Experimental and Modeling Study on the Removal of Mn, Fe, and Zn from Fiberboard Industrial Wastewater Using Modified Activated Carbon

In this work, the use of agricultural waste from oil palm petioles (OPP) as a raw material for the production of activated carbon (AC) and its characterization were examined. By soaking these chars in nitric acid (HNO3) and potassium hydroxide (KOH) at a 10% concentration, AC with favorable high-porosity carbons was generated. To maximize AC synthesis, the AC was pyrolyzed at 460, 480, and 500 degrees C temperatures for 20 min. Based on micrographs of formed pores and surface functional groups, 480 degrees C carbonization temperature on both chemical HNO3 and KOH was shown to be the best. The FTIR measurements reveal that chemical activation successfully transformed the raw material into AC. Moreover, FESEM micrographs show the pores and cavities of the prepared AC achieve a high surface area. This is further supported by BET results of HNO3 OPP AC and KOH OPP AC with surface areas of 883.3 and 372.4 m(2)/g, respectively, compared with the surface area of raw OPP of 0.58 m(2)/g. Furthermore, the tests were revealed by an optimization model, namely response surface methodology (RSM), using a central composite design (CCD) technique. The findings showed that all three parameters (pH, time, and dose) had a substantial impact on the removal of Zn, Fe, and Mn. Analysis of variance (ANOVA) and analytical error indicated that the models were accurate, with a low error value and a high R-2 > 0.9. Remarkably, the good correlation between actual and predicted removal values showed that the modified activated carbon is a promising adsorbent for heavy metal removal from wastewater.

Automated summary

In this study, the feasibility of using oil palm petioles as a raw material for activated carbon production was investigated. Activated carbon with high porosity was generated by chemically treating the char in nitric acid and potassium hydroxide. The optimal carbonization temperature was found to be 480 degrees C, as shown by pore analysis and surface functional group characterization. The prepared activated carbon exhibited a significantly higher surface area compared to the raw material. Furthermore, the study revealed that pH, time, and dose had a substantial impact on the removal of zinc, iron, and manganese from wastewater, making the modified activated carbon a promising adsorbent for heavy metal removal.