☆ 4.7 Article

Enhancing hardness and toughness of WC simultaneously by dispersed ZrO2

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Chemistry, Physical

On the enhanced wear resistance of ultra-coarse WC-Co cemented carbides by WCoB addition

Xuemei Liu et al.

Summary: The addition of WCoB significantly improves the wear resistance of ultra-coarse cemented carbides, mainly due to the high hardness of WCoB balancing the stress distribution within WC grains, reducing the likelihood of fracture and pull-out during the wear process.

JOURNAL OF ALLOYS AND COMPOUNDS (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Extraordinary high-temperature mechanical properties in binder-free nanopolycrystalline WC ceramic

Hongfeng Dong et al.

Summary: The binder-free nanopolycrystalline WC ceramic obtained by high-pressure and high-temperature sintering exhibits excellent mechanical properties at both room temperature and high temperature up to 1000 degrees C. It maintains a considerably high Vicker hardness at high temperature, showing outstanding thermo-mechanical stability superior to typical technical ceramics like SiC, Si3N4, Al2O3, etc. The nanocrystalline grains with dislocations and low-energy E2 grain boundaries contribute to its exceptional high-temperature mechanical properties.

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Effects of Al2O3-ZrO2 content on the densification, microstructure, and mechanical properties of cemented tungsten carbides

Jingmao Li et al.

Summary: The study found that the increase in Al2O3-ZrO2 content affected the grain size of WC and the temperature of the densification process. At the same time, the hardness of the composite material decreased while the indentation fracture toughness increased.

MATERIALS CHEMISTRY AND PHYSICS (2022)

添加到收藏夹

Article Chemistry, Physical

Nano-ceramic replacing cobalt in cemented carbide as binder phase: Is it feasible?

Jialin Sun et al.

Summary: In this study, the feasibility of using nano ceramic as a binder in WC-based cemented carbide was explored. Near-full densifications were achieved for WC-6Al(2)O(3), WC-6ZrO(2), and WC-6MgO nanocomposite carbides through hot-pressing sintering. The nano-sized ceramic binders were located along the grain boundaries and within the WC matrix grains, enhancing the mechanical responses of the materials. The main toughening mechanisms included crack deflection, bridging, and branching. Stress-induced transformation toughening played a significant role in improving fracture toughness in WC with ZrO2 binder. Nano ceramic phases as alternative binders to Co provided greater freedom in tailoring the microstructure, stability, and properties of cemented carbides.

JOURNAL OF ALLOYS AND COMPOUNDS (2022)

添加到收藏夹

Article Nanoscience & Nanotechnology

Understanding microstructure-mechanical properties relationship in ZrO2-SiO2 nanocrystalline glass-ceramics: The effect of ZrO2 content

Le Fu et al.

Summary: The study investigated the effect of the content of crystalline phase on the mechanical properties of ZrO2-SiO2 nanocrystalline glass-ceramics (NCGCs). The results showed that NCGCs with 65 mol% ZrO2 had the highest flexural strength, while increasing the ZrO2 content beyond 65 mol% led to a decrease in strength.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Experimental and numerical investigations of micro-meso damage evolution for a WC/Co-type tool material

Y. Schneider et al.

Summary: Commercial Co/WC/diamond composites with 90vol.% Co exhibit both ductile and quasi-brittle behavior depending on the diamond portion and local morphology. This study investigated the local damage evolution in relation to microstructural features using real and artificial microstructures. The findings contribute to the understanding of WC-Co type tool materials and offer valuable data for future research.

MATERIALIA (2022)

添加到收藏夹

Article Chemistry, Physical

Synergistic strengthening and toughening of oscillatory pressure sintered WC-ZrO2-Al2O3 ceramics

Yong Cheng et al.

Summary: The study found that addition of ZrO2-Al2O3 composite powder can reduce the sintering temperature and promote densification of WC-ZrO2-Al2O3 ceramics, with the ceramics exhibiting the best mechanical properties at 8 wt% of ZrO2-Al2O3 composite powder content.

JOURNAL OF ALLOYS AND COMPOUNDS (2022)

添加到收藏夹

Review Materials Science, Multidisciplinary

A review on optical properties and application of transparent ceramics

Ojo Jeremiah Akinribide et al.

Summary: This article summarizes the advancements in transparent YSZ ceramics, with a focus on applications and various consolidation technologies.

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2022)

添加到收藏夹

Article Engineering, Mechanical

Wear assessment of cemented carbide tools (WC–Co) with defined cutting edges under grinding-like service conditions

Shiqi Fang

WEAR (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Toughening cemented carbides by phase transformation of zirconia

Wentao Jiang et al.

Summary: By incorporating yttria partially stabilized zirconia into WC-Co cemented carbides, the hardness and fracture toughness can be simultaneously improved, mainly attributed to the stress-induced phase transformation of tetragonal ZrO2. ZrO2 particles dispersed homogeneously in the WC skeleton and had good interfacial bonding with both WC and Co phases, contributing to the enhancement of the mechanical properties of cemented carbides.

MATERIALS & DESIGN (2021)

添加到收藏夹

Article Materials Science, Ceramics

Fabrication and thermal shock behavior of ZrO2 toughened magnesia aggregates

Yao Mi et al.

Summary: The study showed that by adding microscale monoclinic ZrO2, the thermal shock resistance of magnesia aggregates can be improved. However, excessive addition of ZrO2 may lead to a decrease in densification and an increase in microcracks.

