4.7 Article

Two-stage growth of Cu3BiS3 thin films: Influence of the Cu/Bi ratio

相关参考文献

注意:仅列出部分参考文献,下载原文获取全部文献信息。
Article Materials Science, Ceramics

Evolution of large-grained CuSbS2 thin films by rapid sulfurization of evaporated Cu-Sb precursor stacks for photovoltaics application

U. Chalapathi et al.

Summary: Ternary chalcostibite (CuSbS2) thin-film solar cell material was synthesized by sulfurizing Cu/Sb/Cu precursor stacks at 450 degrees C for 1-10 min. The films exhibited direct band gap of 1.42 eV and hole mobility of 0.44-0.56 cm(2) V-1 s(-1). Solar cells fabricated using the CuSbS2 films sulfurized for 5 min achieved a maximum power conversion efficiency of 2.5%.

CERAMICS INTERNATIONAL (2023)

Article Chemistry, Physical

Unveiling the Selenization Reaction Mechanisms in Ambient Air-Processed Highly Efficient Kesterite Solar Cells

Zixuan Yu et al.

Summary: By using a combination of strategies involving SnS and Sn or SnSe or SnSe2, the excessive S and related defects in the selenization process are solved, and the pathway for the formation of CZTSSe is clarified. Adding SnSe2 effectively promotes grain fusion and improves crystalline quality, optimizing the band bending at grain boundaries and suppressing interface recombination. As a result, the open-circuit voltage, fill factor, and short-circuit current density are increased, leading to a state-of-the-art kesterite device with 12.89% efficiency. The unveiled reaction mechanisms have guiding significance for further improving selenization atmosphere and efficiency of CZTSSe solar cells.

ADVANCED ENERGY MATERIALS (2023)

Article Engineering, Electrical & Electronic

Co-electrodeposition of Cu3BiS3 thin films in weakly alkaline aqueous solutions for photovoltaic application

Yanlin Pan et al.

Summary: This study successfully fabricated high crystalline Cu3BiS3 thin films with desirable stoichiometric ratios using a novel co-electrodeposition method, achieving bandgap tuning and investigating defects related to radiation recombination in the film.

JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS (2022)

Article Energy & Fuels

Solar cell efficiency tables (Version 60)

Martin A. Green et al.

Summary: This article presents consolidated tables showing the highest independently confirmed efficiencies for solar cells and modules. The guidelines for including results in these tables are outlined, and new entries since January 2022 are reviewed. An appendix describing temporary electrical contacting methods and terminology for large-area solar cells is also included.

PROGRESS IN PHOTOVOLTAICS (2022)

Article Chemistry, Multidisciplinary

Over 10% Efficient Cu2CdSnS4 Solar Cells Fabricated from Optimized Sulfurization

Ping Fan et al.

Summary: Currently, Kesterite-based thin-film solar cells suffer from band-tailed states, leading to low open-circuit voltage and hindering device performance improvement. In this study, stannite-based Cu2CdSnS4 thin films were successfully obtained with good quality and single-phase composition by optimizing sulfurization, Cu/Cd+Sn ratios, and temperatures. Substituting Cd for Zn effectively reduced Cu-Cd-related defects and defect clusters, resulting in reduced band-tailed states compared to kesterite-based devices. The Cu2CdSnS4 thin-film solar cell prepared under optimized conditions exhibited high efficiency and outperformed other stannite-based solar cells reported to date.

ADVANCED FUNCTIONAL MATERIALS (2022)

Article Chemistry, Physical

Solution Processing Cu3BiS3 Absorber Layers with a Thiol-Amine Solvent Mixture

Kristopher M. Koskela et al.

Summary: The study demonstrates the use of thiol-amine solvent mixtures to dissolve CuO and Bi2S3 precursors and produce Cu3BiS3 thin films with high quality, high purity, and a direct band gap of 1.47 eV. These thin films show promise as a solution-processable solar absorber with strong optoelectronic properties.

ACS APPLIED ENERGY MATERIALS (2021)

Article Energy & Fuels

Impact of Ag doping on Cu3BiS3 solar cell performance

Wenning Zhao et al.

Summary: Cation doping of Cu3BiS3 can enhance its structural, optical, electrical, and photovoltaic properties, leading to improved solar cell performance.

