☆ 4.7 Article

Localized corrosion evaluation of newly developed stainless-steel alloys in chloride medium through dynamic and localized micro electrochemical techniques

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Materials Science, Multidisciplinary

Heat Treatment, Microstructure and Corrosion Relationship on 316L SS Produced by AM

Gokhan Ozer

Summary: In this study, the effects of heat treatment on the microstructure, phase changes, hardness, porosity, and corrosion of 316L stainless steel produced by Additive Manufacturing were examined. It was found that the as-built microstructure deteriorated and the hardness decreased with increasing heat treatment temperature, while the corrosion resistance improved. The best corrosion resistance was achieved with heat treatment at 1150 degrees C for 2 hours.

MATERIALS SCIENCE AND TECHNOLOGY (2023)

添加到收藏夹

Article Materials Science, Multidisciplinary

Metastable pitting corrosion behavior and characteristics of passive film of laser powder bed fusion produced Ti-6Al-4V in NaCl solutions with different concentrations

Yu-Wei Cui et al.

Summary: This study investigated the metastable pitting corrosion mechanism of laser powder bed fusion (LPBF) produced Ti-6Al-4V. The passive films of samples were produced by potentiostatic polarization in NaCl solutions with different concentrations, and electrochemical measurements were employed to understand the influence of Cl- on the characteristics of passive films. The frequency of pitting nucleation and the pit dimension increase with increased Cl- concentration. The attack of Cl- promotes the dissolution of passive films, resulting in the formation of pitting corrosion due to the condensation of voids caused by the ingress of Cl-.

CORROSION SCIENCE (2023)

添加到收藏夹

Article Materials Science, Multidisciplinary

Localized corrosion of 304 stainless steel triggered by embedded MnS

Dan Li et al.

Summary: The present study investigated the localized corrosion of 304 stainless steel triggered by MnS in a 3.5 wt% NaCl solution using various analytical techniques. The dissolution of MnS was found to start from the boundary areas and release elemental sulfur. The reoccurrence and disappearance of elemental sulfur during MnS dissolution suggested continuous consumption and conversion. Copper-containing compounds were observed deposited on residual MnS in the corrosion pit, while a thin Cr2O3 film covered the pit and thickened over time. Based on the evidence obtained, a more comprehensive MnS-induced localized corrosion mechanism was proposed.

CORROSION SCIENCE (2023)

添加到收藏夹

Article Materials Science, Multidisciplinary

Insight into microstructure, microhardness and corrosion performance of 2205 duplex stainless steel: Effect of plastic pre-strain

Kuiling Shen et al.

Summary: This study investigated the microstructure evolution of 2205 duplex stainless steel (DSS) and its impact on microhardness and corrosion performance. The results indicated that the microhardness of DSS increased due to dislocation multiplication, strain-induced martensite generation, and grain refinement from pre-strain. The improved corrosion resistance at higher pre-strain levels (14% and 21%) was attributed to smaller surface energy difference, more strain-induced martensite, and more low-angle grain boundaries. The changed pitting nucleation sites with increasing pre-strain were strongly influenced by increased dislocation density and strain-induced martensite.

CORROSION SCIENCE (2023)

添加到收藏夹

Article Chemistry, Physical

Effect of HAc on the Metastable Pitting Corrosion of 304 SS in NaCl Solution

Hanlu Zhang et al.

Summary: The study investigated the effects of acetic acid and its concentration on the metastable pitting corrosion and uniform corrosion of 304 stainless steel in sodium chloride solution. The results showed that with an increase in HAc concentration, the corrosion rate decreased, the number of metastable pits decreased, and HAc promoted the growth rate of metastable pits and the transition to stable pits.

MATERIALS (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Effect of annealing treatment on microstructure, mechanical property and anti-corrosion behavior of X2CrNi12 ferritic stainless steel

Rui Li et al.

Summary: The effect of annealing temperature on the microstructure, mechanical properties, and anti-corrosion behavior of X2CrNi12 ferritic stainless steel was investigated. Increasing annealing temperature prevents the precipitation of (Fe, Cr)(23)C-6, leading to improved mechanical properties but decreased elongation. The steel annealed at 770 degrees C exhibits the best corrosion resistance.

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2022)

添加到收藏夹

Review Materials Science, Multidisciplinary

A review on the role of surface nanocrystallization in corrosion of stainless steel

Khashayar Morshed-Behbahani et al.

Summary: This paper reviews the corrosion behavior of surface nanocrystallized stainless steels, examines the impact of surface nanocrystallization techniques on stainless steels, and discusses the related corrosion mechanisms.

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Improving corrosion resistance of selective laser melted 316L stainless steel through ultrasonic severe surface rolling

Jiapeng Sun et al.

Summary: The study investigates the use of ultrasonic severe surface rolling (USSR) to enhance the corrosion resistance of SLM 316L stainless steel, and finds that the USSR processed samples exhibit significant improvement in corrosion resistance, attributed to the unique gradient structure and chemically homogeneous and high-quality surface.

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Corrosion and passivation behavior of laser powder bed fusion produced Ti-6Al-4V in static/dynamic NaCl solutions with different concentrations

P. Qin et al.

Summary: The study found that Ti-6Al-4V forms oxide films in NaCl solutions, with film thickness increasing with Cl- concentration, and more TiO2 content in dynamic conditions. The corrosion behavior and film growth mechanisms were discussed based on electrochemical and surface characteristic measurements.

