☆ 4.7 Article

The importance of humidity control in powder rheometer studies

POWDER TECHNOLOGY (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Review Engineering, Chemical

Electrostatics of granules and granular flows: A review q

Yanlin Zhao et al.

Summary: In recent decades, the electrostatics of granules and granular flows has gained increasing attention due to its relevance to industrial problems and the development of new technologies. Electrification caused by granule-wall collision is influenced by various factors and shows saturation as granule processing increases. The presence of electrostatic charges has significant impacts in chemistry, chemical engineering, energy, pharmaceuticals, and other related areas. The measurement technology of electrostatics in granule conveying systems has been improved, and further research in this interdisciplinary problem is expected.

ADVANCED POWDER TECHNOLOGY (2023)

添加到收藏夹

Article Pharmacology & Pharmacy

The Influence of Relative Humidity and Storage Conditions on the Physico-chemical Properties of Inhalation Grade Fine Lactose

Milica Stankovic-Brandl et al.

Summary: Dry powder inhalers are favored for delivering dry formulations to the lungs, but struggle with high doses of active pharmaceutical ingredients in lower airways. Adding fine excipient particles can improve aerosolization performance, but variations in milling parameters and storage conditions can affect the properties of lactose powders. Changes in humidity levels can impact amorphous content and dispersion behavior, emphasizing the importance of considering these factors in formulation development.

AAPS PHARMSCITECH (2021)

添加到收藏夹

Article Engineering, Chemical

Measurement and quantification of caking in excipients and food products with emphasis on the non-homogeneous interaction with ambient moisture

Katrina Brockbank et al.

Summary: This study investigated the impact of moisture induced caking on powder flowability using powder rheology. The results showed that caking does not always occur uniformly, with a caked region forming at the air-powder interface and progressing through the powder bed. The strength of this caked region was also observed to increase over time before stabilizing.

PARTICUOLOGY (2021)

添加到收藏夹

Article Engineering, Chemical

Density and size-induced mixing and segregation in the FT4 powder rheometer: An experimental and numerical investigation

Marv J. Khala et al.

Summary: The study investigates mixing and segregation of binary mixtures of glass beads and/or resin particles based on density and size differences using a new FT4 methodology. Results show that the mixing index increases with density and size ratio, with flow energy and torque variation related to mixture components' mixing and segregation. DEM numerical analysis reveals that mixing and segregation occur differently in non-cohesive and cohesive systems under various stress conditions.

POWDER TECHNOLOGY (2021)

添加到收藏夹

Article Engineering, Chemical

On the design of conical hoppers for spent coffee grounds: Moisture content and particle-size effects

L. Massaro Sousa et al.

Summary: The study examined the bulk and flow properties of spent coffee grounds and found that flowability worsened with decreasing particle size and increasing moisture content. It is essential to carefully consider these factors when designing effective devices for handling spent coffee grounds.

JOURNAL OF FOOD ENGINEERING (2021)

添加到收藏夹

Article Engineering, Chemical

Feasibility study to investigate caking in washing powder formulations using a Freeman FT4 powder rheometer

Mark C. Leaper et al.

PARTICULATE SCIENCE AND TECHNOLOGY (2019)

添加到收藏夹

Review Engineering, Chemical

Amorphous and humidity caking: A review

Mingyang Chen et al.

CHINESE JOURNAL OF CHEMICAL ENGINEERING (2019)

添加到收藏夹

Article Chemistry, Medicinal

Effects of Water on Powder Flowability of Diverse Powders Assessed by Complimentary Techniques

Cosima Hirschberg et al.

JOURNAL OF PHARMACEUTICAL SCIENCES (2019)

添加到收藏夹

Article Food Science & Technology

Understanding the caking behavior of amorphous jujube powder by powder rheometer

Keren Agyekumwaa Addo et al.

LWT-FOOD SCIENCE AND TECHNOLOGY (2019)

添加到收藏夹

Article Engineering, Chemical

Assessment of a powder rheometer equipped with a cylindrical impeller for the measurement of powder flow properties at low consolidation

Marco Lupo et al.

POWDER TECHNOLOGY (2019)

添加到收藏夹

Review Engineering, Mechanical

Fundamental theories and basic principles of triboelectric effect: A review

Shuaihang Pan et al.

FRICTION (2019)

添加到收藏夹

Article Engineering, Chemical

DEM analysis of the effect of particle shape, cohesion and strain rate on powder rheometry

Vincenzino Vivacqua et al.

POWDER TECHNOLOGY (2019)

添加到收藏夹

Article Engineering, Chemical

Caking of crystals: Characterization, mechanisms and prevention

Mingyang Chen et al.

POWDER TECHNOLOGY (2018)

添加到收藏夹

Article Engineering, Chemical

Effect of moisture on flowability of pulverized coal

Haifeng Lu et al.

CHEMICAL ENGINEERING RESEARCH & DESIGN (2018)

添加到收藏夹

Article Engineering, Chemical

Effect of water addition on flow properties of lignite particles

Yong Jin et al.

