4.3 Article

Reduced Toxicity and Aqueous-Based Solvent Using Phosphoric Acid as the Dopant Source for Formation Emitter Layer of Silicon Solar Cells

相关参考文献

注意:仅列出部分参考文献,下载原文获取全部文献信息。
Article Chemistry, Physical

Non-Destructive Evaluation of Toxic-Less Approach on Emitter Formation by Water-based Phosphoric Acid for n-Type Silicon

Ahmad Rujhan Mohd Rais et al.

Summary: This paper explores the potential of using phosphoric acid as the emitter formation for silicon solar cells, which is less harmful to the environment and human health compared to the conventional toxic process. Different depths of junction were achieved through dip coating experiments at various temperatures and times. The experimental results of phosphorus activation using 20% H3PO4 supported the calculated junction depth. The overall efficiency of the n-type emitter on n-Si solar cell was determined using the measured sheet resistance and was found to be 8.6%.

SILICON (2023)

Article Energy & Fuels

Optimizing Emitter Diffusion Process for Atmospheric Pressure Dry Nanotextured Monocrystalline PERC

Ahmed Ridoy et al.

Summary: This article presents an optimization of emitter diffusion for nanotextured p-type monocrystalline silicon solar cells using atmospheric pressure dry etching and a short acidic etch, resulting in improved electrical properties and cell performances, ultimately leading to a 20.9% conversion efficiency.

IEEE JOURNAL OF PHOTOVOLTAICS (2022)

Article Energy & Fuels

Lowering firing temperature of a p-type passivated emitter rear contact Si solar cell via current injection

Dongjin Choi et al.

Summary: This study investigates effective contact formation during low-temperature firing with applied current in Si solar cells. By applying a current during firing, contact resistance was reduced and SiNx etching was enhanced, resulting in improved device efficiency.

SOLAR ENERGY MATERIALS AND SOLAR CELLS (2022)

Article Chemistry, Physical

Morphological, Optical and Electrical Analysis of Ag Polymer-Nickel Low Temperature Top Electrode in Silicon Solar Cell for Tandem Application

Nur Fairuz Rostan et al.

Summary: Metallisation is a crucial factor in the production of high-quality and high-performance solar cells. This study investigated the use of a combination of Ag polymer and nickel as the top electrode, which exhibited low resistance, high transmission, and moisture protection capabilities.

SILICON (2022)

Article Engineering, Electrical & Electronic

Enhancement of the conversion efficiency of selective emitter PERC solar cells by post-oxidation

Rui Tong et al.

Summary: This paper investigates the effect of thermal oxidation on the performance of passivated emitter and rear cells (PERC) after the diffusion process. It is found that post-oxidation using an annealing furnace improves the electrical properties of solar cells and mitigates laser-induced damage during the laser doping process.

MATERIALS SCIENCE IN SEMICONDUCTOR PROCESSING (2022)

Article Green & Sustainable Science & Technology

Consumer Acceptance of Renewable Energy in Peninsular Malaysia

Zailin Zainal Ariffin et al.

Summary: This study examines the willingness and ability of consumers in Peninsular Malaysia to pay for renewable energy, finding that consumers' concerns and knowledge about renewable energy are positively related to their willingness to pay more. Additionally, consumers' energy consumption patterns were found to influence their willingness to pay more for renewable energy. These findings have implications for policymakers in Malaysia.

SUSTAINABILITY (2022)

Article Nanoscience & Nanotechnology

Solution-Doped Polysilicon Passivating Contacts for Silicon Solar Cells

Xinbo Yang et al.

Summary: A simple and efficient solution-doping process was proposed for preparing high-quality poly-Si-based passivating contacts, achieving low contact recombination parameter and resistivity through optimized doping and thermal annealing. The method proved to be a promising alternative to gas/ion implantation doping for manufacturing poly-Si passivating contacts in solar cells, leading to the best power conversion efficiency on a planar substrate.

ACS APPLIED MATERIALS & INTERFACES (2021)

Article Green & Sustainable Science & Technology

Simplified process flow for the fabrication of PERC solar cells with ion implanted emitter

Gence Bektas et al.

Summary: The study introduces a simplified process flow for the fabrication of ion implanted PERC cells with Al2O3/SiNx rear passivation stack without any rear side processing, achieving a power conversion efficiency of 20% at large area. The research also highlights the sensitivity of solar cell efficiency to firing peak temperature, implantation dose, and Al2O3 thickness.

RENEWABLE ENERGY (2021)

Article Energy & Fuels

Phosphorus-doped polycrystalline silicon passivating contacts via spin-on doping

Zetao Ding et al.

Summary: Phosphorus spin-on doping is proposed as an alternative doping method for high performance poly-Si passivating contacts, showing promising results in promoting efficiency of silicon solar cells.

SOLAR ENERGY MATERIALS AND SOLAR CELLS (2021)

Article Energy & Fuels

Inkjet printing of phosphorus dopant sources for doping poly-silicon in solar cells with passivating contacts

Zohreh Kiaee et al.

