4.8 Article

Synergistic effects improve thermoelectric properties of zone-melted n-type Bi2Te2.7Se0.3

相关参考文献

注意:仅列出部分参考文献,下载原文获取全部文献信息。
Article Engineering, Environmental

Enhanced phonon scattering and thermoelectric performance for N-type Bi2Te2.7Se0.3 through incorporation of conductive polyaniline particles

Shuhuan Yang et al.

Summary: This study investigates the effect of incorporating conductive polyaniline nanoparticles on the thermoelectric performance of Bi2Te3-based alloys. It is found that the inclusion of polyaniline nanoparticles can reduce the lattice thermal conductivity of the composite system by increasing phonon scattering and enhance the thermopower by inducing energy-dependent carrier scattering at the inorganic/organic boundaries. The composite sample with 1.5 wt% PANI inclusions achieves the maximum figure of merit Zmax = 3.57 x 10-3 K-1 (300 K) and the maximum dimensionless figure of merit ZTmax = 1.22 (345 K), which are 42% and 46% higher than those of pristine Bi2Te2.7Se0.3, respectively, demonstrating the effectiveness of incorporating nanophase polyaniline to enhance the thermoelectric performance.

CHEMICAL ENGINEERING JOURNAL (2023)

Letter Materials Science, Multidisciplinary

Improved thermoelectric properties of zone-melted p-type bismuth-telluride-based alloys for power generation

Ren-Shuang Zhai et al.

RARE METALS (2022)

Review Chemistry, Multidisciplinary

Insights into Low Thermal Conductivity in Inorganic Materials for Thermoelectrics

Tanmoy Ghosh et al.

Summary: Efficient manipulation of thermal conductivity and understanding of microscopic mechanisms of phonon scattering are crucial for achieving high thermoelectric performance. Various strategies including nanostructural modifications, introduction of phonon scattering centers, and manipulation of defects and disorder have been developed to lower thermal conductivity in crystalline solids. Intrinsic lattice distortion and lattice anharmonicity originating from mechanisms such as rattling and bonding heterogeneity have recently gained popularity. This Perspective outlines the role of chemical bonding and structural chemistry in controlling thermal transport in high-performance thermoelectric materials.

JOURNAL OF THE AMERICAN CHEMICAL SOCIETY (2022)

Article Chemistry, Multidisciplinary

Mediating Point Defects Endows n-Type Bi2Te3 with High Thermoelectric Performance and Superior Mechanical Robustness for Power Generation Application

Yu-Ke Zhu et al.

Summary: In this work, the thermoelectric and mechanical properties of n-type Bi2Te3 alloy were enhanced by point defect configuration using S/Te/I defects engineering. When combined with p-type BiSbTe, the fabricated module showed competitive conversion efficiency. The work revealed a novel mechanism of point defect reconfiguration in synergistic enhancement of thermoelectric and mechanical properties, which may be applicable to other thermoelectric systems.
Article Chemistry, Inorganic & Nuclear

Enhancing the thermoelectric performance of n-type Bi2Te2.7Se0.3 through the incorporation of Ag9AlSe6 inclusions

Tao Chen et al.

Summary: The incorporation of Ag9AlSe6 phase into BTS can significantly reduce lattice thermal conductivity and enhance the Seebeck coefficient, leading to an improvement in thermoelectric performance.

INORGANIC CHEMISTRY FRONTIERS (2022)

Article Chemistry, Physical

Enhanced power factor and thermoelectric performance for n-type Bi2Te2.7Se0.3 based composites incorporated with 3D topological insulator nanoinclusions

Bushra Jabar et al.

Summary: Incorporation of nano-sized 3D topological insulator Bi2Se3 in n-type Bi2Te2.7Se0.3 alloy leads to improved electron mobility and electrical conductivity, as well as enhanced Seebeck coefficient due to energy dependent carrier scattering. Additionally, the inclusion of 3D-TI nanoinclusions results in enhanced phonon scattering, leading to a significant increase in power factor and decrease in total thermal conductivity of the material, ultimately increasing the figure of merit ZT.

