☆ 4.7 Article

Effect of Ca alloying and cryogenic temperature on the slip transmission across the grain boundary in pure Mg

JOURNAL OF ALLOYS AND COMPOUNDS (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Nanoscience & Nanotechnology

Effect of CaO on structure and properties of AZ61 magnesium alloy

Umer Masood Chaudry et al.

Summary: This study investigates the effects of CaO additions on the microstructure, texture, and mechanical properties of AZ61 magnesium alloy. The addition of CaO leads to the formation of Ca-rich intermetallic compounds and influences the evolution of the alloy's structure. Additionally, the alloys containing CaO exhibit twined structures, with an increased fraction of tension twins as the amount of CaO increases.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Effect of deformation temperature on the slip activity in pure Mg and AZX211

Umer Masood Chaudry et al.

Summary: The microstructural evolution and slip activity in pure Mg and AZX211 alloy during deformation at room and cryogenic temperatures were systematically investigated. The results showed that AZX211 exhibited exceptional strength/ductility synergy and superior ductility compared to pure Mg at different temperatures, attributed to grain refinement, texture softening, and Ca-containing second phase particles. Analysis of the slip modes revealed higher activities of basal and prismatic slip in AZX211, while pyramidal dislocation slip was promoted in pure Mg at low deformation temperature.

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

A strong, ductile and in-plane tensile isotropic Mg-0.5Zn-0.5Y-0.15Si alloy

Chuan Li et al.

Summary: Strength ductility tradeoff and in-plane isotropy under tensile loading are challenges in magnesium alloys. By fabricating a specific alloy and analyzing factors such as grain size, texture, and precipitates, a magnesium alloy with high strength, high elongation, strain hardenability, and excellent in-plane tensile isotropy can be achieved.

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2022)

添加到收藏夹

Article Chemistry, Physical

Achieving higher dynamic mechanical response by adjusting texture through twinning in a ZK61 Mg alloy

Abdul Malik et al.

Summary: In this study, the reorientation of texture and improvement of mechanical properties in ZK61-T6 and ZK61-PC magnesium alloys were achieved through cross pre-compression. The results showed that the compressive yield strength, ultimate compressive strength, and elongation to fracture were significantly increased. The microstructure evolution revealed the propensity and width of adiabatic shear band and the role of twinning, de-twinning, and dislocation in absorbing high-stress energy. The twinning-induced rotational dynamic recrystallization mechanism contributed to the development of fine grains. Based on the findings, pre-compression is recommended as a practical approach to enhance the efficiency of ZK61 magnesium alloy.

JOURNAL OF ALLOYS AND COMPOUNDS (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Grain boundary co-segregation in magnesium alloys with multiple substitutional elements

Risheng Pei et al.

Summary: Alloying additions in magnesium can modify common basal textures during recrystallization based on their solid solubility and precipitation behavior. The type and level of solute segregation in grain boundaries play a key role in controlling the growth behavior. Further research can advance current alloy design strategies by tweaking the solute concentration in the solid solution.

ACTA MATERIALIA (2021)

添加到收藏夹

Review Materials Science, Multidisciplinary

Microstructure Features and Superplasticity of Extruded, Rolled and SPD-Processed Magnesium Alloys: A Short Review

Abdul Malik et al.

Summary: This study reviews the microstructure features that affect superplasticity of Mg alloys, as well as the deformation behavior under different conditions and dominant deformation mechanisms.Various studies were compared to identify optimal strain rate and temperature for achieving excellent high strain rate superplasticity.

METALS (2021)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Effect of 1Al addition on deformation behavior of Mg

Ji Hyun Hwang et al.

Summary: The deformation behavior of a magnesium alloy containing 1% aluminum has been investigated in this study. The alloy shows much higher strength and larger elongation compared to pure magnesium with similar texture and grain size. Non-basal slips are easily activated in the Mg-1Al alloy at an early stage of deformation, leading to strain localization along the initially formed slip lines with increasing tensile strain.

JOURNAL OF MAGNESIUM AND ALLOYS (2021)

添加到收藏夹

Article Nanoscience & Nanotechnology

The development of a strong and ductile Mg-Zn-Zr thin sheet through nano precipitates and pre-induced dislocation

Abdul Malik et al.

Summary: A strong and ductile Mg-Zn-Zr alloy thin sheet was developed in this study, with fiber basal texture and a large amount of pre-induced dislocations and nano-size precipitates observed in the grain interior. Deformation was accommodated through twinning and dislocations, leading to high yield strength, ultimate tensile strength, and fracture elongation.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2021)

添加到收藏夹

Article Crystallography

Ca-induced Plasticity in Magnesium Alloy: EBSD Measurements and VPSC Calculations

Umer Masood Chaudry et al.

