☆ 4.7 Article

Ignition limit of EPS foam by a hot particle under cross wind

CASE STUDIES IN THERMAL ENGINEERING (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Thermodynamics

Numerical investigation of air curtain jet effect upon the compartment-facade fire safety protection based on temperature evolution and thermal impact

Huasheng Xu et al.

Summary: This paper investigates the influence of the air curtain effect on the safety protection of compartment-facade fire through temperature evolution and thermal impact analysis. A compartment model and various fire scenarios were used to study the vertical temperature and heat flux profiles of the facade under different air curtain jet velocities. The results showed that increasing the jet velocity of the air curtain resulted in a significant reduction in vertical temperature and heat flux, indicating the effectiveness of the air curtain in blocking heat and smoke. The study also found that the impact of the air curtain varied with the height of the opening, with a more severe blockage observed at lower opening heights.

THERMAL SCIENCE AND ENGINEERING PROGRESS (2023)

添加到收藏夹

Article Thermodynamics

Study on the mechanism of molten aluminum droplets igniting EPS foam

Wenjie Yang et al.

Summary: This study investigated the mechanism of molten aluminum droplets igniting EPS foam and found that the critical ignition temperature decreases as the droplet diameter increases. Compared to solid particles, molten aluminum droplets have lower critical temperatures for ignition. The energy per unit contact area was identified as a critical parameter determining ignition occurrence.

COMBUSTION AND FLAME (2022)

添加到收藏夹

Article Engineering, Civil

Flammability trends for a comprehensive array of cladding materials

Martyn S. McLaggan et al.

Summary: The research in this study focuses on the flammability of materials in modern cladding fires, and reveals new findings and trends through bench-scale experiments. It is suggested that the organic content is not a good indicator of fire performance, providing engineers with insights when selecting remediation solutions for buildings.

FIRE SAFETY JOURNAL (2021)

添加到收藏夹

Article Engineering, Multidisciplinary

A Critical Appraisal of the UK's Regulatory Regime for Combustible Facades

Judith Schulz et al.

Summary: This study critically analyzes the BS 8414 test, the BR 135 criteria, and the government tests on Grenfell Tower-type facades, highlighting the uncertainties and lack of adequate consideration in key aspects such as heat flux, fire load, and ventilation. The findings question the fire safety of building facade systems tested under these standards and call for more stringent measures to ensure the safety of occupants.

FIRE TECHNOLOGY (2021)

添加到收藏夹

Review Engineering, Civil

A review of near-limit opposed fire spread

Xinyan Huang et al.

Summary: Creeping fire spread under opposed airflow is a classic fundamental fire research problem involving heat transfer, fluid dynamics, and chemical kinetics, dependent on environmental factors. Persistent research over the last 50 years has established a solid framework for different fire-spread processes, but new fire phenomena continue to challenge our current understanding.

FIRE SAFETY JOURNAL (2021)

添加到收藏夹

Article Thermodynamics

Ignition of pine needle fuel bed by the coupled effects of a hot metal particle and thermal radiation

Wei Fang et al.

Summary: This study investigates the ignition behavior of pine needle fuel bed under the coupled action of a hot particle and thermal radiation for the first time. The experimental results show that the ignition risk under the coupled condition is much higher than that of individual factors. Ignition probability and delay time are influenced by particle temperature and radiation heat flux under different conditions.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2021)

添加到收藏夹

Article Thermodynamics

Downward burning of PMMA cylinders: The effect of pressure and oxygen

Maria Thomsen et al.

Summary: This study aims to investigate the effects of ambient pressure and oxygen concentration on the burning behavior of PMMA, showing that surface regression rate and mass burning rate decrease with decreasing ambient pressure and increase with decreasing oxygen concentration during downward opposed flame spread. A simplified model based on mixed heat convection coefficient and B number is used to estimate the surface regression rate, with model predictions effectively capturing the impact of ambient pressure and oxygen concentration, providing guidance for fire safety testing and design in different ambient conditions.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2021)

添加到收藏夹

Article Thermodynamics

Ignition of EPS foam by a hot moving hollow particle: Threshold, auto-ignition, and fire point

Supan Wang et al.

