☆ 4.4 Article

Wet flashover voltage improvement of the ceramics with dielectric barrier discharge

PLASMA SCIENCE & TECHNOLOGY (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Engineering, Electrical & Electronic

Study on discharge characteristics and improving surface hydrophobicity of epoxy resin by nanosecond pulse excited argon/hexamethyldisiloxane jet array

Zhiyan Liu et al.

Summary: In this paper, a one-dimensional argon jet array driven by nanosecond pulse power supply with hexamethyldisiloxane (HMDSO) addition was used to form a super-hydrophobic film on the surface of epoxy resin, aiming to improve the surface hydrophobicity and insulating performance of insulating materials. The experimental results showed that with 0.04% HMDSO, the jet array achieved the best hydrophobic treatment effect on the epoxy resin surface. The apparent contact angle of the epoxy resin surface increased from 60.3 degrees to 150.0 degrees after 60 seconds of treatment, and the wettability did not change significantly beyond 60 seconds of treatment time. The surface morphology and chemical feature of the treated epoxy resin were analyzed, revealing that the surface was covered with dense coral-like particles in nanoscales, and the original organic functional groups were replaced by silicon-containing groups, resulting in an increase in the Si content from 0.4% to 28.0%. This study provides important references for the development of jet array as an efficient tool to enhance the surface hydrophobicity and insulating performance of insulating materials.

HIGH VOLTAGE (2022)

添加到收藏夹

Article Physics, Fluids & Plasmas

Periodical discharge regime transitions under long-term repetitive nanosecond pulses

Zheng Zhao et al.

Summary: This paper investigates the instability and regime transition of nanosecond repetitively pulsed (NRP) discharges. Experimental studies were conducted on needle-needle and needle-plane gaps in gas mixtures. It is found that the discharge regime transitions periodically from corona to glow to spark and back to corona in each pulse train. The duration of the spark regime can be controlled by adding oxygen and adjusting the output impedance of the power supply.

PLASMA SOURCES SCIENCE & TECHNOLOGY (2022)

添加到收藏夹

Article Materials Science, Coatings & Films

Deposition of superhydrophobic film on cylindrical ceramic with atmospheric pressure plasma jet

Xinglei Cui et al.

Summary: This study demonstrates that a superhydrophobic film can be deposited on the ceramic surface under appropriate treatment conditions, and further investigates the hydrophobicity of the film.

SURFACE & COATINGS TECHNOLOGY (2022)

添加到收藏夹

Article Materials Science, Composites

Fabrication and mechanical characterization of hybrid composite reinforced with nanoparticles of alumina and zirconia

Vivek Vij et al.

Summary: Metal matrix composites reinforced with nanoparticles are becoming increasingly important in the automobile and aerospace industry due to their high performance, lightweight, and excellent mechanical strength. In this study, a nanocomposite with aluminum matrix reinforced with alumina and zirconia nanoparticles was fabricated using the stir-casting technique. The microstructural and mechanical properties of the nanocomposite were investigated and compared with those of pure rolled aluminum. The results showed that the addition of nanoparticles significantly improved the tensile strength and hardness of the nanocomposite, while slightly reducing its flexural strength.

POLYMER COMPOSITES (2022)

添加到收藏夹

Article Chemistry, Physical

Nanosecond pulse-driven atmospheric-pressure plasmas for polymer surface modifications: Wettability performance, insulation evaluation and mechanisms

Xinglei Cui et al.

Summary: In this study, a nanosecond pulsed-driven Ar/Octamethylcyclotetrasiloxane (OMCTS) plasma jet was developed to modify the surface of epoxy resin (EP) and enhance its insulation performance. It was found that the surface roughness of EP increased and the conductivity improved after plasma treatment. The addition of a controlled amount of OMCTS improved the insulation and wettability performance, while excessive addition inhibited the plasma discharge.

APPLIED SURFACE SCIENCE (2022)

添加到收藏夹

Article Instruments & Instrumentation

A unipolar compact nanosecond pulsed power supply with high power factor for dielectric barrier discharge applications

Xiongmin Tang et al.