CERAMICS INTERNATIONAL (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Phase transformation induces plasticity with negligible damage in ceria-stabilized zirconia-based ceramics

Alethea Liens et al.

ACTA MATERIALIA (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Deformation and fracture of WC grains and grain boundaries in a WC-Co hardmetal during microcantilever bending tests

Tamas Csanadi et al.

INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2020)

添加到收藏夹

Article Materials Science, Ceramics

Formation and control of intragranular ZrO2 strengthened and toughened Al2O3 ceramics

Wenya Du et al.

CERAMICS INTERNATIONAL (2020)

添加到收藏夹

Article Engineering, Multidisciplinary

Nanocrystalline WC-Co composite with ultrahigh hardness and toughness

Yong Peng et al.

COMPOSITES PART B-ENGINEERING (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Preparation and characterization of vancomycin-loaded chitosan/PVA/PEG hydrogels for wound dressing

Mitra Naeimi et al.

MATERIALS RESEARCH EXPRESS (2020)

添加到收藏夹

Article Chemistry, Multidisciplinary

Insight into structural properties of polyethylene glycol monolaurate in water and alcohols from molecular dynamics studies

Ianatul Khoiroh et al.

RSC ADVANCES (2020)

添加到收藏夹

Article Materials Science, Ceramics

Influence of Ni and ZrO2 contents on sintering and mechanical properties of WC-2wt.%ZrO2-1wt.%Ni composites

Ziyou Zhao et al.

CERAMICS INTERNATIONAL (2019)

添加到收藏夹

Review Materials Science, Multidisciplinary

Cemented carbide microstructures: a review

Jose Garcia et al.

INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2019)

添加到收藏夹

Article Materials Science, Ceramics

In-situ elongated aluminium borate grains toughening WC-1.87 wt % Al2O3-4.13 wt % ZrO2 composite via spark plasma sintering

Jingmao Li et al.

CERAMICS INTERNATIONAL (2019)

添加到收藏夹

Article Materials Science, Multidisciplinary

Mechanisms of WC plastic deformation in cemented carbide

Xuemei Liu et al.

MATERIALS & DESIGN (2018)

添加到收藏夹

Article Materials Science, Ceramics

Microstructure and characterization of WC-2.8 wt% Al2O3-6.8 wt% ZrO2 composites produced by spark plasma sintering

Xiaojian Xia et al.

CERAMICS INTERNATIONAL (2016)

添加到收藏夹

Article Chemistry, Physical

Microstructural evolution of Al2O3-ZrO2 (Y2O3) powder de-agglomerated by sodium hydroxide solution soaking

Linfeng Xu et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2016)

添加到收藏夹

Article Chemistry, Multidisciplinary

Preparation and mechanisms of cemented carbides with ultrahigh fracture strength

Xingwei Liu et al.

JOURNAL OF APPLIED CRYSTALLOGRAPHY (2015)

添加到收藏夹

Article Materials Science, Ceramics

Zirconia-toughened WC with/without VC and Cr3C2

Donghai Zheng et al.

CERAMICS INTERNATIONAL (2014)

添加到收藏夹

Review Materials Science, Multidisciplinary

Hot pressing of tungsten carbide with and without sintering additives

Agnieszka Gubernat et al.

INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2014)

添加到收藏夹

Article Nanoscience & Nanotechnology

Densification and characterization of spark plasma sintered ZrC-ZrO2 composites

Irina Hussainova et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2014)

添加到收藏夹

Article Chemistry, Physical

ZrO2 (3Y) toughened WC composites prepared by spark plasma sintering

Donghai Zheng et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2013)

添加到收藏夹

Article Materials Science, Multidisciplinary

Effects of Carbon Addition on Microstructures and Mechanical Properties of Binderless Tungsten Carbide

Akihiro Nino et al.

MATERIALS TRANSACTIONS (2012)

添加到收藏夹

Article Materials Science, Ceramics

Influence of WC particles on the microstructural and mechanical properties of 3 mol% Y2O3 stabilized ZrO2 matrix composites produced by hot pressing

N. Uenal et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2011)

添加到收藏夹

Article Materials Science, Multidisciplinary

Investigation on the phase stability, sintering and thermal conductivity of Sc2O3-Y2O3-ZrO2 for thermal barrier coating application

Huaifei Liu et al.

MATERIALS & DESIGN (2010)

添加到收藏夹

Article Engineering, Industrial

Effect of initial particulate and sintering temperature on mechanical properties and microstructure of WC-ZrO2-VC ceramic composites

F. Z. Yang et al.

JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2009)

添加到收藏夹

Article Materials Science, Ceramics

Processing of ultrafine ZrO2 toughened WC composites

Olivier Malek et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2009)

添加到收藏夹

Article Materials Science, Ceramics

Pressureless sintering and tribological properties of WC-ZrO2 composites

B Basu et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2005)

添加到收藏夹

Article Nanoscience & Nanotechnology

Toughness tailoring of yttria-doped zirconia ceramics

B Basu et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2004)

添加到收藏夹

Review Materials Science, Multidisciplinary

Measurement of hardness and elastic modulus by instrumented indentation: Advances in understanding and refinements to methodology

WC Oliver et al.

JOURNAL OF MATERIALS RESEARCH (2004)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.