☆ 4.7 Article

Enhancing the performances of EB-PVD TBCs via overlayer Al-modification

SURFACE & COATINGS TECHNOLOGY (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Materials Science, Coatings & Films

Enhanced reliability with bimodal microstructure and transformation-induced toughening in Al2O3-YSZ based thermal barrier coatings

Shiven Ponnapureddy et al.

Summary: This study investigates the use of a bimodal microstructure consisting of nanometer-sized Al2O3, micrometer-sized Al2O3, 3YSZ, and CNT as a thermal barrier coating. The coating, deposited onto an Inconel 718 substrate, shows improved density and crack resistance compared to conventional Al2O3 coatings.

SURFACE & COATINGS TECHNOLOGY (2023)

添加到收藏夹

Article Materials Science, Multidisciplinary

CMAS plus sea salt corrosion to thermal barrier coatings

Lei Guo et al.

Summary: In the marine environment, the coexistence of sea salt and CMAS poses a significant threat to the safety of thermal barrier coatings (TBCs). This study investigated the corrosion behavior of synthetic sea salt and CMAS towards TBCs. Sea salt altered the structure of CMAS, reducing its melting temperature and high-temperature viscosity. At 1200 degrees C, CMAS + sea salt completely melted while CMAS did not; at 1250 degrees C, both melted, but CMAS + sea salt exhibited a stronger penetration ability in TBCs compared to CMAS. Therefore, TBCs that have not been affected by CMAS or are less affected may still be damaged by CMAS + sea salt attack.

CORROSION SCIENCE (2023)

添加到收藏夹

Article Materials Science, Multidisciplinary

Study of CMAS infiltration and evaporation behaviour under water vapour/sulphur oxide conditions in EB-PVD 7YSZ

X. Montero et al.

Summary: This study investigated the infiltration behavior of CMAS in 7YSZ under different atmospheres and analyzed the corrosion mechanisms. It was found that the hydroxylation of CMAS elements under wet conditions changed their infiltration behavior.

CORROSION SCIENCE (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Surface roughness affects metastable non-wetting behavior of silicate melts on thermal barrier coatings

Shan-Jie Yang et al.

Summary: This study found that thermal barrier coatings with smoother surfaces exhibit stronger wettability and spreading resistance to molten silicate, resulting in reduced damage area at high temperatures.

RARE METALS (2022)

添加到收藏夹

Article Materials Science, Ceramics

Al-modification for PS-PVD 7YSZ TBCs to improve particle erosion and thermal cycle performances

Xiaofeng Zhang et al.

Summary: Plasma spray-physical vapor deposition (PS-PVD) is a novel process for preparing feather-like columnar thermal barrier coatings (TBCs) with good strain tolerance and non-line-of-sight (NLOS) deposition, which shows great potential in the field of aero-engines. However, particle erosion is a weakness for PS-PVD 7YSZ TBCs due to the harsh service environment. To address this issue, an Al-modification approach is proposed, which forms an alpha-Al2O3 overlay on the surface of 7YSZ columnar coating through in-situ reaction of Al and ZrO2. The results demonstrate that this approach can improve particle erosion resistance and has better thermal cycle performance compared to the as-sprayed TBCs.

JOURNAL OF ADVANCED CERAMICS (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Oxidation behavior of high Hf nickel-based superalloy in air at 900, 1000 and 1100°C

Jiu-han Xiao et al.

Summary: This study investigated the oxidation behavior of a nickel-based superalloy with high hafnium content through isothermal oxidation tests at different temperatures. The results showed that the alloy exhibited excellent oxidation resistance, with the formation of HfO2 particles at higher temperatures interacting with Al2O3. The mechanisms of HfO2 formation and its impact on oxidation resistance were analyzed based on the results of the oxidation tests at different temperatures.

INTERNATIONAL JOURNAL OF MINERALS METALLURGY AND MATERIALS (2021)

添加到收藏夹

Article Materials Science, Ceramics

Thermal cycling behavior of EB-PVD rare earth oxides co-doping ZrO2-based thermal barrier coatings

Zhen Zhen et al.

Summary: A novel ceramic topcoat of Gd2O3-Yb2O3-Y2O3 co-stabilized ZrO2 (GYbYSZ) thermal barrier coatings was fabricated using electron beam physical vapor deposition (EB-PVD) technique. The study systematically investigated the phase stability, composition, morphology, and cyclic oxidation of the coating. The results showed that the ceramic coat maintained its cubic phase structure after long-term annealing and exhibited a multi-layer structure with layer-by-layer spallation after thermal cycling.

CERAMICS INTERNATIONAL (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Lifetime improvement of EB-PVD 7YSZ TBCs by doping of Hf or Zr in NiCoCrAlY bond coats

Andrea Ebach-Stahl et al.