Summary: A unipolar high voltage pulsed power supply with power factor correction is proposed to generate uniform and diffuse plasma in dielectric barrier discharge loads. The power supply consists of a high voltage generating unit, a PFC unit, and a driving circuit. By introducing feedback clamping and reverse current blocking, repetitive nanosecond pulses are generated, resulting in a compact structure and high power factor.

REVIEW OF SCIENTIFIC INSTRUMENTS (2022)

添加到收藏夹

Article Engineering, Electrical & Electronic

Enhanced Pollution Flashover of a Slurry Coalescence Superhydrophobic Coating

Wenjie Xu et al.

Summary: The study demonstrates that superhydrophobic coatings are effective in preventing pollution flashover under high voltage conditions and can increase flashover voltage. The unique suppression mechanism of the superhydrophobic coating is primarily driven by the electrostatic force generated by the applied voltage, leading to the formation of coalesced slippery slurry droplets and expanded dry areas which contribute to higher flashover voltage. This suggests that superhydrophobic coatings have potential applications in enhancing the anti-pollution performance of insulators.

IEEE TRANSACTIONS ON DIELECTRICS AND ELECTRICAL INSULATION (2021)

添加到收藏夹

Review Automation & Control Systems

Brazing of SiO2 ceramic

Ruixiang Yi et al.

Summary: This article reviews the brazing of SiO2 ceramic, discussing the advantages and disadvantages of the active brazing method and analyzing the bonding between SiO2 ceramic and different types of metals. It also introduces different improvement methods of filler metal to enhance the wettability of the reaction interface, and proposes the development direction of bonding SiO2 ceramic in the future.

INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2021)

添加到收藏夹

Article Physics, Fluids & Plasmas

Influence of air addition on surface modification of polyethylene terephthalate treated by an atmospheric pressure argon plasma brush

Jiacun Wu et al.

Summary: Using an atmospheric pressure argon plasma brush with air addition can significantly improve the hydrophilicity of PET surfaces by increasing the production of oxygen atoms in the plasma. The increase in oxygen functional groups with higher air content leads to better hydrophilicity, as well as an increase in surface roughness.

PLASMA SCIENCE & TECHNOLOGY (2021)

添加到收藏夹

Article Chemistry, Physical

Study on the self-cleaning phenomenon and anti-pollution flashover performance of micro-nanostructure superhydrophobic coating surface under a high humidity environment

Jinyu Chen et al.

Summary: The research on the anti-pollution flashover performance of superhydrophobic coating is still insufficient. This paper analyzes the various types of forces on the polluted particles accumulated on the coating surface, and establishes a new pollution flashover mechanism model. The experimental results show that the leakage current of superhydrophobic coating surface remains about 16.3 mu A after being completely wetted at any pollution degree.

COLLOIDS AND SURFACES A-PHYSICOCHEMICAL AND ENGINEERING ASPECTS (2021)

添加到收藏夹

Article Physics, Fluids & Plasmas

Improving the surface flashover performance of epoxy resin by plasma treatment: a comparison of fluorination and silicon deposition under different modes

Jiyuan Yan et al.

Summary: This study investigates the use of different plasma modification methods to improve the flashover performance of Al2O3-ER samples, revealing that the DBD-F method has the greatest effect while the APPJ-F method has the poorest effect. Plasma fluorination and silicon deposition introduce shallow traps which play a crucial role in surface charge dissipation and flashover inhibition.

PLASMA SCIENCE & TECHNOLOGY (2021)

添加到收藏夹

Article Chemistry, Multidisciplinary

Solvent-free, ultrafast and ultrathin PDMS coating triggered by plasma for molecule separation and release

Yintao Li et al.

Summary: An efficient and solvent-free PDMS coating method was developed with plasma treatment, enabling ultrathin coatings on nanostructured substrates within 15 seconds at room temperature. The method showed great potential for various applications in separation, controlled release, sensing, surface modification, and protection.

