☆ 4.7 Article

On the modified kinetics model describing the dynamic recrystallization behavior during hot deformation of Incoloy 925

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Materials Science, Multidisciplinary

Constitutive analysis of stress-strain curves in dynamic softening of high Nb- and N-containing austenitic stainless-steel biomaterial

Glaucia Adriane de Sousa Sulzbach et al.

Summary: This research characterizes the dynamic softening behavior of high N-containing austenitic stainless steel under conditions resembling industrial manufacturing. The results indicate that the material's behavior is influenced by competition between work hardening, dynamic recovery, and dynamic recrystallization mechanisms, as well as stacking fault energy and grain boundary microstructures.

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Machine learning neural-network identification for dynamic recrystallization grains during hot deformation of nickel-based superalloy

Yulong Zhu et al.

Summary: A novel multiscale dynamic standard for electron backscatter diffraction (EBSD) test has been developed using neural network to investigate the recrystallization behavior of Incoloy 925 superalloy during hot deformation. The method analyzes the average grain size distribution and grain orientation spread (GOS) distribution at different stages of dynamic recrystallization and describes the recrystallized and deformed grains based on grain size, length-diameter ratio, GOS, and GOS maximum value. The neural network achieves excellent recognition accuracy for different deformation states by learning the grain characteristics.

MATERIALS CHARACTERIZATION (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Dynamic recrystallization behavior of the equiatomic FeCoCrNi high-entropy alloy during high temperature deformation

Seyyed Ali Sajadi et al.

Summary: The hot deformation behavior of FeCoCrNi high-entropy alloy was investigated in this study. The results showed that dynamic recrystallization was the primary softening mechanism, resulting in significant microstructural reconstitution and fine grains formation. The critical stress, strain, and deformation activation energy were determined for dynamic recrystallization.

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Dynamic recrystallization behavior andmicrostructure evolution of high-performance Cu-3.28Ni-0.6Si-0.22Zn-0.11Cr-0.04P during hot compression

Chang-Sheng Wang et al.

Summary: This study investigated the dynamic recrystallization behavior and microstructural evolution of a Cu alloy designed by a machine learning method through isothermal compression at temperatures in the range of 650-900 degrees C and strain rates in the range of 0.001-1 s(-1). The results suggest a suitable temperature range of 800-900 degrees C and appropriate strain rates dependent on the magnitude of strain. Observations of microstructure and texture changes under different conditions provide guidance for selecting process parameters.

RARE METALS (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Kinetic model for describing continuous and discontinuous dynamic recrystallization behaviors of 2195 aluminum alloy during hot deformation

Jingjing Zhang et al.

Summary: Dynamic recrystallization behavior of 2195 aluminum alloy was studied through hot compression experiments, revealing both discontinuous and continuous dynamic recrystallization occurring in the alloy within the temperature range of 300-520 degrees Celsius and strain rates of 0.01-10 s(-1). The dominant DRX mechanism transitioned from DDRX to CDRX when the strain exceeded 1.2, with the number of CDRX grains increasing at higher temperatures or lower strain rates.

MATERIALS CHARACTERIZATION (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Modelling kinetics of dynamic recrystallisation: introducing new characteristic parameters

Parag M. Ahmedabadi et al.

Summary: A new characteristic parameter (T-M50) and a simulation method for dynamics of dynamic recrystallisation (DRX) were introduced in the study, revealing complex relationships between this parameter and factors such as temperature and strain rate.

PHILOSOPHICAL MAGAZINE (2021)

添加到收藏夹

Article Chemistry, Physical

Modified kinetic model for describing continuous dynamic recrystallization behavior of Al 2219 alloy during hot deformation process

Lei Liu et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Microstructure and microtexture evolution of dynamic recrystallization during hot deformation of a nickel-based superalloy

Mingjia Wang et al.

MATERIALS & DESIGN (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Effect of the Zener-Hollomon parameter on the dynamic recrystallization kinetics of Mg-Zn-Zr-Yb magnesium alloy

Lu Li et al.

COMPUTATIONAL MATERIALS SCIENCE (2019)

添加到收藏夹

Article Nanoscience & Nanotechnology

Modeling dynamic recrystallization during hot deformation of a cast-homogenized Mg-Zn-Zr alloy

A. Hadadzadeh et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)

添加到收藏夹

Article Materials Science, Multidisciplinary

Experimental study and numerical simulation of dynamic recrystallization behavior of TiAl-based alloy

Zhipeng Wan et al.

MATERIALS & DESIGN (2017)

添加到收藏夹

Article Chemistry, Physical

Dynamic recrystallization behavior of Mg-Li-Al-Nd duplex alloy during hot compression

T. C. Xu et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2015)

添加到收藏夹

Article Materials Science, Multidisciplinary

A physically-based constitutive model for a typical nickel-based superalloy

Y. C. Lin et al.

COMPUTATIONAL MATERIALS SCIENCE (2014)

添加到收藏夹

Article Materials Science, Multidisciplinary

Dynamic recrystallization behavior of a typical nickel-based superalloy during hot deformation

Xiao-Min Chen et al.

MATERIALS & DESIGN (2014)

添加到收藏夹

Review Materials Science, Multidisciplinary

Dynamic and post-dynamic recrystallization under hot, cold and severe plastic deformation conditions

Taku Sakai et al.

PROGRESS IN MATERIALS SCIENCE (2014)

添加到收藏夹

Article Nanoscience & Nanotechnology

Dynamic recrystallization and precipitation in low carbon low alloy steel 26NiCrMoV 14-5

Masoud Mirzaee et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2012)

添加到收藏夹

Article Nanoscience & Nanotechnology

A new kinetics model of dynamic recrystallization for magnesium alloy AZ31B

J. Liu et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2011)

添加到收藏夹

Article Nanoscience & Nanotechnology

Correlation between Zener-Hollomon parameter and necklace DRX during hot deformation of 316 stainless steel

Meysam Jafari et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2009)

添加到收藏夹

Article Materials Science, Multidisciplinary

Modelling of dynamic recrystallisation kinetics in austenitic stainless and hypereutectoid steels

GR Stewart et al.

MATERIALS SCIENCE AND TECHNOLOGY (2006)

添加到收藏夹

Article Nanoscience & Nanotechnology

Modeling of recrystallization and austenite grain size for AISI 316 stainless steel and its application to hot bar rolling

SI Kim et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2003)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Initiation of dynamic recrystallization in constant strain rate hot deformation

EI Poliak et al.

ISIJ INTERNATIONAL (2003)

添加到收藏夹

Article Nanoscience & Nanotechnology

Dynamic recrystallization behavior of AISI 304 stainless steel

SI Kim et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2001)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.