☆ 3.8 Article

A Model of the Flow of a Nanomedium Removing Particles from the Electroerosion Zone

SURFACE ENGINEERING AND APPLIED ELECTROCHEMISTRY (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Materials Science, Coatings & Films

Optimizing direct laser metal deposition of H13 cladding on CuBe alloy substrate

M. Pellizzari et al.

Summary: This work aims to deposit single-layer H13 tool steel cladding on a CuBe alloy substrate using DLMD. By optimizing the process parameters and substrate preheating temperature, a high-quality and dense cladding layer was successfully obtained.

SURFACE & COATINGS TECHNOLOGY (2022)

添加到收藏夹

Review Materials Science, Multidisciplinary

Review of manufacturing technologies for coated accident tolerant fuel cladding

Jaehwan Ko et al.

Summary: This article reviews the current status of accident tolerant fuel (ATF) cladding development and discusses key issues and techniques for near-term development. The performance of ATF cladding manufactured using different methods is comparatively analyzed, and the oxidation resistance at high temperature is examined. Furthermore, future research directions and challenges are discussed.

JOURNAL OF NUCLEAR MATERIALS (2022)

添加到收藏夹

Article Materials Science, Coatings & Films

Microstructure and wear behavior of laser clad interstitial CoCrFeNi high entropy alloy coating reinforced by carbon nanotubes

Bing Han et al.

Summary: The effect of carbon nanotubes (CNTs) in reinforcing a laser clad interstitial CoCrFeNi high entropy alloy coating was investigated. The addition of CNTs enhanced the hardness and wear properties of the coating. The microstructure of the CNTs on the powder surface was well protected from damage, and the wear rate of the coating was significantly reduced. This improvement in wear performance was attributed to the solution strengthening and precipitation strengthening effects of carbon and carbides.

SURFACE & COATINGS TECHNOLOGY (2022)

添加到收藏夹

Article Materials Science, Coatings & Films

Effect and action mechanism of ultrasonic assistance on microstructure and mechanical performance of laser cladding 316L stainless steel coating

D. -D. Zhuang et al.

Summary: The effect and mechanism of ultrasonic vibration on the microstructure and performance of laser cladding 316L coating has been studied, showing that ultrasonic vibration can effectively improve the forming quality, wear resistance, and corrosion resistance of the cladding layer.

SURFACE & COATINGS TECHNOLOGY (2022)

添加到收藏夹

Article Optics

Microstructure and corrosion behavior of Al-Ti-TiC-CNTs/AZ31 magnesium matrix composites prepared using laser cladding and high speed friction stir processing

Fenjun Liu et al.

Summary: Al-Ti-TiC-CNTs/AZ31 magnesium matrix composites prepared by laser cladding (LC) and high speed friction stir processing (HS-FSP) exhibit refined microstructure, improved microhardness and corrosion resistance.

OPTICS AND LASER TECHNOLOGY (2022)

添加到收藏夹

Review Nuclear Science & Technology

Cold spray technology in nuclear energy applications: A review of recent advances

Hwasung Yeom et al.

Summary: Cold spray technology is being explored for various applications in the nuclear energy sector, including coating deposition, near-net shape manufacturing, and component repair. The focus is on improving accident-tolerant fuel cladding, enhancing wear resistance and heat transfer, and addressing stress corrosion cracking in used fuel storage systems.

ANNALS OF NUCLEAR ENERGY (2021)

添加到收藏夹

Review Optics

Recent trends in laser cladding and surface alloying

Anas Ahmad Siddiqui et al.

Summary: Laser cladding and surface alloying techniques are employed to improve surface properties of materials, with proper selection of input parameters significantly enhancing their performance. Research in this area has attracted extensive interest due to the development of high power lasers and improved control mechanisms.

OPTICS AND LASER TECHNOLOGY (2021)

添加到收藏夹

Article Chemistry, Physical

Nanolayer in brush collector contact under Joule heating

Vera Deeva et al.

APPLIED SURFACE SCIENCE (2020)

添加到收藏夹

Article Electrochemistry

Electrical Discharge Drilling of Small Diameter Holes upon Ultrasonic Field Application. Part 1. Results of Technological Experiments

A. A. Gruzdev et al.

SURFACE ENGINEERING AND APPLIED ELECTROCHEMISTRY (2020)

添加到收藏夹

Article Multidisciplinary Sciences

Limits on gas impermeability of graphene

P. Z. Sun et al.

NATURE (2020)

添加到收藏夹

Article Chemistry, Physical

Mathematical model of tip oscillations: Influence on image quality

Vera Deeva et al.

