☆ 4.6 Article

Effect of Temperature and Impurity Content to Control Corrosion of 316 Stainless Steel in Molten KCl-MgCl2 Salt

MATERIALS (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Materials Science, Multidisciplinary

Excellent high temperature corrosion resistance of 304 stainless steel immersed in purified NaCl-MgCl2 eutectic salts

Pengfei Lu et al.

Summary: The corrosion behaviors of 304 stainless steel (304SS) in NaCl-MgCl2 eutectic salts with purification treatment at high temperature were investigated through static immersion under Ar atmosphere. The weight loss of 304SS was measured as 1.61 mg/cm2 at 500 degrees C and 1.80 mg/cm2 at 600 degrees C. The annual corrosion rate of 304SS was found to be less than 100 μm, indicating excellent corrosion resistance at high temperature. The intergranular corrosion of 304SS at high temperature was accompanied by the dissolution of active chromium and iron. The corrosion of 304SS intensified with increasing temperature, especially above 600 degrees C, which provides valuable data for material selection at high temperature. Due to the compatibility of 304SS with NaCl-MgCl2 salt, it is suitable for use in high-temperature containers.

MATERIALS CHEMISTRY AND PHYSICS (2023)

添加到收藏夹

Article Materials Science, Multidisciplinary

Corrosion behaviors and protective layer stabilization mechanism of 316 stainless steel in NaCl-KCl-NaF reciprocal salts at high temperatures

Yang Wang et al.

Summary: Corrosion tests were conducted on 316 stainless steel (316SS) in NaCl-KCl-NaF reciprocal salts at different temperatures. The results showed perfect compatibility between the reciprocal salts and 316SS, even without special treatment, and a stable Cr-O enriched layer was observed. The mechanism of stabilization of chromium oxides in molten salts was investigated, revealing that low oxoacidity facilitated the formation of stable chromium oxides. These findings can potentially contribute to the design and corrosion control of molten salts.

CORROSION SCIENCE (2023)

添加到收藏夹

Article Materials Science, Multidisciplinary

Effect of excess Mg to control corrosion in molten MgCl2 and KCl eutectic salt mixture

Kasey Hanson et al.

Summary: The study suggests that adding an optimum level of excess Mg to molten salt can prevent corrosion of alloys like 316 H, without forming any detectable Ni-Mg intermetallic phases on Ni-rich alloy surfaces.

CORROSION SCIENCE (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Corrosion behaviour of 316 stainless steel in NaCl-KCl-MgCl2 salt vapour at 700°C

Qi Liu et al.

Summary: The experiment investigated the corrosion behavior of 316 stainless steel in NaCl-KCl-MgCl2 salt vapor at 700 degrees C under static conditions. Easy-to-peel oxide layers were formed on the surface, with their composition and structure changing as exposure continued. The initially formed oxide monolayer gradually transformed into oxide multilayers, with the outermost layer changing from Cr-Fe oxide to Mg-Cr oxide, due to varying diffusion rates of elements and different reaction rates of MgCl2 in the salt vapor.

CORROSION SCIENCE (2022)

添加到收藏夹

Article Chemistry, Physical

In-depth explorations on the microstructural, thermodynamic and kinetic characteristics of MgCl2-KCl eutectic salt

Tingrui Xu et al.

Summary: In this study, first principle molecular dynamics (FPMD) simulations coupled with experimental measurements were used to investigate the thermophysical parameters, microstructures, and thermal transport properties of the MgCl2-KCl eutectic salt. The phase transition behaviors and coordination structure changes were characterized through FPMD simulations and compared with experimental results. The study also revealed the characteristics of peak heights in the static structural factors and the dominating effect of Mg-Mg correlation on pre-peaks. The calculated thermal conductivity and shear viscosity of the molten eutectic were slightly lower than the experimental values based on ionic self-diffusion coefficients.

JOURNAL OF MOLECULAR LIQUIDS (2022)

添加到收藏夹

Review Energy & Fuels

Comparative review of different influence factors on molten salt corrosion characteristics for thermal energy storage

Lina Ma et al.

Summary: This study summarizes the influencing factors and corrosion mechanisms of molten salt, presents anti-corrosion strategies for metallic materials, and proposes future research directions for molten salt corrosion characteristics.

SOLAR ENERGY MATERIALS AND SOLAR CELLS (2022)

添加到收藏夹

Article Energy & Fuels

Optimum design and key thermal property of NaCl-KCl-CaCl2 eutectic salt for ultra-high-temperature thermal energy storage

Huiqin Yin et al.