Summary: Rare earth elements have a positive influence on the oxidation behavior and lifetime of TBC systems. Doping with Hf and Zr in the range of 0.15-0.6 at.% Hf achieves over 3000 cycles, while Zr doping at 0.3 at.% provides a high lifetime of about 2800 cycles. Microstructural changes, including rare earth precipitates, were examined in detail.

CORROSION SCIENCE (2021)

添加到收藏夹

Article Materials Science, Coatings & Films

A study on the mechanical and thermal shock properties of MCrAlY coating prepared by arc ion plating

Shiming Xie et al.

Summary: In this study, MCrAlY coatings with different microstructures were prepared by arc ion plating to investigate their mechanical and thermal shock properties. The results indicate that the microstructure of the coating significantly impacts its thermal shock properties. A columnar structure exhibited poor thermal shock resistance, while a dense and laminar structure was found to be ideal. Increasing bias voltage during coating preparation can achieve the desired structure but may reduce oxidation resistance.

SURFACE & COATINGS TECHNOLOGY (2021)

添加到收藏夹

Article Materials Science, Coatings & Films

A case study on CMAS corrosion of an in-situ microstructure modification YSZ TBCs fabricated by EB-PVD

Xingeng Lei et al.

Summary: By fabricating a microstructure modification yttria-stabilized zirconia (YSZ) top coat with a low-porosity fibrous structure layer on the conventional columnar structure layer, the CMAS corrosion resistance of EB-PVD TBCs was significantly enhanced.

SURFACE & COATINGS TECHNOLOGY (2021)

添加到收藏夹

Review Materials Science, Ceramics

A review on failure mechanism of thermal barrier coatings and strategies to extend their lifetime

Ghazanfar Mehboob et al.

CERAMICS INTERNATIONAL (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Interface failure behavior of yttria stabilized zirconia (YSZ), La2Zr2O7, Gd2Zr2O7, YSZ/La2Zr2O7 and YSZ/Gd2Zr2O7 thermal barrier coatings (TBCs) in thermal cyclic exposure

Abdullah Cahit Karaoglanli et al.

MATERIALS CHARACTERIZATION (2020)

添加到收藏夹

Review Materials Science, Ceramics

Present status and future prospects of plasma sprayed multilayered thermal barrier coating systems

P. G. Lashmi et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2020)

添加到收藏夹

Article Engineering, Mechanical

Chemo-thermo-mechanical modeling of EB-PVD TBC failure subjected to isothermal and cyclic thermal exposures

Shun Yang et al.

INTERNATIONAL JOURNAL OF FATIGUE (2020)

添加到收藏夹

Article Chemistry, Physical

Isothermal oxidation and TGO growth behavior of NiCoCrAlY-YSZ thermal barrier coatings on a Ni-based superalloy

Jiaqi Shi et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2020)

添加到收藏夹

Article Materials Science, Ceramics

CMAS corrosion and thermal cycle of Al-modified PS-PVD environmental barrier coating

Xiaofeng Zhang et al.

CERAMICS INTERNATIONAL (2018)

添加到收藏夹

Article Materials Science, Ceramics

Tailoring the EB-PVD columnar microstructure to mitigate the infiltration of CMAS in 7YSZ thermal barrier coatings

R. Naraparaju et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2017)

添加到收藏夹

Article Materials Science, Coatings & Films

Characterization of the mechanical properties of thermal barrier coatings by 3 points bending tests and modified small punch tests

Pierre Planques et al.

SURFACE & COATINGS TECHNOLOGY (2017)

添加到收藏夹

Article Thermodynamics

A Comparative Experimental Study on Radiative Properties of EB-PVD and Air Plasma Sprayed Thermal Barrier Coatings

G. Yang et al.

JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME (2015)

添加到收藏夹

Article Materials Science, Ceramics

Evaluation of aluminum dross as raw material for high-alumina refractory

Apeng Li et al.

CERAMICS INTERNATIONAL (2014)

添加到收藏夹

Article Materials Science, Coatings & Films

Thermal shock behaviors of YSZ thick thermal barrier coatings fabricated by suspension and atmospheric plasma spraying

Yuexing Zhao et al.

SURFACE & COATINGS TECHNOLOGY (2014)

添加到收藏夹

Review Materials Science, Multidisciplinary

Thermal barrier coatings technology: critical review, progress update, remaining challenges and prospects

R. Darolia

INTERNATIONAL MATERIALS REVIEWS (2013)

添加到收藏夹

Article Materials Science, Coatings & Films

Acoustic emission evaluation of fracture characteristics in thermal barrier coatings under bending

L. Yang et al.

SURFACE & COATINGS TECHNOLOGY (2013)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.