SOLAR ENERGY (2021)

Article Multidisciplinary Sciences

Wittichenite semiconductor of Cu3BiS3 films for efficient hydrogen evolution from solar driven photoelectrochemical water splitting

Dingwang Huang et al.

Summary: A Cu3BiS3-based photocathode with high onset potential and long-term stability in neutral water solutions has been developed, achieving a photoelectrochemical current density of 7mA/cm(2) and an unbiased solar-to-hydrogen conversion efficiency of over 2% when combined with a BiVO4 photoanode. The tandem device of Cu3BiS3-BiVO4 also demonstrates high stability over 20 hours, and a large module has been fabricated with a long-term stability of 60 hours for overall solar water splitting.

NATURE COMMUNICATIONS (2021)

Article Chemistry, Physical

p-type Cu3BiS3 thin films for solar cell absorber layer via one stage thermal evaporation

Arshad Hussain et al.

APPLIED SURFACE SCIENCE (2020)

Article Nanoscience & Nanotechnology

Band Alignments, Band Gap, Core Levels, and Valence Band States in Cu3BiS3 for Photovoltaics

Thomas J. Whittles et al.

ACS APPLIED MATERIALS & INTERFACES (2019)

Article Chemistry, Physical

Antimony induced crystal growth for large-grained Cu2SnS3 thin films for photovoltaics

U. Chalapathi et al.

JOURNAL OF POWER SOURCES (2019)

Article Engineering, Electrical & Electronic

Study of copper bismuth sulfide thin films for the photovoltaic application

Yanbo Yang et al.

JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS (2019)

Article Nanoscience & Nanotechnology

Post-Annealing Effects on Cu3BiS3 Thin Films Grown by Chemical Bath Deposition Technique

Dongchan Lee et al.

NANOSCIENCE AND NANOTECHNOLOGY LETTERS (2018)

Article Engineering, Electrical & Electronic

Development of Cu3BiS3 thin films by chemical bath deposition route

S. G. Deshmukh et al.

JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS (2017)

Article Nanoscience & Nanotechnology

Efficient mixed-solvent exfoliation of few-quintuple layer Bi2S3 and its photoelectric response

Yaohui Guo et al.

NANOTECHNOLOGY (2017)

Article Materials Science, Coatings & Films

Synthesis and characterization of thermally evaporated copper bismuth sulphide thin films

Arshad Hussain et al.

SURFACE & COATINGS TECHNOLOGY (2017)

Article Chemistry, Physical

AgSbS2 modified ZnO nanotube arrays for photoelectrochemical water splitting

Jianhua Han et al.

APPLIED CATALYSIS B-ENVIRONMENTAL (2015)

Article Materials Science, Multidisciplinary

Spray pyrolysis deposition of Cu3BiS3 thin films

Sheng Liu et al.

THIN SOLID FILMS (2015)

Article Chemistry, Physical

Device Characteristics of CZTSSe Thin-Film Solar Cells with 12.6% Efficiency

Wei Wang et al.

ADVANCED ENERGY MATERIALS (2014)

Article Physics, Applied

Cu3BiS3 as a potential photovoltaic absorber with high optical efficiency

Mukesh Kumar et al.

APPLIED PHYSICS LETTERS (2013)

Article Materials Science, Multidisciplinary

Formation of Cu3BiS3 thin films via sulfurization of Bi-Cu metal precursors

D. Colombara et al.

THIN SOLID FILMS (2012)

Article Physics, Applied

A study of ternary Cu2SnS3 and Cu3SnS4 thin films prepared by sulfurizing stacked metal precursors

P. A. Fernandes et al.

JOURNAL OF PHYSICS D-APPLIED PHYSICS (2010)

Article Chemistry, Physical

A Raman spectroelectrochemical investigation of chemical bath deposited CuxS thin films and their modification

Carolyn G. Munce et al.

COLLOIDS AND SURFACES A-PHYSICOCHEMICAL AND ENGINEERING ASPECTS (2007)

Article Engineering, Electrical & Electronic

Semiconducting Cu3BiS3 thin films formed by the solid-state reaction of CuS and bismuth thin films

V Estrella et al.

SEMICONDUCTOR SCIENCE AND TECHNOLOGY (2003)