☆ 4.7 Article

Impact performance on industrial scalable graphene reinforcement composites

AEROSPACE SCIENCE AND TECHNOLOGY (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Engineering, Aerospace

Compression-after-impact effect on postbuckling behavior of thermoplastic composite laminated plates

Taoye Lu et al.

Summary: This paper investigates the postbuckling behavior of carbon fiber reinforced thermoplastic composite laminated plates under uni-axial compression-after-impact and proposes a physical model that considers both internal damage and local geometric imperfection caused by impact. Experimental data is compared with finite element numerical results to validate the method. The numerical results show that initial geometric imperfection, impact point position, plate width-to-thickness ratio, and boundary conditions significantly influence the postbuckling load-deflection curves of the laminated plates under CAI.

AEROSPACE SCIENCE AND TECHNOLOGY (2022)

添加到收藏夹

Article Engineering, Manufacturing

Comparison of impact resistance of carbon fibre composites with multiple ultra-thin CNT, aramid pulp, PBO and graphene interlayers

Yunsen Hu et al.

Summary: This study compared the impact properties of carbon fiber reinforced polymer (CFRP) laminates with different fillers. The results showed that ultra-thin multi-wall carbon nanotubes, Aramid pulp micro/nano-fibers, and poly (pphenylene-2,6-benzobisoxazole) fibers significantly reduced impact damage, while multi-layer graphene did not have this effect. Furthermore, these ultra-thin interlayers had no adverse effect on compressive properties and even improved the residual compressive strength without any impact damage.

COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2022)

添加到收藏夹

Article Engineering, Manufacturing

Improving the delamination resistance and impact damage tolerance of carbon fibre-epoxy composites using multi-scale fibre toughening

Anil R. Ravindran et al.

Summary: This study investigates the multi-scale toughening mechanisms for enhancing the fracture toughness, impact damage resistance, and compression-after-impact strength of carbon fiber-epoxy composite laminates by using carbon nano- and micro-fillers. It was found that a synergistic increase in mode II toughness was achieved when carbon nanofibers were combined with short carbon fibers, leading to improvements in impact damage resistance and CAI strength. The key toughening mechanisms provided by the fillers were identified through analyses and scanning electron microscopy.

COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2021)

添加到收藏夹

Article Engineering, Civil

In-plane compression response of woven CFRP composite after low-velocity impact: Modelling and experiment

Bin Yang et al.

Summary: A finite element model was developed to predict the low-velocity impact and compression-after-impact behavior of woven carbon fiber reinforced polymer composites. Experimental results validated the accuracy of the model, and detailed microscopic damage analysis was conducted on the composites. The effects of impactor diameter and impact energy on impact damage and CAI behaviors were discussed based on the model.

THIN-WALLED STRUCTURES (2021)

添加到收藏夹

Article Materials Science, Characterization & Testing

Cryogenic mechanical properties of graphene oxide/epoxy nanocomposites: Influence of graphene oxide with different oxidation degrees

Jie Fan et al.

Summary: The study showed that as the oxidation degree of graphene oxide increased, it exhibited better dispersion in the matrix and improved interfacial interactions with epoxy resin, leading to enhanced mechanical properties of the nanocomposites. The tensile properties of the GO/epoxy nanocomposites at room temperature and liquid nitrogen temperature increased with the GO oxidation degree, reaching the highest performance at an appropriate oxidation degree. The toughening mechanisms of GO for epoxy nanocomposites at room temperature and liquid nitrogen temperature were analyzed and showed significant differences.

POLYMER TESTING (2021)

添加到收藏夹

Article Engineering, Manufacturing

Simultaneous enhancement of mechanical and electrical/thermal properties of carbon fiber/polymer composites via SiC nanowires/graphene hybrid nanofillers

Tiyuan Wang et al.

Summary: By electrophoretic deposition of SiC nanowires and in-situ grafting of graphene via chemical vapor deposition, carbon fiber/epoxy composites with hybrid nanofillers show significantly improved interlaminar shear strength, mechanical properties, and through-thickness thermal conductivity.

COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2021)

添加到收藏夹

Article Materials Science, Composites

Effect of different lateral dimension graphene oxide sheets on the interface of carbon fiber reinforced polymer composites

Baowei Qiu et al.

