☆ 4.6 Article

Fracture Analysis of Short-Scale Corroded/Healthy Reinforced Concrete Beams under Bending Using Acoustic Emission

MATERIALS (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Construction & Building Technology

Field study of the dielectric constant of concrete: A parameter less sensitive to environmental variations than electrical resistivity

Rui He et al.

Summary: In this study, the effectiveness of curing concrete slabs using air and compound methods was evaluated using non-destructive testing methods. The developments of dielectric constant value, compressive strength, hydration degree, and microstructure of the cured slabs were measured. The results showed that the dielectric constant value of compound cured concrete slabs was consistently higher than that of air cured slabs. The second reflected pulse peak amplitude of ground penetrating radar (GPR) waveform was a reliable indicator of the dielectric constant value. The dielectric constant value determined by the two-way travel time method exhibited strong correlations with compressive strength, CH content, and porosity.

JOURNAL OF BUILDING ENGINEERING (2023)

添加到收藏夹

Review Construction & Building Technology

Steel corrosion damage monitoring in reinforced concrete structures with the acoustic emission technique: A review

Els Verstrynge et al.

Summary: This paper reviews the application of Acoustic Emission (AE) monitoring in reinforced concrete (RC) corrosion monitoring and discusses the challenges and pitfalls. It provides a solid basis for extending the research focus towards on-site AE-based corrosion monitoring in RC structures through an overview of laboratory experiments and on-site studies.

CONSTRUCTION AND BUILDING MATERIALS (2022)

添加到收藏夹

Article Engineering, Multidisciplinary

Fractal characteristics and damage evaluation of corroded beams under four-point bending tests based on acoustic emission techniques

Yonglai Zheng et al.

Summary: This study investigates the relationship between the fractal characteristics of the acoustic emission (AE) signal parameter sequence and the damage evolution information of corroded RC beams under four-point bending. By coupling the four-point bending test and the AE monitoring, strength deterioration behavior and AE data are obtained. The results show that both the corroded and uncorroded beams exhibit prominent fractal characteristics in the AE ringing counts. The fractal dimension values of the corroded RC beams fluctuate to a peak and then sharply drop before failure. The damage index corresponding to the peak point decreases with increasing corrosion degree. The fractal dimension peak point can be utilized as an early warning point for failure in corroded RC beams. The fractal dimension analysis of AE can effectively reflect the pattern of crack development, which is valuable in evaluating the rupture process of corroded RC beams.

MEASUREMENT (2022)

添加到收藏夹

Article Geochemistry & Geophysics

Macro-Microscopic Deterioration Behavior of Gypsum Rock after Wetting and Its Constitutive Model Based on Acoustic Emission

Xiaoding Xu et al.

Summary: Gypsum rock undergoes mechanical deterioration when exposed to a water environment. This study explores the effects of water content and immersion time on the mechanical behavior of gypsum rock. Scanning electron microscope images reveal that the internal microstructure of gypsum rock becomes looser and more complex with longer immersion times. The fractal dimensions of these images quantify the degree of damage. Triaxial compression tests establish the relationship between water content and mechanical response, and acoustic emission analysis shows a positive correlation between immersion time and AE frequency, and a negative correlation with AE cumulative count. A damage constitutive model is developed based on these findings.

MINERALS (2022)

添加到收藏夹

Article Construction & Building Technology

Failure mechanisms of corroded/non-corroded RC cylinder under axial compressive loading evaluated by AE technique

Mouhamadou Mountakhah Seye et al.

Summary: This study used the acoustic emission technique to investigate the mechanical behaviors and failure processes of corroded and non-corroded reinforced concrete cylinders under compressive loading. The results showed that the corrosion of rebars decreased the load-carrying capacity of the RC cylinders and caused early damages during the compression test.

FRONTIERS IN BUILT ENVIRONMENT (2022)

添加到收藏夹

Article Construction & Building Technology

Real-time localization of micro-damage in concrete beams using DIC technology and wavelet packet analysis

Kaiyang Zhou et al.

Summary: This study combines DIC and Daubechies wavelet method to achieve real-time location of micro-damage on concrete structures, providing an effective and feasible method for structural health monitoring.

CEMENT & CONCRETE COMPOSITES (2021)

添加到收藏夹

Article Engineering, Geological

Micro-Mesoscopic Creep Damage Evolution and Failure Mechanism of Sandy Mudstone

Hongwen Jing et al.

Summary: This study investigated the micro-mesoscopic creep damage evolution and failure mechanism of a typical sandy mudstone from the deep-buried roadway of the Kouzidong coal mine. It was found that creep loading leads to more severe, homogeneous, and dispersed microdamage in sandy mudstone, resulting in a looser failure mode. Both experimental and numerical results validate the microdamage evolution mechanism under creep loading in sandy mudstone.

INTERNATIONAL JOURNAL OF GEOMECHANICS (2021)

添加到收藏夹

Article Multidisciplinary Sciences

Acoustic Emission Monitoring of RC Beams Corroded to Different Levels Under Flexural Loading

Sunil Garhwal et al.

