Taguchi optimization and analysis of variance for thermoelectric generators with forced convection air cooling

In recent years, humanity has experienced the effects of using unsustainable energy sources that pollute the environment while being inefficient. Most of the primary energy input used in energy conversion processes is lost in the form of heat. Thermoelectric generators (TEGs) have the potential to recover some of this wasted heat; however, their low energy conversion efficiency needs to be addressed. Previous literature has shown effective optimization of thermoelectric generation systems through statistical tools such as the Taguchi method that optimized all the parameters that affect the outcome of the system. To this date, no research has considered wind speed for convection heat transfer as one of the optimizable parameters. This study aims to optimize the operating conditions of commercially available TEGs that are cooled by forced convection simulating naturally occurring wind speeds and operate under low-quality waste heat temperatures to improve the TEG performance further. Two commercially available TEGs are optimized via the Taguchi method. The Taguchi method is implemented with three parameters and three levels, making an L-9 orthogonal array. The objective function is the maximum output power. The optimized parameters are the hot side temperature, the heat sink size, and the wind airspeed. Analysis of variance (ANOVA) is used alongside the Taguchi orthogonal array for the statistical analysis of the results. The optimization results show that the hot side temperature is the most influential parameter to the output power. In addition, the change in the heat sink size also significantly influences the output power, whereas the impact of the wind speed is not as significant. In addition, interaction analysis between the parameters is performed. The Taguchi method yields satisfactory optimization results. The optimized system yields 0.65 W of power at 140 degrees C hot side temperature, Model K402 heat sink, and 3.7 m(.)s(-1) wind speed. The influence of the air velocity of 1.73% is minimal on the output power compared to the hot side temperature, with a level of influence of 75.67% and a heat sink size of 22.43% for the shorter module. The results also show that the TEG with a smaller TE leg height yields the best output power at low load resistance ranging from 0.2 Omega to 2 Omega, as the TEG with a taller TE leg renders better performance at higher load resistance ranging from 3 Omega to 16 Omega at the optimal conditions. The results show that the hot side temperature remains the most important parameter in the optimization process. Furthermore, convection cooling from naturally occurring winds has a minimal but positive effect on the output of the presented TEG system.

Automated summary

In recent years, the use of unsustainable and inefficient energy sources has led to environmental pollution. Thermoelectric generators (TEGs) have the potential to recover wasted heat, but their energy conversion efficiency needs improvement. This study optimizes commercially available TEGs by considering hot side temperature, heat sink size, and wind airspeed. The results show that hot side temperature has the greatest influence on the output power, while the impact of wind speed is minimal.