期刊
CHEMICAL ENGINEERING JOURNAL
卷 476, 期 -, 页码 -出版社
ELSEVIER SCIENCE SA
DOI: 10.1016/j.cej.2023.146910
关键词
Graphene-based material; 2D materials; Electrooxidation; Intermittent current; Capacitance
Borophene and hexagonal boron nitride-modified graphene sponge anode and N-doped graphene sponge cathode were used for electrochemical degradation of persistent organic contaminants. The use of intermittent current and the functionalization of graphene improved the contaminant removal efficiency while reducing energy consumption.
Borophene (Bph) and hexagonal boron nitride (hBN)-modified graphene sponge anode coupled to N-doped graphene sponge cathode were applied for electrochemical degradation of persistent organic contaminants using intermittent current. Three different ON-OFF pulse cycles were tested using low-conductivity supporting electrolyte in flow-through mode. Functionalization of the reduced graphene oxide (RGO) with Bph and hBN improved the ability of the double layer to store electrical charge, thus maintaining the generation of H2O2, O3, and & sdot;OH even during the OFF cycles. Both anodes tested showed enhanced contaminant removal during shorter OFF periods (e.g. 52.5 s/52.s and 75 s/30 s ON/OFF), due to the improved retention of anode charge during the shorter OFF stages. Electrochemical removal of the target contaminants required 24 kWh m- 3 in continuous current mode for both hBN-RGO and Bph-RGO anodes at 231 A/m- 2, which was lowered to 11.7 and 13.5 kWh m- 3 respectively, using ON-OFF pulse cycles. Electrochemical degradation pathways were elucidated in both systems using carbamazepine as a representative persistent contaminant. Flow-through reactors with both Bph-and hBN-RGO anodes removed >= 60 % of the target contaminants in a single pass using continuous current, whereas intermittent current led to somewhat decreased removal efficiencies (43-58 %) due to the scavenging effect of the wastewater matrix. Thus, halving the current ON time led to less than 20 % decrease in the removal efficiencies due to the capacitive properties of RGO. Given that switching to intermittent current decreased the energy consumption from 9.3 kWh m- 3 to 4.4 kWh m- 3 (Bph-RGO anode) and from 6.9 kWh m- 3 to 3.6 kWh m- 3 (hBN-RGO anode), higher removal of the target contaminants can be achieved by coupling sequential reactors in the intermittent current mode.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据