CRYSTALS (2020)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Microstructural characteristics of AZ31 alloys rolled at room and cryogenic temperatures and their variation during annealing

Sang Won Lee et al.

JOURNAL OF MAGNESIUM AND ALLOYS (2020)

添加到收藏夹

Article Chemistry, Physical

A Further Improvement in the Room-Temperature Formability of Magnesium Alloy Sheets by Pre-Stretching

Umer Masood Chaudry et al.

MATERIALS (2020)

添加到收藏夹

Article Engineering, Multidisciplinary

What is the major problem with wrought Mg alloys?

Abdul Malik et al.

RESULTS IN ENGINEERING (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Effect of Ca addition on the room-temperature formability of AZ31 magnesium alloy

U. M. Chaudry et al.

MATERIALS LETTERS (2019)

添加到收藏夹

Article Engineering, Mechanical

Improving ductility of a Mg alloy via non-basal < a > slip induced by Ca addition

Gaoming Zhu et al.

INTERNATIONAL JOURNAL OF PLASTICITY (2019)

添加到收藏夹

Review Chemistry, Physical

On the ductility of magnesium based materials: A mini review

Umer Masood Chaudry et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2019)

添加到收藏夹

Article Nanoscience & Nanotechnology

Local and global deformation behaviour in rolled pure magnesium sheets at room temperature under different strain rates

Gukin Han et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)

添加到收藏夹

Article Nanoscience & Nanotechnology

Effects of calcium on the activity of slip systems in AZ31 magnesium alloy

Urner Masood Chaudry et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)

添加到收藏夹

Article Nanoscience & Nanotechnology

Dislocation binding as an origin for the improvement of room temperature ductility in Mg alloys

Ki-Hyun Kim et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)

添加到收藏夹

Article Multidisciplinary Sciences

A rare-earth free magnesium alloy with improved intrinsic ductility

S. Sandloebes et al.

SCIENTIFIC REPORTS (2017)

添加到收藏夹

Article Materials Science, Multidisciplinary

Effect of Sn addition on the microstructure and deformation behavior of Mg-3Al alloy

Byeong-Chan Suh et al.

ACTA MATERIALIA (2017)

添加到收藏夹

Article Engineering, Mechanical

Texture-based forming limit prediction for Mg sheet alloys ZE10 and AZ31

D. Steglich et al.

INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES (2016)

添加到收藏夹

Review Chemistry, Physical

Recent developments in rare-earth free wrought magnesium alloys having high strength: A review

Hucheng Pan et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2016)

添加到收藏夹

Article Nanoscience & Nanotechnology

Effects of dilute additions of Zn and Ca on ductility of magnesium alloy sheet

Z. R. Zeng et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2016)

添加到收藏夹

Article Materials Science, Multidisciplinary

Texture, deformation twinning and hardening in a newly developed Mg-Dy-Al-Zn-Zr alloy processed with high pressure torsion

Radim Kocich et al.

MATERIALS & DESIGN (2016)

添加到收藏夹

Article Multidisciplinary Sciences

The origins of high hardening and low ductility in magnesium

Zhaoxuan Wu et al.

NATURE (2015)

添加到收藏夹

Article Nanoscience & Nanotechnology

Effects of calcium on texture and mechanical properties of hot-extruded Mg-Zn-Ca alloys

Baoping Zhang et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2012)

添加到收藏夹

Article Materials Science, Multidisciplinary

On the role of non-basal deformation mechanisms for the ductility of Mg and Mg-Y alloys

S. Sandloebes et al.

ACTA MATERIALIA (2011)

添加到收藏夹

Article Nanoscience & Nanotechnology

Effect of particles in promoting twin nucleation in a Mg-5 wt.% Zn alloy

J. D. Robson et al.

SCRIPTA MATERIALIA (2010)

添加到收藏夹

Article Materials Science, Multidisciplinary

Particle effects on recrystallization in magnesium-manganese alloys: Particle-stimulated nucleation

J. D. Robson et al.

ACTA MATERIALIA (2009)

添加到收藏夹

Article Nanoscience & Nanotechnology

Enhancement of tensile ductility and stretch formability of magnesium by addition of 0.2 wt%(0.035 at%)Ce

Yasumasa Chino et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2008)

添加到收藏夹

Article Nanoscience & Nanotechnology

Stretch formability of AZ31 Mg alloy sheets at different testing temperatures

Yasumasa Chino et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2007)

添加到收藏夹

Article Nanoscience & Nanotechnology

Textures and mechanical behavior of Mg-3.3%Li alloy after ECAP

T Liu et al.

SCRIPTA MATERIALIA (2004)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.