NANO ENERGY (2021)

Article Materials Science, Multidisciplinary

Ultralow lattice thermal conductivity and enhanced power generation efficiency realized in Bi2Te2.7Se0.3/Bi2S3 nanocomposites

Yu-Ke Zhu et al.

Summary: Introducing ultrafine bismuth sulfide nanograins and multiscale lattice defects successfully lowered the lattice thermal conductivity and increased the electrical conductivity, improving the thermoelectric performance close to Clarke's limitation. The small device fabricated using a specific sample achieved a high direct conversion efficiency, and the inverse changes in hardness and Young's modulus with Bi2S3 content were explored for potential improvements in mechanical and thermoelectric properties in thermoelectric materials.

ACTA MATERIALIA (2021)

Article Nanoscience & Nanotechnology

Achieving High Thermoelectric Performance of n-Type Bi2Te2.79Se0.21 Sintered Materials by Hot-Stacked Deformation

Chenglong Xiong et al.

Summary: The hot-stacked deformation technique effectively improved the thermoelectric properties of n-type Bi2Te2.79Se0.21 materials by maintaining high grain alignment, optimizing carrier concentration, and suppressing lattice thermal conductivity due to dense grain boundaries and dislocations, resulting in a significantly higher zT value.

ACS APPLIED MATERIALS & INTERFACES (2021)

Article Materials Science, Multidisciplinary

Improved thermoelectric performance in n-type BiTe facilitated by defect engineering

Hao Zhu et al.

Summary: By tuning the carrier concentration through chemical doping, significant enhancement in thermoelectric performance of n-type Bi1-xSbxTe compounds is achieved, with a remarkable increase in Seebeck coefficient and gradual decrease in electronic thermal conductivity as Sb content increases, resulting in improved thermoelectric figure of merit. Moreover, the simultaneous optimization of electrical and thermal transport properties leads to a shift in the peak temperature of the figure of merit towards lower temperatures with increasing Sb content in Bi1-xSbxTe, making it a potential alternative to bismuth telluride for near-room-temperature thermoelectric applications.

RARE METALS (2021)

Article Nanoscience & Nanotechnology

Realize High Thermoelectric Properties in n-Type Bi2Te2.7Se0.3/Y2O3 Nanocomposites by Constructing Heterointerfaces

Qiujun Hu et al.

Summary: In this study, n-type Bi2Te2.7Se0.3 based thermoelectric materials incorporated with nanosized Y2O3 were prepared and studied, leading to significantly improved thermoelectric performance due to the multiscale interface modifications induced by the Y2O3 nanoparticles. The addition of Y2O3 NPs effectively reduced the thermal conductivity, increased the hardness, and maintained excellent thermoelectric properties in the entire operating temperature range. The strategy of high-density heterogeneous interfaces implemented by Y2O3 NP addition provides a feasible pathway for fabricating high-performance thermoelectric materials with optimized properties.

ACS APPLIED MATERIALS & INTERFACES (2021)

Article Engineering, Environmental

Synergistic effects of B-In codoping in zone-melted Bi0.48Sb1.52Te3-based thermoelectric

Hongxiang Wang et al.

Summary: By doping with B and In, the power factor and ZT values of Bi0.48Sb1.52Te3 materials have been simultaneously improved, leading to effective suppression of thermal conductivity.

CHEMICAL ENGINEERING JOURNAL (2021)

Article Chemistry, Multidisciplinary

Point Defect Engineering: Co-Doping Synergy Realizing Superior Performance in n-Type Bi2Te3 Thermoelectric Materials

Bin Zhu et al.

Summary: This study enhances the thermoelectric properties of n-type Bi2Te3 materials through Cl and W co-doping, achieving excellent ZT values within a certain temperature range and high efficiency when combined with p-type Bi2Te3 materials, providing an important direction for the development of n-type Bi2Te3 materials.
Article Chemistry, Physical

Synergistic Texturing and Bi/Sb-Te Antisite Doping Secure High Thermoelectric Performance in Bi0.5Sb1.5Te3-Based Thin Films

Ming Tan et al.

Summary: By carefully tuning the deposition temperature to enhance the texture and induce Bi/Sb-Te antisite doping in Bi0.5Sb1.5Te3 thin films, a high ZT value of approximately 1.5 was achieved, showing great potential for practical applications.