Summary: Through thermodynamic calculation and experimental validation, NaCl-KCl-CaCl2 eutectic salt with excellent ultra-high-temperature thermal stability and lower cost was developed, which can be considered as ultra-high-temperature thermal energy storage materials.

SOLAR ENERGY MATERIALS AND SOLAR CELLS (2022)

添加到收藏夹

Article Energy & Fuels

Thermodynamic and kinetic corrosion behavior of alloys in molten MgCl2-NaCl eutectic: FPMD simulations and electrochemical technologies

Xuejiao Li et al.

Summary: In this study, the thermodynamic, kinetic, and microstructural characteristics of divalent alloying elements in molten salt were analyzed through simulations and experiments. The results revealed the corrosion rules and explained the phenomenon of corrosion. The oxidation reactions of Ti were found to be thermodynamically and kinetically favorable, while the reactions of Fe and Cr had advantages in either thermodynamics or kinetics. Additionally, the Ni enrichment on the alloy surface was explained by the larger diffusivity of Ni2+ in molten salt.

SOLAR ENERGY MATERIALS AND SOLAR CELLS (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Corrosion behavior and mechanism of 316 stainless steel in NaCl-KCl-ZnCl2 molten salts at high temperature

Zhe Hu et al.

Summary: The corrosion behavior and mechanism of 316SS alloy in NaCl-KCl-ZnCl2 molten salts were investigated. The annual corrosion rate initially increased and then decreased to a steady rate. No evident pitting and intergranular corrosion were observed. An oxide layer composed of various oxides formed on the surface of the 316SS samples. The corrosion mechanism involved the hygroscopicity of ZnCl2, the reactions with Fe and Cr, and the formation of nickel oxide. Removal of Zn(OH)2 or basic zinc chloride in NaCl-KCl-ZnCl2 is necessary for commercial application.

MATERIALS TODAY COMMUNICATIONS (2022)

添加到收藏夹

Article Chemistry, Physical

Corrosion Behavior of Nitrogen-Containing Low-Nickel Weld Cladding in KCl-MgCl2 Eutectic Molten Salt at 900 °C

Taisen Yang et al.

Summary: This paper investigates the corrosion behavior of nitrogen-containing low-nickel flux-cored wire and weld cladding in molten salt. The results demonstrate that the nitrogen-containing low-nickel weld cladding exhibits better corrosion resistance compared to conventional weld cladding. The addition of nitrogen reacts with corrosive impurities, improves the corrosion environment, and enhances the corrosion resistance.

MATERIALS (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Hot corrosion behavior of additively manufactured stainless steel 316L and Inconel 718 in MgCl2/KCl/NaCl chloride salts at 700?

Hao Shi et al.

Summary: This study investigates the corrosion behavior of additively manufactured materials, specifically stainless steel 316L (SS316L) and Ni-base superalloy Inconel 718 (IN718), when exposed to salt environments. The results show that LMD SS316L has inferior corrosion resistance, while both AM and conventionally processed IN718 samples exhibit two different types of corrosion morphologies.

CORROSION SCIENCE (2022)

添加到收藏夹

Article Chemistry, Multidisciplinary

The corrosion behavior of 304 stainless steel in NaNO3-NaCl-NaF molten salt and vapor

Xing Lai et al.

Summary: The corrosion behavior of 304 stainless steel in molten NaNO3-NaCl-NaF salt and vapor has been studied. The results showed the formation of surface oxides and shedding phenomenon, attributed to the existence of NO2 and NO in the vapor. The corrosion rate in the salt is similar to that in solar salt, indicating the insignificant influence of Cl- and F- on the steel. This study enriches the molten salt corrosion database and provides references for alloy and salt selection in CSP.

RSC ADVANCES (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Ni-Mo-Cr alloy corrosion in molten NaCl-KCl-MgCl2 salt and vapour

Qi Liu et al.

Summary: The corrosion behavior of Ni-Mo-Cr alloy samples in salt and vapor revealed that oxidation in vapor accelerated corrosion, while corrosion in liquid molten salt was less severe. The corrosion by salt vapor should not be neglected in practical applications.

CORROSION SCIENCE (2021)

添加到收藏夹

Review Engineering, Multidisciplinary

Progress in Research and Development of Molten Chloride Salt Technology for Next Generation Concentrated Solar Power Plants

Wenjin Ding et al.

