Regulation of bimodal structure and mechanical properties of powder-thixoformed GO/ZK60 magnesium matrix composite through adjusting GO content

Although remarkable strength enhancements can be achieved in graphene oxide (GO)/ graphene nanoplatelets (GNPs) reinforced Mg matrix composites by using the available techniques, their ductility is always quite poor due to the difficultly avoided strength-ductility trade-off. To conquer this dilemma, GO/ZK60 composites with bimodal-grain structure were fabricated using powder thixoforming in this work. The results indicate that the grain size and volume fraction of coarse grains (CGs) first decrease as the GO content increases to 0.2 wt.% and then increase again as the content increases to 0.3 wt.%, while the grain size in the fine grains (FGs) almost does not change. Consequently, the strength of the composites is improved with increasing GO content and reaches the peak values at the content of 0.2 wt.%. The composite with 0.1 wt.% GO content exhibits significantly increased tensile yield strength up to 177 +/- 2 MPa while maintaining a high elongation of 23.1% +/- 2.5%, being equivalent to that of the ZK60 matrix alloy. The increased FGs volume fraction, together with the promoted dislocation accumulation and storage via GO and grain refinement of large-sized CGs lead to the improvement of strain hardening ability, thus rendering the composite an excellent ductility. Furthermore, the deformation of the GO/ZK60 composites occurs progressively from the FGs to the CGs, which is opposite to the status of the milled ZK60 matrix alloy. In view of the microstructure characteristics of the composites, a new complex calculation model was proposed and it could well predict the strength of the bimodal GO/ZK60 composites. This study provides a new insight into the microstructure design and fabrication technology of GO/GNPs reinforced metal-based composites with high strength and ductility. (c) 2023 Published by Elsevier Ltd on behalf of The editorial office of Journal of Materials Science & Technology.

Automated summary

In this study, GO/ZK60 composites with bimodal-grain structure were fabricated using powder thixoforming. The strength of the composites was improved with increasing GO content and reached the peak values at 0.2 wt.%. The composite with 0.1 wt.% GO content exhibited significantly increased tensile yield strength and maintained a high elongation, equivalent to that of the ZK60 matrix alloy.