Summary: The study demonstrates that graphene oxide (GO) sheets with smaller lateral dimensions are more advantageous in enhancing the interfacial properties of carbon fiber reinforced polymers (CFRPs). This is attributed to the presence of a larger number of functional groups and higher roughness on the surface of CFs modified by smaller GO sheets, leading to higher surface energy which enhances chemical bonding and mechanical interlocking at the matrix-fiber interface.

COMPOSITES SCIENCE AND TECHNOLOGY (2021)

添加到收藏夹

Article Mechanics

On the crashworthiness behaviour of a composite fuselage Sub-floor component

A. Riccio et al.

COMPOSITE STRUCTURES (2020)

添加到收藏夹

Article Engineering, Multidisciplinary

Impact and post-impact properties of multiscale carbon fiber composites interleaved with carbon nanotube sheets

W. Xin et al.

COMPOSITES PART B-ENGINEERING (2020)

添加到收藏夹

Article Engineering, Multidisciplinary

Model updating of uncertain parameters of carbon/epoxy composite plates using digital image correlation for full-field vibration measurement

M. Cuadrado et al.

MEASUREMENT (2020)

添加到收藏夹

Article Chemistry, Physical

Carbon nanotube/carbon composite fiber with improved strength and electrical conductivity via interface engineering

Songlin Zhang et al.

CARBON (2019)

添加到收藏夹

Article Engineering, Manufacturing

Improving impact resistance and residual compressive strength of carbon fibre composites using un-bonded non-woven short aramid fibre veil

Bingyan Yuan et al.

COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2019)

添加到收藏夹

Article Materials Science, Composites

Experimental investigation on graphene oxides coated carbon fibre/epoxy hybrid composites: Mechanical and electrical properties

Lokasani Bhanuprakash et al.

COMPOSITES SCIENCE AND TECHNOLOGY (2019)

添加到收藏夹

Article Engineering, Multidisciplinary

Relations between intralaminar micromechanisms and translaminar fracture behavior of unidirectional FRP supported by experimental micromechanics

Sandip Haldar et al.

COMPOSITES PART B-ENGINEERING (2019)

添加到收藏夹

Article Engineering, Manufacturing

Mechanical properties and strain monitoring of glass-epoxy composites with graphene-coated fibers

Haroon Mahmood et al.

COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2018)

添加到收藏夹

Article Engineering, Manufacturing

Micro-configuration controlled interfacial adhesion by grafting graphene oxide onto carbon fibers

Xiaomin Yuan et al.

COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2018)

添加到收藏夹

Article Engineering, Multidisciplinary

Effects of hydrazine reduced graphene oxide on the inter-laminar fracture toughness of woven carbon fiber/epoxy composite

Nitai Chandra Adak et al.

COMPOSITES PART B-ENGINEERING (2018)

添加到收藏夹

Article Materials Science, Composites

Enhanced interfacial interactions of carbon fiber reinforced PEEK composites by regulating PEI and graphene oxide complex sizing at the interface

Junlin Chen et al.

COMPOSITES SCIENCE AND TECHNOLOGY (2018)

添加到收藏夹

Article Materials Science, Characterization & Testing

Experimental study of the influence of thickness and ply-stacking sequence on the compression after impact strength of carbon fibre reinforced epoxy laminates

M. A. Caminero et al.

POLYMER TESTING (2018)

添加到收藏夹

Article Engineering, Multidisciplinary

Investigation of the effect of stacking sequence on low velocity impact response and damage formation in hybrid composite pipes under internal pressure. A comparative study

Lokman Gemi

COMPOSITES PART B-ENGINEERING (2018)

添加到收藏夹

Article Engineering, Mechanical

Low-velocity impact of woven CFRE composites under different temperature levels

U. A. Khashaba et al.

INTERNATIONAL JOURNAL OF IMPACT ENGINEERING (2017)

添加到收藏夹

Article Materials Science, Characterization & Testing

Impact resistance of hybrid glass fiber reinforced epoxy/nanoclay composite

Ahmad Rafiq et al.

POLYMER TESTING (2017)

添加到收藏夹

Article Materials Science, Composites

Fracture related mechanical properties of low and high graphene reinforcement of epoxy nanocomposites

Nikolaos D. Alexopoulos et al.

COMPOSITES SCIENCE AND TECHNOLOGY (2017)

添加到收藏夹

Article Engineering, Multidisciplinary

Residual strength evaluation after impact tests in extreme temperature conditions. New equipment for CAI tests

Valentina Lopresto et al.