ADVANCED ENERGY MATERIALS (2021)

Article Nanoscience & Nanotechnology

Phonon Engineering for Thermoelectric Enhancement of p-Type Bismuth Telluride by a Hot-Pressing Texture Method

Hongxiang Wang et al.

ACS APPLIED MATERIALS & INTERFACES (2020)

Review Chemistry, Multidisciplinary

Advanced Thermoelectric Design: From Materials and Structures to Devices

Xiao-Lei Shi et al.

CHEMICAL REVIEWS (2020)

Review Chemistry, Multidisciplinary

Tuning Optimum Temperature Range of Bi2Te3-Based Thermoelectric Materials by Defect Engineering

Qi Zhang et al.

CHEMISTRY-AN ASIAN JOURNAL (2020)

Article Chemistry, Inorganic & Nuclear

Characterization and Decomposition of the Natural van der Waals SnSb2Te4 under Compression

Juan A. Sans et al.

INORGANIC CHEMISTRY (2020)

Article Chemistry, Multidisciplinary

Leveraging Deep Levels in Narrow Bandgap Bi0.5Sb1.5Te3for Record-HighzTaveNear Room Temperature

Lipeng Hu et al.

ADVANCED FUNCTIONAL MATERIALS (2020)

Article Chemistry, Multidisciplinary

Realizing record high performance in n-type Bi2Te3-based thermoelectric materials

Bin Zhu et al.

ENERGY & ENVIRONMENTAL SCIENCE (2020)

Review Chemistry, Multidisciplinary

Complex Band Structures and Lattice Dynamics of Bi2Te3-Based Compounds and Solid Solutions

Teng Fang et al.

ADVANCED FUNCTIONAL MATERIALS (2019)

Article Nanoscience & Nanotechnology

Evolution of the Intrinsic Point Defects in Bismuth Telluride-Based Thermoelectric Materials

Qi Zhang et al.

ACS APPLIED MATERIALS & INTERFACES (2019)

Article Chemistry, Multidisciplinary

Tunable Optimum Temperature Range of High-Performance Zone Melted Bismuth-Telluride-Based Solid Solutions

Renshuang Zhai et al.

CRYSTAL GROWTH & DESIGN (2018)

Article Materials Science, Multidisciplinary

Control of donor-like effect in V2VI3 polycrystalline thermoelectric materials

Lipeng Hu et al.

MATERIALS RESEARCH BULLETIN (2018)

Review Materials Science, Multidisciplinary

Recent advances in high-performance bulk thermoelectric materials

X. Shi et al.

INTERNATIONAL MATERIALS REVIEWS (2016)

Review Chemistry, Multidisciplinary

New Insights into Intrinsic Point Defects in V2VI3 Thermoelectric Materials

Tiejun Zhu et al.

ADVANCED SCIENCE (2016)

Article Chemistry, Inorganic & Nuclear

Lead-free tin chalcogenide thermoelectric materials

Min Zhou et al.

INORGANIC CHEMISTRY FRONTIERS (2016)

Review Materials Science, Multidisciplinary

Thermoelectric power factor: Enhancement mechanisms and strategies for higher performance thermoelectric materials

Arash Mehdizadeh Dehkordi et al.

MATERIALS SCIENCE & ENGINEERING R-REPORTS (2015)

Article Chemistry, Physical

Electronic structure of SnSb2Te4 and PbSb2Te4 topological insulators

T. V. Menshchikova et al.

APPLIED SURFACE SCIENCE (2013)

Article Multidisciplinary Sciences

High-performance bulk thermoelectrics with all-scale hierarchical architectures

Kanishka Biswas et al.

NATURE (2012)

Article Engineering, Electrical & Electronic

Improved Thermoelectric Performance of p-Type Bismuth Antimony Telluride Bulk Alloys Prepared by Hot Forging

J. J. Shen et al.

JOURNAL OF ELECTRONIC MATERIALS (2011)

Review Chemistry, Multidisciplinary

Enhancement of Thermoelectric Figure-of-Merit by a Bulk Nanostructuring Approach

Yucheng Lan et al.

ADVANCED FUNCTIONAL MATERIALS (2010)