CORROSION SCIENCE (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Corrosion resistant and conductive TiN/TiAlN multilayer coating on 316L SS: a promising metallic bipolar plate for proton exchange membrane fuel cell

S. Pugal Mani et al.

Summary: The single layers of TiN, TiAlN and TiN/TiAlN multilayer coatings were deposited on 316L SS bipolar plate by physical vapor deposition technique. Studies showed that TiN/TiAlN coating exhibited better water management and higher electrochemical impedance behavior in the fuel cell, even meeting the U.S. Department of Energy's 2020 target, and significantly reducing the metal ions dissolution.

JOURNAL OF MATERIALS SCIENCE (2021)

添加到收藏夹

Article Chemistry, Applied

Wear and corrosion resistance performance of UHMWPE/GNPs nanocomposite coatings on AA2028 Al alloys

Ismaila Kayode Aliyu et al.

Summary: The research aims to provide better wear and corrosion protection for automotive components using nanocomposite coatings, in order to reduce automotive emissions.

PROGRESS IN ORGANIC COATINGS (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

The Effect of Powder Composition on the Microstructure and Corrosion Resistance of Laser Cladding 60NiTi Alloy Coatings on SS 316L

Zexu Du et al.

Summary: The 55NiTi-5Ni and 60Ni-40Ti coatings prepared by alcohol ball milling on a 316L stainless steel substrate exhibit different microstructures and hardness, as well as varying corrosion resistance performance.

METALS (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Mechanical, in-vitro corrosion, and tribological characteristics of TiN coating produced by cathodic arc physical vapor deposition on Ti20Nb13Zr alloy for biomedical applications

M. A. Hussein et al.

THIN SOLID FILMS (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Natural passivation behavior and its influence on chloride-induced corrosion resistance of stainless steel in simulated concrete pore solution

Xuwen Yuan et al.

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Influence of Thermal Treatment on the Microstructure, Mechanical Properties, and Corrosion Resistance of Newly Developed Ti20Nb13Zr Biomedical Alloy in a Simulated Body Environment

M. A. Hussein et al.

JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE (2019)

添加到收藏夹

Article Materials Science, Multidisciplinary

Influence of Sn and Mo on corrosion behavior of ferrite-pearlite steel in the simulated bottom plate environment of cargo oil tank

Xuehui Hao et al.

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2019)

添加到收藏夹

Article Materials Science, Multidisciplinary

Corrosion and tribocorrosion behaviour of beta-type Ti-Nb and Ti-Mo surfaces designed by diffusion treatments for biomedical applications

J. Urena et al.

CORROSION SCIENCE (2018)

添加到收藏夹

Review Chemistry, Physical

Electrochemical frequency modulation (EFM) technique: Theory and recent practical applications in corrosion research

I. B. Obot et al.

JOURNAL OF MOLECULAR LIQUIDS (2018)

添加到收藏夹

Article Materials Science, Multidisciplinary

Influence of Laser Nitriding on the Surface and Corrosion Properties of Ti-20Nb-13Zr Alloy in Artificial Saliva for Dental Applications

Mohamed A. Hussein et al.

JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE (2018)

添加到收藏夹

Article Chemistry, Applied

Sodium alginate: A promising biopolymer for corrosion protection of API X60 high strength carbon steel in saline medium

I. B. Obot et al.

CARBOHYDRATE POLYMERS (2017)

添加到收藏夹

Article Materials Science, Multidisciplinary

Growth kinetics of metastable pits on sputtered nanocrystalline stainless steel

Tianshu Li et al.

CORROSION SCIENCE (2017)

添加到收藏夹

Article Materials Science, Coatings & Films

Effect of functionalization of carbon nanotubes on mechanical and electrochemical behavior of polyaniline nanocomposite coatings

A. Madhan Kumar et al.

SURFACE & COATINGS TECHNOLOGY (2015)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Effect of Alloying Tin on the Corrosion Characteristics of Austenitic Stainless Steel in Sulfuric Acid and Sodium Chloride Solutions

Min Sun et al.

ACTA METALLURGICA SINICA-ENGLISH LETTERS (2015)

添加到收藏夹

Article Electrochemistry

The history of the Point Defect Model for the passive state: A brief review of film growth aspects

Digby D. Macdonald

ELECTROCHIMICA ACTA (2011)

添加到收藏夹

Article Materials Science, Multidisciplinary

Effect of tin on the corrosion behavior of low-alloy steel in an acid chloride solution

Nguyen Dang Nam et al.

CORROSION SCIENCE (2010)

添加到收藏夹

Article Electrochemistry

Study of the effects of hydrogen on the pitting processes of X70 carbon steel with SECM

Yuan Yuan et al.

ELECTROCHEMISTRY COMMUNICATIONS (2010)

添加到收藏夹

Article Chemistry, Applied

Scanning electrochemical microscopy for the investigation of localized degradation processes in coated metals

Yaiza Gonzalez-Garcia et al.

PROGRESS IN ORGANIC COATINGS (2010)

添加到收藏夹

Article Materials Science, Multidisciplinary

Influence of Ti, C and N concentration on the intergranular corrosion behaviour of AISI 316Ti and 321 stainless steels

A. Pardo et al.

ACTA MATERIALIA (2007)

添加到收藏夹

Article Materials Science, Multidisciplinary

Pitting corrosion behaviour of austenitic stainless steels with Cu and Sn additions

A. Pardo et al.

CORROSION SCIENCE (2007)

添加到收藏夹

Article Materials Science, Multidisciplinary

Influence of Cu and Sn content in the corrosion of AISI 304 and 316 stainless steels in H2SO4

A Pardo et al.

CORROSION SCIENCE (2006)

添加到收藏夹

Article Electrochemistry

Pit initiation at single sulfide inclusions in stainless steel - I. Electrochemical microcell measurements

EG Webb et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2002)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.