COMPOSITES PART B-ENGINEERING (2017)

添加到收藏夹

Article Engineering, Manufacturing

Computational micromechanics of the transverse and shear behavior of unidirectional fiber reinforced polymers including environmental effects

F. Naya et al.

COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2017)

添加到收藏夹

Article Engineering, Multidisciplinary

Mechanical properties of carbon nanotubes based polymer composites

M. Tarfaoui et al.

COMPOSITES PART B-ENGINEERING (2016)

添加到收藏夹

Article Mechanics

Experimental study of the impactor mass effect on the low velocity impact of carbon/epoxy woven laminates

J. A. Artero-Guerrero et al.

COMPOSITE STRUCTURES (2015)

添加到收藏夹

Article Engineering, Multidisciplinary

Mechanical and electrical properties of carbon fiber composites with incorporation of graphene nanoplateletsat the fiber-matrix interphase

Wenzhen Qin et al.

COMPOSITES PART B-ENGINEERING (2015)

添加到收藏夹

Article Materials Science, Coatings & Films

Influence of graphene oxide coatings on carbon fiber by ultrasonically assisted electrophoretic deposition on its composite interfacial property

Chao Deng et al.

SURFACE & COATINGS TECHNOLOGY (2015)

添加到收藏夹

Article Engineering, Manufacturing

Experimental analysis of normal and oblique high velocity impacts on carbon/epoxy tape laminates

J. Pernas-Sanchez et al.

COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2014)

添加到收藏夹

Article Materials Science, Composites

Impact velocity effect on the delamination of woven carbon-epoxy plates subjected to low-velocity equienergetic impact loads

H. Zabala et al.

COMPOSITES SCIENCE AND TECHNOLOGY (2014)

添加到收藏夹

Article Polymer Science

Advantages and disadvantages of the addition of graphene nanoplatelets to epoxy resins

S. G. Prolongo et al.

EUROPEAN POLYMER JOURNAL (2014)

添加到收藏夹

Article Mechanics

Analysis of high velocity impacts of steel cylinders on thin carbon/epoxy woven laminates

D. Varas et al.

COMPOSITE STRUCTURES (2013)

添加到收藏夹

Article Mechanics

The effect of stacking sequence on the impact and post-impact behavior of woven/knit fabric glass/epoxy hybrid composites

Alaattin Aktas et al.

COMPOSITE STRUCTURES (2013)

添加到收藏夹

Article Engineering, Manufacturing

Failure analysis of CFRP laminates subjected to compression after impact: FE simulation using discrete interface elements

Samuel Rivallant et al.

COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2013)

添加到收藏夹

Article Nanoscience & Nanotechnology

Interfacial Microstructure and Properties of Carbon Fiber Composites Modified with Graphene Oxide

Xiaoqing Zhang et al.

ACS APPLIED MATERIALS & INTERFACES (2012)

添加到收藏夹

Article Materials Science, Composites

Effects of ply clustering in laminated composite plates under low-velocity impact loading

E. V. Gonzalez et al.

COMPOSITES SCIENCE AND TECHNOLOGY (2011)

添加到收藏夹

Article Materials Science, Composites

Impact and after-impact properties of carbon fibre reinforced composites enhanced with multi-wall carbon nanotubes

V. Kostopoulos et al.

COMPOSITES SCIENCE AND TECHNOLOGY (2010)

添加到收藏夹

Article Materials Science, Composites

Low-velocity impact damage on dispersed stacking sequence laminates. Part I: Experiments

C. S. Lopes et al.

COMPOSITES SCIENCE AND TECHNOLOGY (2009)

添加到收藏夹

Article Materials Science, Composites

A new composite structure impact performance assessment program

P Feraboli et al.

COMPOSITES SCIENCE AND TECHNOLOGY (2006)

添加到收藏夹

Article Materials Science, Composites

Compression after impact of thin composite laminates

S Sanchu-Saez et al.

COMPOSITES SCIENCE AND TECHNOLOGY (2005)

添加到收藏夹

Article Engineering, Aerospace

Enhanced evaluation of the low-velocity impact response of composite plates

P Feraboli et al.

AIAA JOURNAL (2004)

添加到收藏夹

Review Engineering, Aerospace

Impact on composite structures

GAO Davies et al.

AERONAUTICAL JOURNAL (2004)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.