☆ 4.4 Article

Analysis of Changes in Soot Content in Engine Oils under Operating Conditions

LUBRICANTS (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Engineering, Chemical

Effect of Zinc Dialkyl Dithiophosphate Replenishment on Tribological Performance of Heavy-Duty Diesel Engine Oil

A. Al Sheikh Omar et al.

Summary: Soot is a major contaminant that affects oil performance and increases the need for oil changes. The concentration of additives in engine oil can be influenced by additive depletion over time and additive adsorption on soot particles. This study investigates the effect of replenishing the antiwear additive, ZDDP, on the tribological performance of oil in the presence of soot and after removing soot. The results show that reclaiming the used oil by removing soot is not as effective as using fresh oil, but adding a small amount of ZDDP can improve the performance of the reclaimed oil.

TRIBOLOGY LETTERS (2022)

添加到收藏夹

Article Energy & Fuels

Comparative study of pilot-main injection timings and diesel/ethanol binary blends on combustion, emission and microstructure of particles emitted from diesel engines

Jun Cong Ge et al.

Summary: This study investigates the application of anhydrous ethanol-diesel blends in a diesel engine, showing that the addition of ethanol can improve the trade-off relationship between nitrogen oxides and smoke emissions while reducing particle diameter.

FUEL (2022)

添加到收藏夹

Article Engineering, Multidisciplinary

Design of a tribotechnical diagnostics model for determining the technical condition of an internal combustion engine during its life cycle

Jan Furch et al.

Summary: This paper proposes a model for tribotechnical diagnostics that can assess the technical condition of an internal combustion engine. The model is applied to monitor an internal combustion engine in agricultural equipment throughout its life cycle. The paper provides detailed descriptions of the methods used and their measurement results, as well as their evaluation and comparison.

EKSPLOATACJA I NIEZAWODNOSC-MAINTENANCE AND RELIABILITY (2022)

添加到收藏夹

Article Thermodynamics

Effect of injection timing on combustion, emission and particle morphology of an old diesel engine fueled with ternary blends at low idling operations

Jun Cong Ge et al.

Summary: This study investigates the combustion, engine performance, and emission characteristics of an old diesel engine fueled with DPE ternary blended fuels under low idling conditions. The results show that increasing ethanol concentrations in DPE blends lead to increased fuel consumption and HC emissions, while reducing NOx and smoke emissions.

ENERGY (2022)

添加到收藏夹

Article Chemistry, Physical

Carbonaceous soot dispersion characteristic and mechanism in lubricant with effect of dispersants by molecular dynamics simulation and experimental studies

Junqin Shi et al.

Summary: The dispersion behavior and mechanism of soot agglomerate in a lubricating system were investigated through molecular dynamics (MD) simulation and experimental study. The findings showed that the dispersant concentration had a significant influence on the dispersion characteristics of carbonaceous soot, and this influence varied under different conditions.

CARBON (2022)

添加到收藏夹

Article Engineering, Chemical

Effects of Dispersant and ZDDP Additives on Fretting Wear

A. Kontou et al.

Summary: The presence of base oil reduces fretting wear, while the combination of ZDDP anti-wear additive and Succinimide dispersant provides significant protection against fretting wear.

TRIBOLOGY LETTERS (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Study of the Effect of Physicochemical Degradation and Contamination of Motor Oils on Their Lubricity

Marie Sejkorova et al.

Summary: The experimental results indicated that current motor oils have excellent lubricity, which they maintain throughout their life.

COATINGS (2021)

添加到收藏夹

Article Engineering, Multidisciplinary

Internal combustion engine diagnostics using statistically processed Wiebe function

Jan Famfulik et al.

Summary: This article introduces an indirect diagnostic method to assess the variability of the combustion process of an internal combustion engine by using the variability of released heat and heat release rate. The Wiebe function and statistical analysis are used to calculate parameters and determine upper and lower limits for more accurate evaluation of heat generation. The assessment of variability is more complex than using a single integral indicator, providing a comprehensive understanding of the heat release process.