Summary: The study found that the minimum ignition temperature of hollow particles is close to solid particles, and the temperature and size of the particle are better measures of fire hazard assessment. As the void ratio increases, the minimum particle temperature for ignition first slightly decreases, but for extremely hollow particles, a much higher particle temperature is required for ignition.

COMBUSTION AND FLAME (2021)

添加到收藏夹

Article Engineering, Civil

Small-scale single burning item test for the study of the fire behavior of building materials

Alexandre Gossiaux et al.

Summary: A small-scale single burning item test has been developed for quicker and more cost-effective development studies of high-performance building materials. The test allows for evaluation and differentiation of different foam materials in terms of HRR, flame spread, FIGRA, and SMOGRA index. It provides a better understanding of fire behavior and enables additional discrimination of material performance compared to the mass loss cone test.

FIRE SAFETY JOURNAL (2021)

添加到收藏夹

Article Thermodynamics

Limiting condition for auto-ignition of finite thick PMMA in forced convective airflow

Junhui Gong et al.

Summary: The experimental study on the auto-ignition of finite thick PMMA samples subjected to parallel forced convective airflow revealed three controlling regimes based on different mechanisms. It was found that critical temperature increases with sample thickness and airflow velocity, but remains relatively unchanged with varying heat fluxes. Surface temperature measurements were significantly affected in the gas-dominant regime due to the presence of large bubbles, leading to discrepancies with numerical predictions.

INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2021)

添加到收藏夹

Article Thermodynamics

Experimental study of flame spread over thermally-thin inclined fuel surface and controlling heat transfer mechanism under concurrent wind

Yajun Huang et al.

Summary: This study investigates the impact of fuel inclination angle and horizontal ambient airflow on flame spread behavior through wind tunnel experiments, developing a predictive formula for flame spread rate and deepening the understanding of the interaction between these two factors.

INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Reconstruction of Grenfell Tower fire. Part 1: Lessons from observations and determination of work hypotheses

Eric Guillaume et al.

FIRE AND MATERIALS (2020)

添加到收藏夹

Review Thermodynamics

Role of firebrand combustion in large outdoor fire spread

Samuel L. Manzello et al.

PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2020)

添加到收藏夹

Article Engineering, Multidisciplinary

Temperature and Motion Tracking of Metal Spark Sprays

Yudong Liu et al.

FIRE TECHNOLOGY (2019)

添加到收藏夹

Article Engineering, Environmental

Fire behaviour of modern facade materials - Understanding the Grenfell Tower fire

Sean T. McKenna et al.

JOURNAL OF HAZARDOUS MATERIALS (2019)

添加到收藏夹

Review Engineering, Mechanical

Review of the Transition From Smouldering to Flaming Combustion in Wildfires

Muhammad A. Santoso et al.

FRONTIERS IN MECHANICAL ENGINEERING-SWITZERLAND (2019)

添加到收藏夹

Article Engineering, Multidisciplinary

Spot Fire Ignition of Natural Fuels by Hot Aluminum Particles

James L. Urban et al.

FIRE TECHNOLOGY (2018)

添加到收藏夹

Article Engineering, Multidisciplinary

Review of Pathways for Building Fire Spread in the Wildland Urban Interface Part I: Exposure Conditions

Sara E. Caton et al.

FIRE TECHNOLOGY (2017)

添加到收藏夹

Article Engineering, Civil

Wildland fire spot ignition by sparks and firebrands

A. Carlos Fernandez-Pello

FIRE SAFETY JOURNAL (2017)

添加到收藏夹

Article Forestry

Interaction between flaming and smouldering in hot-particle ignition of forest fuels and effects of moisture and wind

Supan Wang et al.

INTERNATIONAL JOURNAL OF WILDLAND FIRE (2017)

添加到收藏夹

Article Thermodynamics

Smoldering spot ignition of natural fuels by a hot metal particle

James L. Urban et al.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2017)

添加到收藏夹

Article Engineering, Multidisciplinary

Ignition of Wood Fencing Assemblies Exposed to Continuous Wind-Driven Firebrand Showers

Sayaka Suzuki et al.

FIRE TECHNOLOGY (2016)

添加到收藏夹

Article Thermodynamics

Ignition of low-density expandable polystyrene foam by a hot particle

Supan Wang et al.