Summary: The research evaluates the behavior of large-sized reinforced concrete beams corroded to different levels under flexural loading using local acoustic emission technique. As corrosion level increases, the ultimate load-carrying capacity and midspan deflections decrease significantly, indicating increased brittleness and decreased ductility in the corroded beams. AE monitoring shows various stages of failure progression in corroded RC beams under flexural loading, with a significant drop in cumulative AE hits as corrosion level increases.

ARABIAN JOURNAL FOR SCIENCE AND ENGINEERING (2021)

添加到收藏夹

Article Construction & Building Technology

Localisation and characterisation of corrosion damage in reinforced concrete by means of acoustic emission and X-ray computed tomography

Charlotte Van Steen et al.

CONSTRUCTION AND BUILDING MATERIALS (2019)

添加到收藏夹

Article Construction & Building Technology

Assessing the bond behaviour of corroded smooth and ribbed rebars with acoustic emission monitoring

Charlotte Van Steen et al.

CEMENT AND CONCRETE RESEARCH (2019)

添加到收藏夹

Article Materials Science, Multidisciplinary

Determining porosity and pore network connectivity of cement-based materials by a modified non-contact electrical resistivity measurement: Experiment and theory

Rui He et al.

MATERIALS & DESIGN (2018)

添加到收藏夹

Article Construction & Building Technology

Characterization of damage in concrete beams under bending with Acoustic Emission Technique (AET)

Tam Nguyen-Tat et al.

CONSTRUCTION AND BUILDING MATERIALS (2018)

添加到收藏夹

Article Construction & Building Technology

Acoustic emission-based analysis of bond behavior of corroded reinforcement in existing concrete structures

Ahmed A. Abouhussien et al.

STRUCTURAL CONTROL & HEALTH MONITORING (2017)

添加到收藏夹

Article Construction & Building Technology

Monitoring fracture of steel corroded reinforced concrete members under flexure by acoustic emission technique

Ahmad Zaki et al.

CONSTRUCTION AND BUILDING MATERIALS (2017)

添加到收藏夹

Article Acoustics

Acoustic emission monitoring of reinforced concrete beams subjected to four-point-bending

Prabhat Ranjan Prem et al.

APPLIED ACOUSTICS (2017)

添加到收藏夹

Article Construction & Building Technology

Influence of corrosion on the bond strength of steel rebars in concrete

Simona Coccia et al.

MATERIALS AND STRUCTURES (2016)

添加到收藏夹

Article Construction & Building Technology

Evaluation for RC specimen damaged from rebar corrosion by acoustic emission technique

Yuma Kawasaki et al.

CONSTRUCTION AND BUILDING MATERIALS (2014)

添加到收藏夹

Article Construction & Building Technology

Integrated non-destructive assessment of concrete structures under flexure by acoustic emission and travel time tomography

A. Behnia et al.

CONSTRUCTION AND BUILDING MATERIALS (2014)

添加到收藏夹

Article Materials Science, Multidisciplinary

Identification of corrosion mechanisms by univariate and multivariate statistical analysis during long term acoustic emission monitoring on a pre-stressed concrete beam

L. Calabrese et al.

CORROSION SCIENCE (2013)

添加到收藏夹

Article Construction & Building Technology

Acoustic emission characterization of the fracture process in fibre reinforced concrete

D. G. Aggelis et al.

CONSTRUCTION AND BUILDING MATERIALS (2011)

添加到收藏夹

Article Mechanics

Classification of cracking mode in concrete by acoustic emission parameters

Dimitrios G. Aggelis

MECHANICS RESEARCH COMMUNICATIONS (2011)

添加到收藏夹

Article Construction & Building Technology

Damage analysis of reinforced concrete buildings by the acoustic emission technique

A. Carpinteri et al.

STRUCTURAL CONTROL & HEALTH MONITORING (2011)

添加到收藏夹

Article Construction & Building Technology

AE monitoring of corrosion process in cyclic wet-dry test

Yuma Kawasaki et al.

CONSTRUCTION AND BUILDING MATERIALS (2010)

添加到收藏夹

Article Construction & Building Technology

Crack classification in concrete based on acoustic emission

Kentaro Ohno et al.

CONSTRUCTION AND BUILDING MATERIALS (2010)

添加到收藏夹

Article Materials Science, Multidisciplinary

Corrosion process in reinforced concrete identified by acoustic emission

Masayasu Ohtsu et al.

MATERIALS TRANSACTIONS (2007)

添加到收藏夹

Article Construction & Building Technology

Signal-based acoustic emission techniques in civil engineering

CU Grosse et al.

JOURNAL OF MATERIALS IN CIVIL ENGINEERING (2003)

添加到收藏夹

Article Construction & Building Technology

Assessing damage of reinforced concrete beam using b-value analysis of acoustic emission signals

IS Colombo et al.

JOURNAL OF MATERIALS IN CIVIL ENGINEERING (2003)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.