EKSPLOATACJA I NIEZAWODNOSC-MAINTENANCE AND RELIABILITY (2021)

添加到收藏夹

Article Engineering, Mechanical

Chemical and physical assessment of engine oils degradation and additive depletion by soot

A. Al Sheikh Omar et al.

Summary: Soot contamination in engine oil leads to increased wear of engine components and affects the oil change intervals. Removing soot can extend the service life of engine oil, but may reduce the efficiency of additives.

TRIBOLOGY INTERNATIONAL (2021)

添加到收藏夹

Article Energy & Fuels

Optimization of palm oil biodiesel blends and engine operating parameters to improve performance and PM morphology in a common rail direct injection diesel engine

Jun Cong Ge et al.

FUEL (2020)

添加到收藏夹

Article Engineering, Mechanical

FTIR analysis and monitoring of used synthetic oils operated under similar driving conditions

Artur Wolak et al.

FRICTION (2020)

添加到收藏夹

Article Energy & Fuels

Multiscale characterization of exhaust and crankcase soot extracted from heavy-duty diesel engine and implications for DPF ash

Sujay Bagi et al.

FUEL (2020)

添加到收藏夹

Article Energy & Fuels

Impact of Diesel Engine Oil Additives-Soot Interactions on Physiochemical, Oxidation, and Wear Characteristics of Soot

Kimaya Vyavhare et al.

ENERGY & FUELS (2019)

添加到收藏夹

Article Engineering, Chemical

Engine Oils in the Field: A Comprehensive Chemical Assessment of Engine Oil Degradation in a Passenger Car

Nicole Doerr et al.

TRIBOLOGY LETTERS (2019)

添加到收藏夹

Article Engineering, Mechanical

An Alternative Procedure to Quantify Soot in Engine Oil by Ultraviolet-Visible Spectroscopy

Vicente Macian et al.

TRIBOLOGY TRANSACTIONS (2019)

添加到收藏夹

Proceedings Paper Engineering, Manufacturing

About eco-driving, genesis, challenges and benefits, application possibilities

Jacek Caban et al.

13TH INTERNATIONAL SCIENTIFIC CONFERENCE ON SUSTAINABLE, MODERN AND SAFE TRANSPORT (TRANSCOM 2019) (2019)

添加到收藏夹

Article Energy & Fuels

Reducing volatile organic compound emissions from diesel engines using canola oil biodiesel fuel and blends

Jun Cong Ge et al.

FUEL (2018)

添加到收藏夹

Article Energy & Fuels

Study on tribological behavior of biodiesel - Diethyl ether (B20A4) blend for long run test on compression ignition engine

Sajan Chourasia et al.

FUEL (2018)

添加到收藏夹

Article Engineering, Chemical

Influence of Dispersant and ZDDP on Soot Wear

A. Kontou et al.

TRIBOLOGY LETTERS (2018)

添加到收藏夹

Review Materials Science, Coatings & Films

Contemporary challenges of soot build-up in IC engine and their tribological implications

L. B. Abdulqadir et al.

TRIBOLOGY-MATERIALS SURFACES & INTERFACES (2018)

添加到收藏夹

Article Engineering, Mechanical

The effect of soot and diesel contamination on wear and friction of engine oil pump

F. Motamen Salehi et al.

TRIBOLOGY INTERNATIONAL (2017)

添加到收藏夹

Article Engineering, Mechanical

Synthesis and utilization of non-metallic detergent/dispersant and antioxidant additives for lubricating engine oil

Amal M. Nassar et al.

TRIBOLOGY INTERNATIONAL (2016)

添加到收藏夹

Article Engineering, Mechanical

Characterisation of soot in oil from a gasoline direct injection engine using Transmission Electron Microscopy

A. La Rocca et al.

TRIBOLOGY INTERNATIONAL (2015)

添加到收藏夹

Article Engineering, Mechanical

Thermogravimetric analysis of carbon black and engine soot-Towards a more robust oil analysis method

Arne Bredin et al.

TRIBOLOGY INTERNATIONAL (2011)

添加到收藏夹

Article Engineering, Mechanical

Effect of diesel soot contaminated oil on engine wear

Sam George et al.

WEAR (2007)

添加到收藏夹

Article Engineering, Mechanical

FTIR condition monitoring of in-service lubricants: Ongoing developments and future perspectives

F. R. Van De Voort et al.

TRIBOLOGY TRANSACTIONS (2006)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.