Effect of Lead Addition and Milling on Densification and Mechanical Properties of 6061 Aluminium Alloys

In the present work, one batch of prealloyed 6061Al powder was mixed with different lead compositions (5, 10, 15 vol.%) and another set with same composition was ball-milled for 5 h at 300 rpm. Microstructural features such as lattice constant, crystallite size, particle size and morphology were studied using XRD, particle size analyzer and SEM. Both the as-mixed as well as ball-milled powders were compacted at 300 MPa and sintered under N-2 atmosphere for 1 h in tube furnace at 590 degrees C. The ball milling of 6061Al alloy powder improved sinter density and densification while lead addition showed negligible influence on these parameters. The microstructure of as-mixed 6061Al-Pb alloys exhibited equiaxial morphology whereas ball-milling resulted in elongated grains with uniform lead distribution. Quasi-static compressive mechanical behavior was investigated for 6061Al-Pb alloys at 1 x 10(-3) s(-1) strain rate. Results indicated that ultimate compressive and yield strength were sensitive to milling and lead volume fraction.