APPLIED SURFACE SCIENCE (2020)

添加到收藏夹

Article Electrochemistry

Optimization of the Process of Fine Electric Discharge Dispersion

A. P. Malyushevskaya et al.

SURFACE ENGINEERING AND APPLIED ELECTROCHEMISTRY (2020)

添加到收藏夹

Article Electrochemistry

Application of an Electric Arc to Produce Metal Powders

V. M. Bokov et al.

SURFACE ENGINEERING AND APPLIED ELECTROCHEMISTRY (2020)

添加到收藏夹

Article Engineering, Electrical & Electronic

Simulation of Voltage/Current Waveforms and Contact Area of Pulsed Surface Discharge on Water

Tomohiro Furusato et al.

IEEE TRANSACTIONS ON DIELECTRICS AND ELECTRICAL INSULATION (2019)

添加到收藏夹

Article Electrochemistry

Mechanism of Formation of Plane Surfaces with an Electric Arc

V. M. Bokov et al.

SURFACE ENGINEERING AND APPLIED ELECTROCHEMISTRY (2019)

添加到收藏夹

Article Engineering, Mechanical

Assessment of the Tribological Contact Between Sliding Surfaces Via an Entropy Approach

Vera Deeva et al.

JOURNAL OF TRIBOLOGY-TRANSACTIONS OF THE ASME (2019)

添加到收藏夹

Article Engineering, Chemical

Development and validation of an enhanced filtered drag model for simulating gas-solid fluidization of Geldart A particles in all flow regimes

Xi Gao et al.

CHEMICAL ENGINEERING SCIENCE (2018)

添加到收藏夹

Article Thermodynamics

Effects of pipe size on horizontal two-phase flow: Flow regimes, pressure drop, two-phase flow parameters, and drift-flux analysis

Ran Kong et al.

EXPERIMENTAL THERMAL AND FLUID SCIENCE (2018)

添加到收藏夹

Article Mechanics

Frictional pressure drop correlation for two-phase flows in mini and micro single-channels

Xuejiao Li et al.

INTERNATIONAL JOURNAL OF MULTIPHASE FLOW (2017)

添加到收藏夹

Article Multidisciplinary Sciences

Harvesting electrical energy from carbon nanotube yarn twist

Shi Hyeong Kim et al.

SCIENCE (2017)

添加到收藏夹

Article Multidisciplinary Sciences

Molecular transport through capillaries made with atomic-scale precision

B. Radha et al.

NATURE (2016)

添加到收藏夹

Proceedings Paper Materials Science, Multidisciplinary

Physical model of the sliding contact of conductors of the alloy Cu-Zr and Cu-Re under high current density

Vera Deeva et al.

MATERIALS TODAY-PROCEEDINGS (2016)

添加到收藏夹

Article Physics, Multidisciplinary

Effect of cylindrical filler aggregation on the electrical conductivity of composites

Jaime Silva et al.

PHYSICS LETTERS A (2014)

添加到收藏夹

Article Engineering, Manufacturing

Numerical modelling of electrohydraulic free-forming and die-forming of DP590 steel

Amir Hassannejadasl et al.

JOURNAL OF MANUFACTURING PROCESSES (2014)

添加到收藏夹

Review Chemistry, Physical

Progress in Titanium Metal Powder Injection Molding

Randall M. German

MATERIALS (2013)

添加到收藏夹

Article Engineering, Manufacturing

Modelling of electro hydraulic free and die forming of sheet steels

Arne Melander et al.

INTERNATIONAL JOURNAL OF MATERIAL FORMING (2013)

添加到收藏夹

Article Chemistry, Multidisciplinary

Synthesis of individual ultra-long carbon nanotubes and transfer to other substrates

Than Xuan Tinh et al.

JOURNAL OF EXPERIMENTAL NANOSCIENCE (2011)

添加到收藏夹

Article Engineering, Multidisciplinary

Method of acoustic sensor diagnosis

M. S. Slobodyan et al.

MEASUREMENT TECHNIQUES (2008)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.