Summary: Concentrated solar power plants with thermal energy storage systems are emerging as a promising option for future renewable energy systems. The next generation CSP technology aims to reduce electricity costs and improve performance by utilizing higher process temperatures and greater energy efficiency.

ENGINEERING (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Air-stable, earth-abundant molten chlorides and corrosion-resistant containment for chemically-robust, high-temperature thermal energy storage for concentrated solar power

Adam S. Caldwell et al.

Summary: Increasing the inlet temperatures of CSP turbines and utilizing thermal energy storage at higher temperatures can improve efficiency, reduce costs, and enhance electricity generation. Research on alternative high-temperature, oxidation-resistant molten chlorides shows promise for low-cost, chemically-robust thermal energy storage materials.

MATERIALS TODAY (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Assessment of effects of Mg treatment on corrosivity of molten NaCl-KClMgCl2 salt with Raman and Infrared spectra

Hua Sun et al.

CORROSION SCIENCE (2020)

添加到收藏夹

Article Nanoscience & Nanotechnology

Revealing 3D Morphological and Chemical Evolution Mechanisms of Metals in Molten Salt by Multimodal Microscopy

Arthur Ronne et al.

ACS APPLIED MATERIALS & INTERFACES (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Excellent corrosion resistance of 316 stainless steel in purified NaCl-MgCl2 eutectic salt at high temperature

Lili Guo et al.

CORROSION SCIENCE (2020)

添加到收藏夹

Article Nuclear Science & Technology

Feasibility of an innovative long-life molten chloride-cooled reactor

Ming Lin et al.

NUCLEAR SCIENCE AND TECHNIQUES (2020)

添加到收藏夹

Article Chemistry, Physical

Insight into dynamic interaction of molten MgCl2-NaCl-KCl with impurity water via FPMD simulations

Xuejiao Li et al.

JOURNAL OF MOLECULAR LIQUIDS (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Corrosion behavior of Inconel 625 deposited metal in molten KCl-MgCl2

Taisen Yang et al.

MATERIALS RESEARCH EXPRESS (2020)

添加到收藏夹

Proceedings Paper Materials Science, Multidisciplinary

Effect of Ni on the Corrosion Behavior of Haynes 230 Alloy in MgCl2-KCl Salt

Yuxiang Peng et al.

TMS 2019 148TH ANNUAL MEETING & EXHIBITION SUPPLEMENTAL PROCEEDINGS (2019)

添加到收藏夹

Article Chemistry, Multidisciplinary

Enabling chloride salts for thermal energy storage: implications of salt purity

J. Matthew Kurley et al.

RSC ADVANCES (2019)

添加到收藏夹

Article Energy & Fuels

Experimental Test of Properties of KCl-MgCl2 Eutectic Molten Salt for Heat Transfer and Thermal Storage Fluid in Concentrated Solar Power Systems

Xiankun Xu et al.

JOURNAL OF SOLAR ENERGY ENGINEERING-TRANSACTIONS OF THE ASME (2018)

添加到收藏夹

Review Green & Sustainable Science & Technology

Materials corrosion for thermal energy storage systems in concentrated solar power plants

Magdalena Walczak et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2018)

添加到收藏夹

Article Energy & Fuels

Hot corrosion behavior of commercial alloys in thermal energy storage material of molten MgCl2/KCl/NaCl under inert atmosphere

Wenjin Ding et al.

SOLAR ENERGY MATERIALS AND SOLAR CELLS (2018)

添加到收藏夹

Article Materials Science, Multidisciplinary

Effects of alloying elements on the corrosion behavior of Ni-based alloys in molten NaCl-KCl-MgCl(2 )salt at different temperatures

Hua Sun et al.

CORROSION SCIENCE (2018)

添加到收藏夹

Article Energy & Fuels

Survey and evaluation of equations for thermophysical properties of binary/ternary eutectic salts from NaC1, KC1, MgC12, CaC12, ZnCl2 for heat transfer and thermal storage fluids in CSP

Yuanyuan Li et al.

SOLAR ENERGY (2017)

添加到收藏夹

Article Energy & Fuels

Material aspects of Solar Salt for sensible heat storage

Thomas Bauer et al.

APPLIED ENERGY (2013)

添加到收藏夹

Article Nuclear Science & Technology

MOLTEN SALT MIXTURE PROPERTIES (KF-ZrF4 AND KCl-MgCl2) FOR USE IN RELAP5-3D FOR HIGH-TEMPERATURE REACTOR APPLICATION

N. A. Anderson et al.

NUCLEAR TECHNOLOGY (2012)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.