☆ 4.7 Article

Multi-scale contact induced period-doubling vibrations in rotor systems: Numerical and experimental studies

MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Engineering, Mechanical

Electromechanical coupling modeling and motor current signature analysis of bolt loosening of industrial robot joint

Kai Xu et al.

Summary: In this study, a detection method for bolt loosening of industrial robot joint based on electromechanical modeling and motor current signature analysis (MCSA) is proposed. The method utilizes the time-frequency features of the motor current to detect loosening and achieves effective results.

MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2023)

添加到收藏夹

Article Engineering, Mechanical

Combination resonances of rotor systems with asymmetric residual preloads in bolted joints

Jie Hong et al.

Summary: This paper investigates the combination resonances of bolted rotor systems with asymmetric preloads under multi-frequency excitation and proposes a new breathing model. Theoretical and experimental studies demonstrate that combination resonances could occur in practical dual rotor systems near specific frequencies.

MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2023)

添加到收藏夹

Article Mechanics

Nonlinear analysis of a dual-disk rotor system considering elastoplastic contact

Runchao Zhao et al.

Summary: This paper proposes a modified contact model for the gas turbine rotor system, which considers the effect of elastoplastic deformation and is compared with verified experimental results. By introducing an equivalent material layer, a finite element model is established and the dynamic response of the rotor system is solved using the Newmark-fl method. The results show that the proposed contact model accurately reflects the actual contact state and the preload amount leads to the appearance of multiple combined frequency components.

INTERNATIONAL JOURNAL OF NON-LINEAR MECHANICS (2022)

添加到收藏夹

Article Engineering, Aerospace

Study on Fretting Wear of Contact Interface of Curvic Coupling for Circumferential Rod Combined Rotor

Lihua Yang et al.

Summary: This study investigates the effects of bolt preload, torque, and transverse vibration on the fretting characteristics of curvic coupling in a combined rotor gas turbine using the finite-element method and Archard wear theory. The influences of a single mistuned tie rod and the material properties on the fretting characteristics are also examined. The results show that increasing the preload and torque leads to higher contact stress, slide distance, and wear depth. Mistuning in a single rod causes uneven distribution of fretting characteristics. Additionally, the elastic modulus has a notable impact on the fretting characteristics, compared to Poisson's ratio and density. The simulation results are consistent with the experimental findings.

JOURNAL OF AEROSPACE ENGINEERING (2022)

添加到收藏夹

Article Acoustics

Influence of imperfections on the stability of a multi-disc friction system

Alexy Mercier et al.

Summary: This paper studies the impact of geometrical imperfections on the stability and dynamic behavior of mechanical systems exhibiting friction-induced vibrations. It introduces a new phenomenological mechanical model that considers geometrical imperfections and examines their influence on the system's stability. The study finds that the inclusion of these imperfections leads to the emergence of a non-autonomous dynamical system, significantly affecting the system's stability and dynamic behavior.

JOURNAL OF SOUND AND VIBRATION (2022)

添加到收藏夹

Article Engineering, Mechanical

Nonlinear effects of bolted flange connections in aeroengine casing assemblies

Seyed-Ehsan Mir-Haidari et al.

Summary: This research proposes a novel and robust analytical formulation that accurately captures the nonlinear dynamic characteristics of bolted flange connections in aircraft engines. The model demonstrates significant accuracy and precision, as well as computational efficiency, making it feasible for implementing nonlinear analyses of large structural assemblies. The proposed analytical lump model is universal and has been validated using nonlinear experimental test data for an aeroengine casing assembly.

MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2022)

添加到收藏夹

Article Engineering, Mechanical

Study on the bistable vibration behaviour of a rod-fastened rotor-bearing system

Jiaqi Li et al.

Summary: This paper investigates the bistable behavior and hysteric cycle in a rod-fastened rotor-bearing system and verifies these phenomena through experiments. Furthermore, the effect of rotor eccentric distance on the bistable behavior is explored.

NONLINEAR DYNAMICS (2022)

添加到收藏夹

Article Engineering, Multidisciplinary

Scaling design strategy for experimental rotor systems subjected to restricted support stiffness

Runchao Zhao et al.

Summary: This paper proposes a design method for scaled rotor systems based on dynamic similarity and restricted support stiffness. Key optimization parameters and ranges are determined through sensitivity analysis, and a genetic algorithm is used to establish a geometrically distorted scaled model to optimize rotor performance. Experimental results show that this design method can accurately predict the dynamic characteristics of the prototype rotor.