Summary: In this study, inkjet printing of phosphorus inks was used as a dopant source for fabricating silicon solar cells with tunnel oxide passivating contacts. Rheological characterizations were carried out to optimize printing processes, resulting in high cell efficiency and excellent passivation quality. The research demonstrates the high potential of inkjet printing processes in improving the performance of solar cells.

SOLAR ENERGY MATERIALS AND SOLAR CELLS (2021)

Article Energy & Fuels

Optimization of Mono-Crystalline Silicon Solar Cell Devices Using PC1D Simulation

Gokul Sidarth Thirunavukkarasu et al.

Summary: The study used PC1D simulation software to investigate the influence of various parameters on solar cell efficiency, identifying key factors in improving the efficiency of silicon solar cells.

ENERGIES (2021)

Article Energy & Fuels

Enhanced performance of solar cell with n+ emitter by SiO2 nanospheres assisted liquid phosphorus diffusion

Binkang Lai et al.

Summary: By using SiO2 nanospheres for phosphoric acid spin-on doping, the quality of n(+) emitter can be improved and efficiency enhanced. With the change in phosphoric acid concentration, sheet resistance decreases, diffusion uniformity increases; surface doping concentration increases with phosphoric acid within a certain range.

SOLAR ENERGY (2021)

Article Engineering, Electrical & Electronic

Reducing light reflection by processing the surface of silicon solar cells

Shao-Hwa Hu et al.

JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS (2020)

Article Engineering, Multidisciplinary

An Improved Efficiency by Surface Modification Using Pulse Laser for Partial Transparent Bifacial Solar Cell

Muhd Hatim Rohaizar et al.

JURNAL KEJURUTERAAN (2020)

Article Materials Science, Multidisciplinary

Efficiency characteristics of a silicon oxide passivation layer on p-type crystalline silicon solar cell at low illumination

Jong Hoon Lee et al.

CURRENT APPLIED PHYSICS (2019)

Article Engineering, Electrical & Electronic

Optimized phosphorus diffusion process and performance improvement of c-Si solar cell by eliminating SiP precipitates in the emitter

Peng Dong et al.

JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS (2019)

Article Energy & Fuels

Ceramic Roller Inline Diffusion With Lowest Standard Deviation for Crystalline Si Solar Cells

Zhiping Huang et al.

IEEE JOURNAL OF PHOTOVOLTAICS (2019)

Article Engineering, Electrical & Electronic

Effect of diffusion parameters on emitter formation in silicon solar cells by proximity rapid thermal diffusion

A. Oates et al.

MATERIALS SCIENCE IN SEMICONDUCTOR PROCESSING (2018)

Article Energy & Fuels

SiO2 surface passivation layers a key technology for silicon solar cells

Stefan W. Glunz et al.

SOLAR ENERGY MATERIALS AND SOLAR CELLS (2018)

Article Energy & Fuels

266-nm ps Laser Ablation for Copper-Plated p-Type Selective Emitter PERC Silicon Solar Cells

Pei-Chieh Hsiao et al.

IEEE JOURNAL OF PHOTOVOLTAICS (2018)

Proceedings Paper Energy & Fuels

Transfer of POCl3 Diffusion Processes from Atmospheric Pressure to High Throughput Low Pressure

Sabrina Lohmuller (Nee Werner) et al.

SILICONPV 2018: THE 8TH INTERNATIONAL CONFERENCE ON CRYSTALLINE SILICON PHOTOVOLTAICS (2018)

Article Engineering, Multidisciplinary

Optimization of Phosphoric Acid-Based Emitter Formation on Silicon Wafer

Zon Fazlila Mohd Ahir et al.

JURNAL KEJURUTERAAN (2018)

Article Energy & Fuels

POCl3 diffusion for industrial Si solar cell emitter formation

Hongzhao Li et al.

FRONTIERS IN ENERGY (2017)

Article Materials Science, Multidisciplinary

In-depth investigation of spin-on doped solar cells with thermally grown oxide passivation

Samir Mahmmod Ahmad et al.

RESULTS IN PHYSICS (2017)

Article Materials Science, Multidisciplinary

A Well-Controlled PSG Layer on Silicon Solar Cells against Potential Induced Degradation

Chen-Hsun Du et al.

ECS JOURNAL OF SOLID STATE SCIENCE AND TECHNOLOGY (2015)

Proceedings Paper Energy & Fuels

Impact of rear side roughness on optical and electrical properties of a high-efficiency solar cell

Maxi Richter et al.

5TH INTERNATIONAL CONFERENCE ON SILICON PHOTOVOLTAICS, SILICONPV 2015 (2015)

Article Nanoscience & Nanotechnology

Optimization of oxidation processes to improve crystalline silicon solar cell emitters

L. Shen et al.

AIP ADVANCES (2014)

Article Physics, Applied

Recombination at textured silicon surfaces passivated with silicon dioxide

Keith R. McIntosh et al.

JOURNAL OF APPLIED PHYSICS (2009)

Article Energy & Fuels

Internal quantum efficiency for solar cells

W. J. Yang et al.

SOLAR ENERGY (2008)

Article Electrochemistry

Development of a phosphorus spray diffusion system for low-cost silicon solar cells

D. S. Kim et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2006)