COMBUSTION AND FLAME (2015)

添加到收藏夹

Article Forestry

The likelihood of ignition of dry-eucalypt forest litter by firebrands

P. F. M. Ellis

INTERNATIONAL JOURNAL OF WILDLAND FIRE (2015)

添加到收藏夹

Article Engineering, Environmental

Ignition of expandable polystyrene foam by a hot particle: An experimental and numerical study

Supan Wang et al.

JOURNAL OF HAZARDOUS MATERIALS (2015)

添加到收藏夹

Article Thermodynamics

Effects of altitude and sample orientation on heat transfer for flame spread over polystyrene foams

Xinjie Huang et al.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2015)

添加到收藏夹

Article Thermodynamics

Correlation analysis of sample thickness, heat flux, and cone calorimetry test data of polystyrene foam

Weiguang An et al.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2015)

添加到收藏夹

Article Engineering, Multidisciplinary

New Correlation Between Ignition Time and Moisture Content for Pine Needles Attacked by Firebrands

Panpan Yin et al.

FIRE TECHNOLOGY (2014)

添加到收藏夹

Article Engineering, Multidisciplinary

Ignition of Mediterranean Fuel Beds by Several Types of Firebrands

D. X. Viegas et al.

FIRE TECHNOLOGY (2014)

添加到收藏夹

Article Mechanics

Safety distance for preventing hot particle ignition of building insulation materials

Jiayun Song et al.

THEORETICAL AND APPLIED MECHANICS LETTERS (2014)

添加到收藏夹

Review Mechanics

A review on research of fire dynamics in high-rise buildings

Jinhua Sun et al.

THEORETICAL AND APPLIED MECHANICS LETTERS (2013)

添加到收藏夹

Article Engineering, Multidisciplinary

Ignition of Combustible Fuel Beds by Hot Particles: An Experimental and Theoretical Study

Rory M. Hadden et al.

FIRE TECHNOLOGY (2011)

添加到收藏夹

Article Forestry

Fuelbed ignition potential and bark morphology explain the notoriety of the eucalypt messmate 'stringybark' for intense spotting

P. F. M. Ellis

INTERNATIONAL JOURNAL OF WILDLAND FIRE (2011)

添加到收藏夹

Article Thermodynamics

The combined effect of pressure and oxygen concentration on piloted ignition of a solid combustible

Sara McAllister et al.

COMBUSTION AND FLAME (2010)

添加到收藏夹

Article Engineering, Civil

Quantifying the vulnerabilities of ceramic tile roofing assemblies to ignition during a firebrand attack

Samuel L. Manzello et al.

FIRE SAFETY JOURNAL (2010)

添加到收藏夹

Article Thermodynamics

A model for the oxidative pyrolysis of wood

Chris Lautenberger et al.

COMBUSTION AND FLAME (2009)

添加到收藏夹

Article Engineering, Civil

Investigation on the ability of glowing firebrands deposited within crevices to ignite common building materials

Samuel L. Manzello et al.

FIRE SAFETY JOURNAL (2009)

添加到收藏夹

Article Forestry

Spot fires: fuel bed flammability and capability of firebrands to ignite fuel beds

Anne Ganteaume et al.

INTERNATIONAL JOURNAL OF WILDLAND FIRE (2009)

添加到收藏夹

Article Materials Science, Multidisciplinary

The piloted transition to flaming in smoldering fire retarded and non-fire retarded polyurethane foam

Olivier M. Putzeys et al.

FIRE AND MATERIALS (2008)

添加到收藏夹

Article Engineering, Civil

Experimental investigation of firebrands: Generation and ignition of fuel beds

Samuel L. Manzello et al.

FIRE SAFETY JOURNAL (2008)

添加到收藏夹

Article Thermodynamics

Mass flux of combustible solids at piloted ignition

David Rich et al.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2007)

添加到收藏夹

Article Construction & Building Technology

State of the art in thermal insulation materials and aims for future developments

AM Papadopoulos

ENERGY AND BUILDINGS (2005)

添加到收藏夹

Article Thermodynamics

Transition from smoldering to flaming combustion of horizontally oriented flexible polyurethane foam with natural convection

CYH Chao et al.

COMBUSTION AND FLAME (2001)

添加到收藏夹

Article Polymer Science

Characterisation of smoke in expanded polystyrene combustion

M Rossi et al.

POLYMER DEGRADATION AND STABILITY (2001)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.