期刊
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING
卷 177, 期 -, 页码 -出版社
ELSEVIER SCI LTD
DOI: 10.1016/j.compositesa.2023.107922
关键词
A. Particle-reinforcement; B. Cure behaviour; B. Thermal properties; E. Prepreg processing
Faster heating rates and higher process temperatures can reduce the total process time while achieving the same degree-of-cure. Thermal analysis shows that thermoplastic interleaf particles melt at the recommended curing temperature. A short dwell at a lower temperature can prevent the mixing of thermoplastic particles and thermoset pre-polymer.
Faster heating rates of 10 degrees C/min and higher process temperatures of 210 degrees C were applied to the commercial M21 resin system. The total process time was reduced by two-thirds while achieving the same degree-of-cure in the epoxy. Thermal analysis and hot-stage microscopy showed that the thermoplastic interleaf particles melt at around 15 degrees C above the manufacturer's recommended 180 degrees C curing temperature. A short dwell at 180 degrees C was found to prevent the thermoplastic particle from mixing with the thermoset pre-polymer before ramping to the accelerated curing temperature of 210 degrees C. Such interaction was found to decrease the glass transition temperature by 13-45 %, but increase the mode I delamination resistance by 70-105 %, respectively. The results demonstrate that accelerated curing of interleaf systems can shorten cycle time and produce a range of physical and mechanical properties from a single base material, opening the design space to new and optimised composite structures.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据