☆ 4.6 Article

Improvement of dynamic compression properties and strengthening mechanism of Mg-Y-Nd-Gd-Zr alloy by pre-twinning

JOURNAL OF MATERIALS SCIENCE (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Metallurgy & Metallurgical Engineering

Improved mechanical properties and strengthening mechanism with the altered precipitate orientation in magnesium alloys

Y. J. Wan et al.

Summary: This study investigated the effect of aging prior to twinning deformation on the precipitate orientation in AZ31 Mg alloy. The results demonstrated that the presence of prismatic plates led to significant improvements in compressive yield strength and compression ratio. Analysis using a yield strengthen model revealed that the enhanced CYS was primarily attributed to the altered precipitate orientation and refined grain size, with prismatic plates exhibiting a stronger hardening effect on basal slip.

JOURNAL OF MAGNESIUM AND ALLOYS (2022)

添加到收藏夹

Article Engineering, Mechanical

The effect of ultrasonic surface rolling process on tension-tension fatigue limit of small diameter specimens of Inconel 718 superalloy

Xiang Peng et al.

Summary: The fatigue limit of aged Inconel 718 superalloy specimens after ultrasonic surface rolling process (USRP) is influenced by the diameter. Smaller diameter samples showed a decrease in fatigue limit, while larger diameter samples exhibited an increase. Moreover, the fatigue life displayed an increasing trend and then a decreasing trend with increasing distance between the fatigue crack initiation position (FCIP) and the specimen surface.

INTERNATIONAL JOURNAL OF FATIGUE (2022)

添加到收藏夹

Review Metallurgy & Metallurgical Engineering

Effects of deformation twins on microstructure evolution, mechanical properties and corrosion behaviors in magnesium alloys-A review

Lianhui Li et al.

Summary: Twins play a crucial role in regulating texture, refining grains, improving mechanical properties, and corrosion resistance in magnesium alloys. This article reviews the common types and variants of twins in magnesium alloys, their influencing factors, and their effects on microstructure, mechanical properties, and corrosion resistance. It also proposes interesting ideas for further research.

JOURNAL OF MAGNESIUM AND ALLOYS (2022)

添加到收藏夹

Article Chemistry, Physical

Achieving higher dynamic mechanical response by adjusting texture through twinning in a ZK61 Mg alloy

Abdul Malik et al.

Summary: In this study, the reorientation of texture and improvement of mechanical properties in ZK61-T6 and ZK61-PC magnesium alloys were achieved through cross pre-compression. The results showed that the compressive yield strength, ultimate compressive strength, and elongation to fracture were significantly increased. The microstructure evolution revealed the propensity and width of adiabatic shear band and the role of twinning, de-twinning, and dislocation in absorbing high-stress energy. The twinning-induced rotational dynamic recrystallization mechanism contributed to the development of fine grains. Based on the findings, pre-compression is recommended as a practical approach to enhance the efficiency of ZK61 magnesium alloy.

JOURNAL OF ALLOYS AND COMPOUNDS (2022)

添加到收藏夹

Review Metallurgy & Metallurgical Engineering

Post deformation analysis of the ballistic impacted magnesium alloys, a short-review

Abdul Malik et al.

Summary: Magnesium alloys are lightweight materials that have gained increasing attention in military and aerospace fields, but their applications are limited by low ductility and mechanical properties. Components made from magnesium alloys must withstand shockwaves under hypervelocity ballistic impact, and ballistic testing can provide valuable data for performance evaluation and optimization.

JOURNAL OF MAGNESIUM AND ALLOYS (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Crystallography of the precipitates formed on {10-11} twin boundary in Mg-Al alloys

Feiya Liu et al.

Summary: It was revealed for the first time that the Mg17Al12 precipitates formed on {1011} twin boundaries in a Mg-Al alloy hold an identical orientation relationship, driven by the minimization of the total energy between the matrix-precipitate interface and the twin-precipitate interface.

MATERIALS CHARACTERIZATION (2021)

添加到收藏夹

Article Nanoscience & Nanotechnology

Effect of grain size on the microstructure and deformation mechanism of Mg-2Y-0.6Nd-0.6Zr alloy at a high strain rate

Aiwen Li et al.

Summary: The dynamic mechanical behavior and deformation mechanism of Mg-2Y-0.6Nd-0.6Zr alloys are influenced by grain size, with fine grains inhibiting twinning and allowing easier movement of dislocations. Increasing grain size leads to a shift in the main deformation mechanism from dislocation slip to {101(-)2} tensile twins and dislocation slip.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2021)

添加到收藏夹

Article Multidisciplinary Sciences

Evading strength-corrosion tradeoff in Mg alloys via dense ultrafine twins

Changjian Yan et al.

Summary: The study demonstrates that ultrafine grained Mg alloys with dense twins exhibit high strength and reduced corrosion rate compared to conventional ultrafine grains, achieved through a carefully designed multi-directional compression treatment refining grain size down to 300nm. This technique not only decreases micro-galvanic corrosion tendency, but also completely suppresses severe localized corrosion.

NATURE COMMUNICATIONS (2021)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Effect of Ce-base mischmetal addition on the microstructure and mechanical properties of hot-rolled ZK60 alloy

E. P. Silva et al.

Summary: Mg-Zn-Zr (ZK) alloys have high mechanical strength, but are susceptible to hot cracking due to the formation of low melting point precipitates. Adding rare earths can improve the alloy's performance. Ce-base mischmetal addition can enhance hot rolling behavior, refine grain size, and improve mechanical properties of ZK60 alloy.

JOURNAL OF MAGNESIUM AND ALLOYS (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Mechanistic investigation of a low-alloy Mg-Ca-based extrusion alloy with high strength-ductility synergy

Hucheng Pan et al.

