4.7 Article

Assessing fuel economy and NOx emissions of a hydrogen engine bus using neural network algorithms for urban mass transit systems

相关参考文献

注意:仅列出部分参考文献,下载原文获取全部文献信息。
Article Thermodynamics

Comprehensive analysis of the combustion of low carbon fuels (hydrogen, methane and coke oven gas) in a spark ignition engine through CFD modeling

Rafael Ortiz-Imedio et al.

Summary: The study validates the performance of a Volkswagen Polo 1.4L engine fueled with three different LCFs (COG, H2, and CH4) under various operating conditions using computational fluid dynamics simulation tools. It is found that COG provides higher power values but may affect pressure and temperature under certain conditions. Proper management of operating conditions maximizes the conversion of waste stream fuel into useful energy while reducing emissions.

ENERGY CONVERSION AND MANAGEMENT (2022)

Article Energy & Fuels

Effect of hydrogen enrichment on the flame propagation, emissions formation and energy balance of the natural gas spark ignition engine

Xingyu Sun et al.

Summary: Adding hydrogen to natural gas in spark ignition engines improves combustion rate, thermal efficiency, and emissions control.
Review Energy & Fuels

Review of the backfire occurrences and control strategies for port hydrogen injection internal combustion engines

Jianbing Gao et al.

Summary: Hydrogen-fueled internal combustion engines offer zero carbon emissions and excellent combustion characteristics, but the occurrence of backfire in port hydrogen injection engines can limit engine performance improvement, requiring effective control strategies. Backfire control strategies have specific application conditions to ensure their effectiveness and prevent negative impacts.
Article Thermodynamics

Effect of mixture formation mode on the combustion and emission characteristics in a hydrogen direct-injection engine under different load conditions

Sanguk Lee et al.

Summary: This study investigates the efficiency and emission characteristics of a hydrogen direct injection (DI) engine using different mixture formation modes, including homogeneous charge, lean-homogeneous charge, and lean-stratified charge (LSC). The results show that the LSC mode achieves the highest indicated thermal efficiency, but also has high nitrogen oxide emissions. Heat management is crucial for efficient energy extraction from hydrogen.

APPLIED THERMAL ENGINEERING (2022)

Article Thermodynamics

Learning-based supervisory control of dual mode engine-based hybrid electric vehicle with reliance on multivariate trip information

Hao Zhang et al.

Summary: The study explores the potential of combining electrification and advanced dedicated hybrid engines for reducing fuel consumption and emissions. Using experimental data and a multistate deep reinforcement learning method, the study develops an integrated energy management and engine control system that selects optimal combustion mode and processes real-time traffic and terrain information to achieve optimized engine control performance.

ENERGY CONVERSION AND MANAGEMENT (2022)

Article Chemistry, Applied

Parametric assessment of the effect of oxygenated low carbon fuels in a light-duty compression ignition engine

Antonio Garcia et al.

Summary: This study evaluates the combustion characteristics, performance, and emissions of different renewable low carbon fuels and finds that they can reduce soot emissions compared to diesel but increase fuel consumption. The optimization of engine calibration can greatly reduce NOx emissions.

FUEL PROCESSING TECHNOLOGY (2022)

Article Chemistry, Physical

Effect of fuel injection timing and injection pressure on performance in a hydrogen direct injection engine

Cheolwoong Park et al.

Summary: The study utilized components from a gasoline direct-injection engine to implement the in-cylinder hydrogen fuel injection method, adjusting injection timing and pressure to enhance engine output performance and efficiency, resulting in increased torque and reduced NOx emissions.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2022)

Article Thermodynamics

Effects of swirl enhancement on in-cylinder flow and mixture characteristics in a high-compression-ratio, spray-guided, gasoline direct injection engine

Jisoo Shin et al.

Summary: This study investigates the flow enhancement effects of applying a swirl control valve in a high compression ratio, spray-guided, gasoline direct injection engine. The results show that the flow intensity can be strengthened by adjusting the swirl control valve angle, but the effect becomes insignificant when the angle increases beyond 45 degrees. Additionally, the study differentiates between swirl-dominant flow and tumble-dominant flow based on the relationship between maximum swirl and tumble ratios. The injection timing adjustment has an impact on the mixture formation.

CASE STUDIES IN THERMAL ENGINEERING (2022)

Article Energy & Fuels

Experimental investigation of the achieving methods and the working characteristics of a near-zero NOx emission turbocharged direct-injection hydrogen engine

Ling-zhi Bao et al.

Summary: This study focuses on achieving near-zero NOx emission with a large power and high thermal efficiency in a 2.0 L turbocharged direct-injection engine. By investigating the effects of variables such as excess air coefficient, start of injection timing, and injection pressure, the researchers were able to optimize the engine parameters and achieve the desired emission levels without the need for posttreatment equipment.
Article Energy & Fuels

Effects of control strategies for mixture activity and chemical reaction pathway coupled with exhaust gas recirculation on the performance of hydrogen-enriched natural-gas fueled spark ignition engine

Linxun Xu et al.

Summary: This study investigates the performance of a hydrogen-enriched natural gas engine and explores the impact of different control strategies. The results suggest that adopting a late direct injection strategy can improve the engine's volumetric efficiency and combustion efficiency.
Article Energy & Fuels

Experimental investigation of water injection and spark timing effects on combustion and emissions of a hybrid hydrogen-gasoline engine

Lijun Qian et al.

Summary: This study aimed to investigate the effects of water injection and spark timing on the performance of a hybrid hydrogen-gasoline engine. Experimental results showed that the spark timing and maximum brake torque varied with the addition of water and/or hydrogen. The combustion deterioration caused by water injection can be improved by adding hydrogen and the stability of spark timing can be enhanced.
Article Engineering, Mechanical

Comparative Study on the Prediction of City Bus Speed Between LSTM and GRU

Giyeon Hwang et al.