CHEMICAL ENGINEERING RESEARCH & DESIGN (2018)

添加到收藏夹

Article Engineering, Chemical

Flow of granular materials in a bladed mixer: Effect of particle properties and process parameters on impeller torque and power consumption

Veerakiet Boonkanokwong et al.

ADVANCED POWDER TECHNOLOGY (2018)

添加到收藏夹

Article Engineering, Chemical

Influence of moisture content on the flow properties of basundi mix

Hrishikesh Mitra et al.

POWDER TECHNOLOGY (2017)

添加到收藏夹

Review Engineering, Chemical

A review of bulk powder caking

U. Zafar et al.

POWDER TECHNOLOGY (2017)

添加到收藏夹

Article Chemistry, Physical

The Effects of Relative Humidity on the Flowability and Dispersion Performance of Lactose Mixtures

Xiang-Yun Lu et al.

MATERIALS (2017)

添加到收藏夹

Article Engineering, Chemical

Analysis of powder rheometry of FT4: Effect of air flow

Wenguang Nan et al.

CHEMICAL ENGINEERING SCIENCE (2017)

添加到收藏夹

Article Engineering, Chemical

Adhesion force approximation at varying consolidation stresses for fine powder under humid conditions

Vikram Karde et al.

ADVANCED POWDER TECHNOLOGY (2017)

添加到收藏夹

Article Engineering, Chemical

Effect of liquid addition on the bulk and flow properties of fine and coarse glass beads

James V. Scicolone et al.

AICHE JOURNAL (2016)

添加到收藏夹

Article Pharmacology & Pharmacy

On the Methods to Measure Powder Flow

Geoffrey Tan et al.

CURRENT PHARMACEUTICAL DESIGN (2015)

添加到收藏夹

Article Engineering, Chemical

Analysis of the dynamics of the FT4 powder rheometer

C. Hare et al.

POWDER TECHNOLOGY (2015)

添加到收藏夹

Article Engineering, Chemical

Surface modification to improve powder bulk behavior under humid conditions

Vikram Karde et al.

POWDER TECHNOLOGY (2015)

添加到收藏夹

Proceedings Paper Engineering, Multidisciplinary

Measurement and quantification of caking in powders

Tim Freeman et al.

NEW PARADIGM OF PARTICLE SCIENCE AND TECHNOLOGY, PROCEEDINGS OF THE 7TH WORLD CONGRESS ON PARTICLE TECHNOLOGY (2015)

添加到收藏夹

Article Engineering, Chemical

Caking of sodium chloride: Role of ambient relative humidity in dissolution and recrystallization process

Marina Langlet et al.

CHEMICAL ENGINEERING SCIENCE (2013)

添加到收藏夹

Review Engineering, Environmental

Triboelectrostatic separation for granular plastic waste recycling: A review

Guiqing Wu et al.

WASTE MANAGEMENT (2013)

添加到收藏夹

Article Engineering, Chemical

The impact of electrostatic charge in pharmaceutical powders with specific focus on inhalation-powders

Stefan Karner et al.

JOURNAL OF AEROSOL SCIENCE (2011)

添加到收藏夹

Article Agriculture, Multidisciplinary

Moisture-induced caking of beverage powders

Edgar Chavez Montes et al.

JOURNAL OF THE SCIENCE OF FOOD AND AGRICULTURE (2011)

添加到收藏夹

Review Engineering, Chemical

Triboelectric charging of powders: A review

S. Matsusaka et al.

CHEMICAL ENGINEERING SCIENCE (2010)

添加到收藏夹

Review Pharmacology & Pharmacy

Deliquescence of pharmaceutical systems

Lisa J. Mauer et al.

PHARMACEUTICAL DEVELOPMENT AND TECHNOLOGY (2010)

添加到收藏夹

Review Food Science & Technology

Water-Solids Interactions: Deliquescence

Lisa J. Mauer et al.

ANNUAL REVIEW OF FOOD SCIENCE AND TECHNOLOGY, VOL 1 (2010)

添加到收藏夹

Article Engineering, Chemical

Characterization of powder flow: Static and dynamic testing

Matthew Krantz et al.

POWDER TECHNOLOGY (2009)

添加到收藏夹

Article Engineering, Chemical

Measuring the flow properties of consolidated, conditioned and aerated powders - A comparative study using a powder rheometer and a rotational shear cell

Reg Freeman

POWDER TECHNOLOGY (2007)

添加到收藏夹

Article Pharmacology & Pharmacy

Deliquescence-induced caking in binary powder blends

Adnan K. Salameh et al.

PHARMACEUTICAL DEVELOPMENT AND TECHNOLOGY (2006)

添加到收藏夹

Review Engineering, Chemical

Electrostatics of particles

S Matsusaka et al.

ADVANCED POWDER TECHNOLOGY (2003)

添加到收藏夹

Review Chemistry, Multidisciplinary

Phase transitions of aqueous atmospheric particles

ST Martin

CHEMICAL REVIEWS (2000)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.