluidized bed

Ali Akbar Sarbanha et al.

CHEMICAL ENGINEERING JOURNAL (2018)

添加到收藏夹

Article Engineering, Chemical

Simulation of a large methanol-to-olefins fluidized bed reactor with consideration of coke distribution

Jingyuan Zhang et al.

CHEMICAL ENGINEERING SCIENCE (2018)

添加到收藏夹

Article Engineering, Chemical

Experimental study of full field riser hydrodynamics by PIV/DIA coupling

A. E. Carlos Varas et al.

POWDER TECHNOLOGY (2017)

添加到收藏夹

Article Engineering, Chemical

Experimental study on the pressure wave attenuation across gas-solid fluidized bed by single bubble injection

Kamal Nosrati et al.

POWDER TECHNOLOGY (2017)

添加到收藏夹

Article Engineering, Chemical

Bubble-induced particle mixing in a 2-D gas-solid fluidized bed with different bed aspect ratios: A CFD-DPM study

Zahra Amiri et al.

POWDER TECHNOLOGY (2017)

添加到收藏夹

Article Engineering, Chemical

Particles Mixing Induced by Bubbles in a Gas-Solid Fluidized Bed

Zahra Amiri et al.

AICHE JOURNAL (2016)

添加到收藏夹

Article Engineering, Chemical

Speeding up CFD simulation of fluidized bed reactor for MTO by coupling CRE model

Bona Lu et al.

CHEMICAL ENGINEERING SCIENCE (2016)

添加到收藏夹

Article Engineering, Multidisciplinary

Hydrodynamics and particle mixing/segregation measurements in an industrial gas phase olefin polymerization reactor using image processing technique and CFD-PBM model

Roya Aramesh et al.

MEASUREMENT (2016)

添加到收藏夹

Article Engineering, Chemical

CPFD simulation of solids residence time and back-mixing in CFB risers

Xiaogang Shi et al.

POWDER TECHNOLOGY (2015)

添加到收藏夹

Article Engineering, Chemical

Eulerian-Eulerian simulation of dense solid-gas cylindrical fluidized beds: Impact of wall boundary condition and drag model on fluidization

A. Bakshi et al.

POWDER TECHNOLOGY (2015)

添加到收藏夹

Article Chemistry, Physical

Methanol to Olefins (MTO): From Fundamentals to Commercialization

Peng Tian et al.

ACS CATALYSIS (2015)

添加到收藏夹

Article Engineering, Chemical

Bubble Splitting in a Pseudo-2D Gas-Solid Fluidized Bed for Geldart B-Type Particles

Salman Movahedirad et al.

CHEMICAL ENGINEERING & TECHNOLOGY (2014)

添加到收藏夹

Article Engineering, Chemical

Filtered two-fluid models of fluidized gas-particle flows: New constitutive relations

Christian C. Milioli et al.

AICHE JOURNAL (2013)

添加到收藏夹

Article Engineering, Chemical

CFD modelling of the hydrodynamics and kinetic reactions in a fluidised-bed MTO reactor

Jian Chang et al.

CHEMICAL ENGINEERING RESEARCH & DESIGN (2013)

添加到收藏夹

Article Engineering, Chemical

3D Numerical Simulation of a Large Scale MTO Fluidized Bed Reactor

Yinfeng Zhao et al.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2013)

添加到收藏夹

Article Engineering, Chemical

Bubble Size Distribution in Two-Dimensional Gas-Solid Fluidized Beds

S. Movahedirad et al.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2012)

添加到收藏夹

Article Engineering, Chemical

The solids flow in the riser of a Circulating Fluidised Bed (CFB) viewed by Positron Emission Particle Tracking (PEPT)

M. Van de Velden et al.

POWDER TECHNOLOGY (2008)

添加到收藏夹

Article Mechanics

EXPERIMENTAL RESEARCH OF FLOW STRUCTURE IN A GAS-SOLID CIRCULATING FLUIDIZED BED RISER BY PIV

Shi Hui-xian

JOURNAL OF HYDRODYNAMICS (2007)

添加到收藏夹

Article Engineering, Chemical

Bubble computation, granular temperatures, and reynolds stresses

Jonghwun Jung et al.

CHEMICAL ENGINEERING COMMUNICATIONS (2006)

添加到收藏夹

Article Engineering, Environmental

The staging in fluidised bed reactors: from CSTR to plug-flow

I Miracca et al.

CHEMICAL ENGINEERING JOURNAL (2001)

添加到收藏夹

Article Engineering, Chemical

A calibration procedure to obtain solid concentrations from digital images of bulk powders

G Grasa et al.

POWDER TECHNOLOGY (2001)

添加到收藏夹

Article Engineering, Environmental

X-ray computer tomography - potential and limitation for the measurement of local solids distribution in circulating fluidized beds

T Grassler et al.

CHEMICAL ENGINEERING JOURNAL (2000)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.