Summary: This study predicts the future speed of city buses by using a small amount of bus driving data and bus stop IDs. The LSTM-based model shows remarkable and practical prediction ability in terms of accuracy and time spent.

INTERNATIONAL JOURNAL OF AUTOMOTIVE TECHNOLOGY (2022)

Article Chemistry, Physical

Study of performance, combustion, and NOx emission behavior of an SI engine fuelled with ammonia/hydrogen blends at various compression ratio

M. H. Dinesh et al.

Summary: This paper investigates the effects of hydrogen blending on internal combustion engine performance under variable compression ratio and different speeds. The results show that increasing compression ratio and hydrogen fraction can improve combustion and fuel efficiency, but it also leads to higher exhaust temperature and increased NOx emissions.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2022)

Article Thermodynamics

Analysis of the exhaust hydrogen characteristics of high-compression ratio, ultra-lean, hydrogen spark-ignition engine using advanced regression algorithms

Seungmook Oh et al.

Summary: This study focused on the impact of hydrogen and NOx emissions on catalyst performance, and observed the influence of engine load and lambda value on hydrogen distribution. Regression analysis revealed strong correlations between exhaust hydrogen quantity and seven different parameters, with IMEPg and lambda value showing the highest importance in the overall analysis. The proposed prediction model plays a significant role in reducing NOx emissions and improving the thermal efficiency of hydrogen-fueled internal combustion engines.

APPLIED THERMAL ENGINEERING (2022)

Article Energy & Fuels

Development of a turbocharged direct-injection hydrogen engine to achieve clean, efficient, and high-power performance

Ling-zhi Bao et al.

Summary: This study implements a 2.0L turbocharged direct-injection hydrogen engine, which has the characteristics of clean, efficient, and high-power performance. By optimizing the engine parameters, the goals of achieving large power, high efficiency, and near-zero emissions can be realized.
Article Thermodynamics

Effects of direct water injection timings on knock suppression, combustion, and emission performance of high compression ratio hydrogen-enriched natural gas engine

Xiaoqi Wu et al.

Summary: The study found that adjusting the timing of water injection can effectively reduce knock in hydrogen-enriched NG engines and improve thermal efficiency. At the same time, NOx emissions decrease significantly, while HC and CO emissions increase slightly.

ENERGY CONVERSION AND MANAGEMENT (2021)

Review Chemistry, Applied

A review of water injection application on spark-ignition engines

Juye Wan et al.

Summary: This paper provides a comprehensive review of water injection applications on SI engines, discussing its effects on combustion and emissions as well as implementation methods. The study found that water injection can improve the thermal efficiency of SI engines and suppress emissions, but there are still limitations that need to be addressed for wider application.

FUEL PROCESSING TECHNOLOGY (2021)

Article Chemistry, Applied

The influence of hydrogen addition on the combustion characteristics of a common-rail CI engine fueled with waste cooking oil biodiesel/diesel blends

Mehmet Akcay et al.

Summary: The study showed that hydrogen assisted intake air has a significant impact on combustion characteristics of a diesel fuel-waste cooking oil biodiesel blend fueled CI engine, particularly on the premixed pilot fuel combustion phase. The findings suggest that hydrogen enrichment does not have an adverse effect on ringing intensity.

FUEL PROCESSING TECHNOLOGY (2021)

Article Chemistry, Physical

Computational characterization of hydrogen direct injection and nonpremixed combustion in a compression-ignition engine

Rafig Babayev et al.

Summary: This computational study evaluates the characteristics of H-2 direct-injection compression-ignition non-premixed combustion concept, focusing on hydrogen's unique features and the need to rethink optimization strategies for CI engines when using H-2 as fuel. The research contributes to the future development of DICI H-2 combustion engines by providing detailed characterization of the combustion cycle and highlighting key differences between CI non-premixed H-2 and diesel combustion.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2021)

Article Multidisciplinary Sciences

Dealing with uncertainty in agent-based models for short-term predictions

Le-Minh Kieu et al.

ROYAL SOCIETY OPEN SCIENCE (2020)

Review Engineering, Mechanical

Review of Recent After-Treatment Technologies for De-NOx Process in Diesel Engines

Byungchul Choi et al.

INTERNATIONAL JOURNAL OF AUTOMOTIVE TECHNOLOGY (2020)

Review Engineering, Chemical

110th Anniversary: Recent Progress and Future Challenges in Selective Catalytic Reduction of NO by H2 in the Presence of O2

Zhun Hu et al.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2019)

Article Chemistry, Physical

Fundamental characterization of backfire in a hydrogen fuelled spark ignition engine using CFD and experiments

Vipin Dhyani et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2019)

Article Chemistry, Applied

Mixed and autothermal reforming of methane with supported Ni catalysts with a core/shell structure

Ki-Moon Kang et al.

FUEL PROCESSING TECHNOLOGY (2012)

Article Chemistry, Physical

Hydrogen Lean-DeNOxas an Alternative to the Ammonia and Hydrocarbon Selective Catalytic Reduction (SCR)

Petros G. Savva et al.

CATALYSIS REVIEWS-SCIENCE AND ENGINEERING (2011)

Article Engineering, Environmental

Industrial NOx control via H2-SCR on a novel supported-Pt nanocatalyst

George G. Olympiou et al.

CHEMICAL ENGINEERING JOURNAL (2011)

Article Chemistry, Physical

An insight on hydrogen fuel injection techniques with SCR system for NOx reduction in a hydrogen-diesel dual fuel engine

N. Saravanan et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2009)