ACTA MATERIALIA (2020)

添加到收藏夹

Article Nanoscience & Nanotechnology

Constitutive analysis, twinning, recrystallization, and crack in fine-grained ZK61 Mg alloy during high strain rate compression over a wide range of temperatures

Abdul Malik et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)

添加到收藏夹

Article Nanoscience & Nanotechnology

Influence of pre-twinning on high strain rate compressive behavior of AZ31 Mg-alloys

Ruifeng Wang et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

3D atomic-scale growth characteristics of {10-12} twin in magnesium

Xin Wan et al.

JOURNAL OF MAGNESIUM AND ALLOYS (2019)

添加到收藏夹

Article Nanoscience & Nanotechnology

Effect of pre-existing {10(1)over-bar2} extension twins on mechanical properties, microstructure evolution and dynamic recrystallization of AZ31 Mg alloy during uniaxial compression

Hua Zhang et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Texture tailoring and bendability improvement of rolled AZ31 alloy using {10-12} twinning: The effect of precompression levels

Jong Un Lee et al.

JOURNAL OF MAGNESIUM AND ALLOYS (2019)

添加到收藏夹

Article Chemistry, Physical

High strain-rate behavior and deformation mechanism of a multi-layer composite textured AZ31B Mg alloy plate

Weigui Zhang et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2018)

添加到收藏夹

Article Nanoscience & Nanotechnology

Deformation behaviors and cyclic strength assessment of AZ31B magnesium alloy based on steady ratcheting effect

Zhifeng Yan et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)

添加到收藏夹

Article Nanoscience & Nanotechnology

Enhancing the age-hardening response of rolled AZ80 alloy by pre-twinning deformation

Chunpeng Wang et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)

添加到收藏夹

Article Nanoscience & Nanotechnology

Effect of pre-deformation on microstructure and mechanical properties of WE43 magnesium alloy

Y. H. Kang et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)

添加到收藏夹

Article Nanoscience & Nanotechnology

Effect of grain size on high strain rate deformation of rolled Mg-4Y-3RE alloy in compression

H. Asgari et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2015)

添加到收藏夹

Article Nanoscience & Nanotechnology

Enhanced mechanical properties due to grain refinement and texture modification in an AZ61 Mg alloy processed by small strain impact forging

M. G. Jiang et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2015)

添加到收藏夹

Article Materials Science, Multidisciplinary

The precipitation behavior of a pretwinned Mg-6Al-1Zn alloy and the effect on subsequent deformation

Yin Zhang et al.

JOURNAL OF MATERIALS RESEARCH (2014)

添加到收藏夹

Review Materials Science, Multidisciplinary

Improvement of formability and mechanical properties of magnesium alloys via pre-twinning: A review

Bo Song et al.

MATERIALS & DESIGN (2014)

添加到收藏夹

Article Materials Science, Multidisciplinary

Strengthening mechanisms in a high-strength bulk nanostructured Cu-Zn-Al alloy processed via cryomilling and spark plasma sintering

Haiming Wen et al.

ACTA MATERIALIA (2013)

添加到收藏夹

Article Multidisciplinary Sciences

Periodic Segregation of Solute Atoms in Fully Coherent Twin Boundaries

J. F. Nie et al.

SCIENCE (2013)

添加到收藏夹

Article Materials Science, Multidisciplinary

Softening and dynamic recrystallization in magnesium single crystals during c-axis compression

Talal Al-Samman et al.

ACTA MATERIALIA (2012)

添加到收藏夹

Article Materials Science, Multidisciplinary

The relation between ductility and stacking fault energies in Mg and Mg-Y alloys

S. Sandloebes et al.

ACTA MATERIALIA (2012)

添加到收藏夹

Article Nanoscience & Nanotechnology

Tailoring the texture of magnesium alloy by twinning deformation to improve the rolling capability

Yunchang Xin et al.

SCRIPTA MATERIALIA (2011)

添加到收藏夹

Article Chemistry, Physical

Effects of rare-earth elements Gd and Y on the solid solution strengthening of Mg alloys

L. Gao et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2009)

添加到收藏夹

Article Materials Science, Multidisciplinary

Strain hardening behaviour and the Taylor factor of pure magnesium

C. H. Caceres et al.

PHILOSOPHICAL MAGAZINE (2008)

添加到收藏夹

Article Chemistry, Physical

Microstructure and strengthening mechanism of high strength Mg-10Gd-2Y-0.5Zr alloy

S. M. He et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2007)

添加到收藏夹

Article Materials Science, Multidisciplinary

Early stages of precipitation and microstructure control in Mg-rare earth alloys

C. Antion et al.

PHILOSOPHICAL MAGAZINE (2006)

添加到收藏夹

Article Materials Science, Multidisciplinary

Geometrical c-Titerion for the activation of prismatic slip in AZ61 Mg alloy sheets deformed at room temperature

J Koike et al.

ACTA MATERIALIA (2005)

添加到收藏夹

Article Materials Science, Multidisciplinary

An alternative physical explanation of the Hall-Petch relation

V Bata et al.

ACTA MATERIALIA (2004)

添加到收藏夹

Article Nanoscience & Nanotechnology

Hall-Petch relation and boundary strengthening

N Hansen

SCRIPTA MATERIALIA (2004)

添加到收藏夹

Article Nanoscience & Nanotechnology

Geometrically necessary dislocations and strain-gradient plasticity: a few critical issues

LP Kubin et al.

SCRIPTA MATERIALIA (2003)

添加到收藏夹

Article Materials Science, Multidisciplinary

Characterisation of strengthening precipitate phases in a Mg-Y-Nd alloy

JF Nie et al.

ACTA MATERIALIA (2000)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.