☆ 4.1 Article

Reacting flow analysis in scramjet engine: effect of mass flow rate of fuel and flight velocity

INTERNATIONAL JOURNAL OF TURBO & JET-ENGINES (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Thermodynamics

Evaluation of Fuel and Air Mixing in a Scramjet Engine Using an Asymmetric Strut-Based Fuel Injection Using CFD

Tushar Kant Swain et al.

Summary: This paper proposes and investigates a new asymmetric strut-based fuel injection for enhanced fuel-air mixing and combustion in supersonic combustors. The asymmetry in the strut creates vortices along the Z-axis, resulting in improved mixing. The presence of vortices significantly increases the mixing and combustion efficiency.

COMBUSTION SCIENCE AND TECHNOLOGY (2022)

添加到收藏夹

Article Thermodynamics

The non-reacting flow characteristics of pylon and wall injections in a dual combustion ramjet engine

J. Sarathkumar Sebastin et al.

Summary: The influence of pylon and wall injection on coaxial jets in a Dual Combustion Ramjet engine has been numerically investigated. Pylon injection provides better spatial distribution of fuel but results in higher total pressure loss within the supersonic combustor compared to wall injection. The study validated the numerical analysis with experimental data and observed shock wave interactions within the combustor.

INTERNATIONAL JOURNAL OF ENGINE RESEARCH (2022)

添加到收藏夹

Article Engineering, Multidisciplinary

The numerical investigation of combustion performance of scramjet combustor with variation in angle of attack

Kumari Ambe Verma et al.

Summary: This article involves a computational investigation of a parallel fuel injection based scramjet combustor. By validating the selected geometry and changing the angle of attack of the incoming air, the variations in combustion efficiency are analyzed. The study results indicate that the performance of the scramjet combustor is primarily influenced by the geometry configuration and the nature of flow of incoming air.

RESULTS IN ENGINEERING (2022)

添加到收藏夹

Article Thermodynamics

Numerical Study on the Effect of Jet on the Operation of Powder Fuel Scramjet

H. M. Ding et al.

Summary: Metal powder fuel is an excellent power fuel for future hypersonic aircraft due to its high energy and volume calorific values. Introducing a primary jet upstream of the powder fuel inlet can effectively improve the mixing degree of fuel and air, and prolong the residence time of particles in the combustion chamber. However, increasing the mass flow rate of the primary jet results in a peak and subsequent decrease in combustion efficiency and engine thrust.

JOURNAL OF APPLIED FLUID MECHANICS (2022)

添加到收藏夹

Article Energy & Fuels

Hydrogen fueled scramjet combustor with a wavy-wall double strut fuel injector

Obula Reddy Kummitha et al.

Summary: The global demand for enhanced scramjet engine performance is increasing, with the main challenge being the mixing of fuel and air. Research has shown that using a wavy wall surface and double strut fuel injector can significantly improve mixing efficiency and combustion phenomenon.

FUEL (2021)

添加到收藏夹

Article Energy & Fuels

The Combustion Characteristics of Double Ramps in a Strut-Based Scramjet Combustor

A. Antony Athithan et al.

Summary: This paper investigates the influence of ramps located upstream of a strut-based scramjet combustor under reacting flow conditions. The numerical results are validated with experimental values, showing compliance within the range, and the shock reflection due to the ramps enhances hydrogen distribution in the spatial direction, while lowering the combustion ignition delay time.

ENERGIES (2021)

添加到收藏夹

Article Thermodynamics

Experimental study of kerosene supersonic combustion with pilot hydrogen and fuel additive under low flight mach conditions

Feiteng Luo et al.

Summary: This paper experimentally studied liquid kerosene ignition and combustion with pilot hydrogen and fuel additive in a model supersonic combustor under simulated conditions of flight Mach 3.8-4.0. It was found that an appropriate amount of fuel additive can significantly enhance kerosene supersonic combustion and temperature rises, leading to mode transition from transonic to subsonic. The concentration of additive and hydrogen addition play important roles in improving combustor performance, while excessive amounts may lower combustion efficiency.

ENERGY (2021)

添加到收藏夹

Article Engineering, Mechanical

Significance of fluid flow characteristics in the hydrogen-fuelled scramjet combustor using flame stabilisation analysis

S. K. Gugulothu

Summary: Research on fluid flow dynamics of supersonic combustion ramjet engines focuses on improving combustion efficiency by studying the effects of injection temperature, wall pressure, formation of compressed wave train, and different modes of fuel injection. Transition to desired mode can be achieved through enhancement of injection pressure and reduction of temperature, whereas transverse injection of fuel may reduce combustion efficiency and hinder mode transition during horizontal injection.

AUSTRALIAN JOURNAL OF MECHANICAL ENGINEERING (2021)

添加到收藏夹

Article Engineering, Aerospace

Effects of pylon geometry on mixing enhancement in a scramjet pylon-cavity flameholder

A. Oamjee et al.

AERONAUTICAL JOURNAL (2020)

添加到收藏夹

Article Energy & Fuels

Impact of parametric variation on combustion characteristics of hydrogen-fueled strut based scramjet combustor at supersonic speed

Kumari Ambe Verma et al.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2020)

添加到收藏夹

Article Energy & Fuels

Large eddy simulation of turbulent supersonic hydrogen flames with OpenFOAM

Huangwei Zhang et al.

FUEL (2020)

添加到收藏夹

Article Engineering, Mechanical

Investigation of strut-ramp injector in a Scramjet combustor: Effect of strut geometry, fuel and jet diameter on mixing characteristics

Rahul Kumar Soni et al.

JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY (2017)

添加到收藏夹

Article Engineering, Aerospace

Large Eddy Simulation of the fuel transport and mixing process in a scramjet combustor with rearwall-expansion cavity

Zun Cai et al.

ACTA ASTRONAUTICA (2016)

添加到收藏夹

Article Thermodynamics

The model constant A of the eddy dissipation model

Peiyong Wang

PROGRESS IN COMPUTATIONAL FLUID DYNAMICS (2016)

添加到收藏夹

Article Engineering, Aerospace

Large eddy simulation of hydrogen/air scramjet combustion using tabulated thermo-chemistry approach

Cao Changmin et al.

CHINESE JOURNAL OF AERONAUTICS (2015)

添加到收藏夹

Article Engineering, Aerospace

Thermochemical exploration of hydrogen combustion in generic scramjet combustor

Malsur Dharavath et al.

AEROSPACE SCIENCE AND TECHNOLOGY (2013)

添加到收藏夹

Article Engineering, Mechanical

Experimental investigation of combustion mechanisms of kerosene-fueled scramjet engines with double-cavity flameholders

Yu Pan et al.

ACTA MECHANICA SINICA (2011)

添加到收藏夹

Article Multidisciplinary Sciences

Parametric effects on the combustion flow field of a typical strut-based scramjet combustor

Huang Wei et al.

CHINESE SCIENCE BULLETIN (2011)

添加到收藏夹

Article Computer Science, Interdisciplinary Applications

Numerical analysis of supersonic combustion ramjet with upstrearn fuel injection

R Savino et al.

INTERNATIONAL JOURNAL FOR NUMERICAL METHODS IN FLUIDS (2003)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.