APPLIED MATHEMATICAL MODELLING (2022)

添加到收藏夹

Article Engineering, Multidisciplinary

Multi-stage contact model between fractal rough surfaces based on multi-scale asperity deformation

Xin Yu et al.

Summary: A novel multi-stage contact model of fractal rough surfaces is proposed in this paper. The contact behavior of the whole surface is distinguished into five stages based on the deformation modes of multi-scale asperities. The relationship between contact force, normal stiffness, and real contact area under the effects of fractal factors is analyzed, and the developed model is compared with other models and experimental data.

APPLIED MATHEMATICAL MODELLING (2022)

添加到收藏夹

Article Engineering, Mechanical

On an independent subharmonic sequence for vibration isolation and suppression in a nonlinear rotor system

Yeyin Xu et al.

Summary: Independent vibrations in nonlinear systems are advantageous for vibration isolation. In this research, a sequence of odd-order independent subharmonic vibrations in a nonlinear flexible rotor system is studied. The stability and bifurcations of the vibrations are discussed, and it is found that the vibrations can effectively suppress global synchronous vibrations.

MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2022)

添加到收藏夹

Article Mechanics

Establishment of a contact stiffness matrix and its effect on the dynamic behavior of rod-fastening rotor bearing system

Xianglin Wu et al.

Summary: The study established a dynamic model of the rod-fastening rotor-bearing system and analyzed the influence of various factors on the nonlinear dynamic characteristics of the system. The results showed that increasing the pre-tightening load can increase contact stiffness, while increasing rod diameter can delay partial separation of contact surfaces. Uneven pre-tightening load significantly affects the fluctuation of stiffness coefficients and can lead to self-excited vibration frequencies. The number of rods, rod diameter, and contact surface roughness also impact the system's dynamic characteristics.

ARCHIVE OF APPLIED MECHANICS (2021)

添加到收藏夹

Article Engineering, Mechanical

Dynamic modeling and stability analysis of a rotor-bearing system with bolted-disk joint

Yuqi Li et al.

Summary: This study proposes a bolted-disk joint element that considers dynamic parameters and establishes a dynamic model for rotor systems with bolted-disk joints. The research uses numerical methods and graphical analyses to study the system's dynamic behavior under different stiffness conditions, and also examines the influence of bending stiffness of bolted disk joints on system response.

MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2021)

添加到收藏夹

Article Nanoscience & Nanotechnology

A three-dimensional fractal model of the normal contact characteristics of two contacting rough surfaces

Guosheng Lan et al.

Summary: A new model of asperity elastic-plastic contact is proposed in this study, supported by an analytical model of normal contact stiffness and damping considering the influence of contact area distribution and elastoplastic deformation mechanism. Through numerical simulations, the impact of factors such as normal contact load, fractal dimension, fractal roughness, and plastic index on the joint surface's normal contact stiffness and damping is analyzed. Comparison with different models demonstrates that the elastoplastic contact deformation mechanism significantly affects the results, with greater normal contact stiffness and damping when considering the elastoplastic deformation mechanism.

AIP ADVANCES (2021)

添加到收藏夹

Article Engineering, Mechanical

An elasto-plastic contact model for conformal contacts between cylinders

Jianqiao Hu et al.

PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY (2020)

添加到收藏夹

Article Engineering, Mechanical

Dynamic investigation of aeroengine high pressure rotor system considering assembly characteristics of bolted joints

Wei Sun et al.

ENGINEERING FAILURE ANALYSIS (2020)

添加到收藏夹

Article Mathematics, Interdisciplinary Applications

Period-1 Motion to Chaos in a Nonlinear Flexible Rotor System

Yeyin Xu et al.

INTERNATIONAL JOURNAL OF BIFURCATION AND CHAOS (2020)

添加到收藏夹

Article Engineering, Mechanical

Phenomenological Model of Surface Forces and Contact of Rough Surfaces

V. V. Izmailov

JOURNAL OF FRICTION AND WEAR (2020)

添加到收藏夹

Article Engineering, Mechanical

Determination of equivalent transversely isotropic material parameters for sheet-layered lamination stacks

Maximilian Volkan Baloglu et al.

MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2020)

添加到收藏夹

Article Engineering, Mechanical

Thermal effects on the tensile forces of rods in rod-fastened rotor of heavy-duty gas turbine

M. Zhuo et al.

PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE (2019)

添加到收藏夹

Article Engineering, Mechanical

On bifurcation trees of period-1 to period-2 motions in a nonlinear Jeffcott rotor system

Yeyin Xu et al.

INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES (2019)

添加到收藏夹

Article Mathematics, Interdisciplinary Applications

Numerical and experimental investigation of an elastoplastic contact model for spherical discrete elements

Jerzy Rojek et al.

COMPUTATIONAL PARTICLE MECHANICS (2019)

添加到收藏夹

Review Engineering, Mechanical

A review of continuous contact-force models in multibody dynamics

Luka Skrinjar et al.

INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES (2018)

添加到收藏夹

Article Acoustics

Estimating bolt tightness using transverse natural frequencies

Si Mohamed Sah et al.

JOURNAL OF SOUND AND VIBRATION (2018)

添加到收藏夹

Article Engineering, Mechanical

A new elliptical microcontact model considering elastoplastic deformation

Yuqin Wen et al.

PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY (2018)

添加到收藏夹

Article Engineering, Mechanical

Elastoplastic contact mechanics model of rough surface based on fractal theory

Yuan Yuan et al.

CHINESE JOURNAL OF MECHANICAL ENGINEERING (2017)

添加到收藏夹

Article Chemistry, Physical

A revised Majumdar and Bushan model of elastoplastic contact between rough surfaces

Yuan Yuan et al.

APPLIED SURFACE SCIENCE (2017)

添加到收藏夹

Article Mechanics

Nonlinear dynamic response of a rub-impact rod fastening rotor considering nonlinear contact characteristic

Liang Hu et al.

ARCHIVE OF APPLIED MECHANICS (2016)

添加到收藏夹

Article Engineering, Mechanical

Bolt loosening at rotating joint interface and its influence on rotor dynamics

Zhaoye Qin et al.

ENGINEERING FAILURE ANALYSIS (2016)

添加到收藏夹

Article Engineering, Multidisciplinary

Surface contact stress-based nonlinear virtual material method for dynamic analysis of bolted joint of machine tool

Yongsheng Zhao et al.

PRECISION ENGINEERING-JOURNAL OF THE INTERNATIONAL SOCIETIES FOR PRECISION ENGINEERING AND NANOTECHNOLOGY (2016)

添加到收藏夹

Article Acoustics

Investigation on the stability and bifurcation of a rod-fastening rotor bearing system

Yi Liu et al.

JOURNAL OF VIBRATION AND CONTROL (2015)

添加到收藏夹

Article Mechanics

Statistical model of nearly complete elastic rough surface contact

Y. Xu et al.

INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES (2014)

添加到收藏夹

Article Engineering, Mechanical

Nonlinear Deformation Behavior of Bolted Flanges Under Tensile, Torsional, and Bending Loads

Zhijun Wu et al.

JOURNAL OF PRESSURE VESSEL TECHNOLOGY-TRANSACTIONS OF THE ASME (2014)

添加到收藏夹

Article Engineering, Mechanical

Analytical model of bolted disk- drum joints and its application to dynamic analysis of jointed rotor

Z. Y. Qin et al.

PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE (2014)

添加到收藏夹

Article Construction & Building Technology

Bending behavior and design model of bolted flange-plate connection

Y. Q. Wang et al.

JOURNAL OF CONSTRUCTIONAL STEEL RESEARCH (2013)

添加到收藏夹

Article Engineering, Mechanical

Modeling and Validation of the Nonlinear Dynamic Behavior of Bolted Flange Joints

C. W. Schwingshackl et al.

JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME (2013)

添加到收藏夹

Article Engineering, Mechanical

Effects of Bending Moments and Pretightening Forces on the Flexural Stiffness of Contact Interfaces in Rod-Fastened Rotors

Jin Gao et al.

JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME (2012)

添加到收藏夹

Article Engineering, Mechanical

Asperity micro-contact models as applied to the deformation of rough line contact

Ali Beheshti et al.

TRIBOLOGY INTERNATIONAL (2012)

添加到收藏夹

Article Engineering, Chemical

An elastic-plastic contact model of ellipsoid bodies

J. Jamari et al.

TRIBOLOGY LETTERS (2006)

添加到收藏夹

Article Engineering, Mechanical

An elliptical microcontact model considering elastic, elastoplastic, and plastic deformation

YR Jeng et al.

JOURNAL OF TRIBOLOGY-TRANSACTIONS OF THE ASME (2003)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.