GREEN CHEMISTRY (2021)

添加到收藏夹

Article Materials Science, Ceramics

Morphology and structure characterization of ceramic granules

Christian Bechteler et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2020)

添加到收藏夹

Article Engineering, Electrical & Electronic

A new high-voltage H2S single noxious gas reliability test for power modules

T. N. Wassermann et al.

MICROELECTRONICS RELIABILITY (2019)

添加到收藏夹

Article Physics, Fluids & Plasmas

Deposition of SiCxHyOz thin film on epoxy resin by nanosecond pulsed APPJ for improving the surface insulating performance

Qing Xie et al.

PLASMA SCIENCE & TECHNOLOGY (2018)

添加到收藏夹

Article Physics, Applied

Inorganic nanofilms for surface charge control on polymer surfaces by atmospheric-pressure plasma deposition

Ruixue Wang et al.

JOURNAL OF APPLIED PHYSICS (2017)

添加到收藏夹

Article Physics, Applied

Plasma surface treatment to improve surface charge accumulation and dissipation of epoxy resin exposed to DC and nanosecond-pulse voltages

Cheng Zhang et al.

JOURNAL OF PHYSICS D-APPLIED PHYSICS (2017)

添加到收藏夹

Article Engineering, Environmental

Superhydrophobic high impact polystyrene (HIPS) nanocomposites with wear abrasion resistance

Muhammad T. Masood et al.

CHEMICAL ENGINEERING JOURNAL (2017)

添加到收藏夹

Article Physics, Applied

The control mechanism of surface traps on surface charge behavior in alumina-filled epoxy composites

Chuanyang Li et al.

JOURNAL OF PHYSICS D-APPLIED PHYSICS (2016)

添加到收藏夹

Article Physics, Fluids & Plasmas

Surface Modification of Polyimide Film by Dielectric Barrier Discharge at Atmospheric Pressure

Peng Shi et al.

PLASMA SCIENCE & TECHNOLOGY (2016)

添加到收藏夹

Article Chemistry, Physical

Microsecond pulse driven Ar/CF4 plasma jet for polymethylmethacrylate surface modification at atmospheric pressure

Ruixue Wang et al.

APPLIED SURFACE SCIENCE (2015)

添加到收藏夹

Article Physics, Applied

Enhanced surface flashover strength in vacuum of polymethylmethacrylate by surface modification using atmospheric-pressure dielectric barrier discharge

Tao Shao et al.

APPLIED PHYSICS LETTERS (2014)

添加到收藏夹

Article Physics, Fluids & Plasmas

Pulsed Power Generation by Solid-State LTD

Weihua Jiang et al.

IEEE TRANSACTIONS ON PLASMA SCIENCE (2014)

添加到收藏夹

Article Chemistry, Multidisciplinary

Why a Lotus-like Superhydrophobic Surface Is Self-Cleaning? An Explanation from Surface Force Measurements and Analysis

Miao Yu et al.

LANGMUIR (2014)

添加到收藏夹

Article Physics, Fluids & Plasmas

Surface Treatment of Polyethylene Terephthalate to Improving Hydrophilicity Using Atmospheric Pressure Plasma Jet

Zhi Fang et al.

IEEE TRANSACTIONS ON PLASMA SCIENCE (2013)

添加到收藏夹

Article Physics, Applied

Identification of electron and hole trap based on isothermal surface potential decay model

Wen-Wei Shen et al.

JOURNAL OF APPLIED PHYSICS (2013)

添加到收藏夹

Article Chemistry, Physical

Colloid mobilization by fluid displacement fronts in channels

Volha Lazouskaya et al.

JOURNAL OF COLLOID AND INTERFACE SCIENCE (2013)

添加到收藏夹

Article Chemistry, Physical

Preparation and spectroscopic properties of Y2O3:Eu3+ nanopowders and ceramics

Wang Chaonan et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2009)

添加到收藏夹

Article Materials Science, Coatings & Films

Organic-inorganic behaviour of HMDSO films plasma-polymerized at atmospheric pressure

Rino Morent et al.

SURFACE & COATINGS TECHNOLOGY (2009)

添加到收藏夹

Article Engineering, Chemical

Accounting for the JKR-DMT transition in adhesion and friction measurements with atomic force microscopy

DS Grierson et al.

JOURNAL OF ADHESION SCIENCE AND TECHNOLOGY (2005)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.