相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。Optical diagnostics and chemical kinetic analysis on the dual-fuel combustion of methanol and high reactivity fuels
Yanqing Cui et al.
FUEL (2022)
Effect of water - methanol blends on engine performance at borderline knock conditions in gasoline direct injection engines
Niranjan Miganakallu et al.
APPLIED ENERGY (2020)
Potential of bio-ethanol in different advanced combustion modes for hybrid passenger vehicles
Antonio Garcia et al.
RENEWABLE ENERGY (2020)
Combustion characteristics of high pressure direct-injected methanol ignited by diesel in a constant volume combustion chamber
Ye Wang et al.
FUEL (2019)
A review of synthetic fuels for passenger vehicles
Severin Hanggi et al.
ENERGY REPORTS (2019)
Miller cycle for improved efficiency, load range and emissions in a heavy-duty engine running under reactivity controlled compression ignition combustion
Santiago Molina et al.
APPLIED THERMAL ENGINEERING (2018)
The Impact of Injector Hole Diameter on Spray Behaviour for Butanol-Diesel Blends
Sattar Jabbar Murad Algayyim et al.
ENERGIES (2018)
Simulation and optimization of a methanol synthesis process from different biogas sources
Rafael Oliveira dos Santos et al.
JOURNAL OF CLEANER PRODUCTION (2018)
Reduced Kinetic Mechanism for Methanol Combustion in Spark-Ignition Engines
Christoffer Pichler et al.
ENERGY & FUELS (2018)
Potential of 1-octanol and di-n-butyl ether (DNBE) to improve the performance and reduce the emissions of a direct injected compression ignition diesel engine
Antonio Garcia et al.
ENERGY CONVERSION AND MANAGEMENT (2018)
Effect of split fuel injection and EGR on NOx and PM emission reduction in a low temperature combustion (LTC) mode diesel engine
Ayush Jain et al.
ENERGY (2017)
The effect of the alcohol content in the fuel mixture on the performance and emissions of a direct injection diesel engine fueled with diesel-methanol and diesel-ethanol blends
Arkadiusz Jamrozik
ENERGY CONVERSION AND MANAGEMENT (2017)
Experimental investigation of methanol compression ignition in a high compression ratio HD engine using a Box-Behnken design
Sam Shamun et al.
FUEL (2017)
A detailed chemical kinetic modeling, ignition delay time and jet-stirred reactor study of methanol oxidation
Ultan Burke et al.
COMBUSTION AND FLAME (2016)
Carbon capture, storage and utilisation technologies: A critical analysis and comparison of their life cycle environmental impacts
Rosa M. Cuellar-Franca et al.
JOURNAL OF CO2 UTILIZATION (2015)
The impact of fuel injection pressure on the exhaust emissions of a direct injection diesel engine fueled with biodiesel-diesel fuel blends
Metin Gumus et al.
FUEL (2012)
The Impact of Common Rail System's Control Parameters on the Performance of High-power Diesel
Tan Xu-Guang et al.
2012 INTERNATIONAL CONFERENCE ON FUTURE ENERGY, ENVIRONMENT, AND MATERIALS, PT C (2012)
Effects of Rail Pressure, Pilot Scheduling and EGR Rate on Combustion and Emissions in Conventional and PCCI Diesel Engines
Andrea Emilio Catania et al.
SAE INTERNATIONAL JOURNAL OF ENGINES (2010)
Formaldehyde and Methanol Emissions from a Methanol/Gasoline-Fueled Spark-Ignition (SI) Engine
Yanju Wei et al.
ENERGY & FUELS (2009)
Effect of exhaust gas recirculation (EGR) temperature for various EGR rates on heavy duty DI diesel engine performance and emissions
D. T. Hountalas et al.
ENERGY (2008)
Engine performance and emissions of a diesel engine operating on diesel-RME (rapeseed methyl ester) blends with EGR (exhaust gas recirculation)
A. Tsolakis et al.
ENERGY (2007)
An experimental study of energy balance in low heat rejection diesel engine
I Taymaz
ENERGY (2006)
A dimensionally reduced reaction mechanism for methanol oxidation
RP Lindstedt et al.
PROCEEDINGS OF THE COMBUSTION INSTITUTE (2002)
Reaction mechanism of soot formation in flames
M Frenklach
PHYSICAL CHEMISTRY CHEMICAL PHYSICS (2002)
In-cylinder pressure reconstruction based on instantaneous engine speed signal
D Moro et al.
JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME (2002)
分享论文
