☆ 4.7 Article

Simultaneous Effects of Hot Steam Injection and Surface Heating through an Embedded Channel of Steam Turbine Cascade

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Thermodynamics

Numerical modeling of droplets injection in the secondary flow of the wet steam ejector in the refrigeration cycle

Daryoush Dadpour et al.

Summary: This paper investigates the effects of droplets injection at secondary flow on the performance of the refrigeration cycle. The Eulerian-Eulerian method is used to simulate the flow, and the results are validated with experimental data. It is found that the wetness and number of droplets have an impact on the COP, T-outlet, and ER of the refrigeration cycle.

INTERNATIONAL JOURNAL OF REFRIGERATION (2022)

添加到收藏夹

Article Physics, Multidisciplinary

An applicable surface heating in a two-phase ejector refrigeration

Ahmad Jahani Rahvard et al.

Summary: This research investigates the effects of surface heating on ejector performance in a refrigeration system. By conducting flow simulation and analyzing parameters, the practical heat value and ejector performance indicators are obtained. The results show that surface heating can reduce wetness and entrainment ratio.

EUROPEAN PHYSICAL JOURNAL PLUS (2022)

添加到收藏夹

Article Thermodynamics

Numerical investigation of roughness effect on wet steam ejector performance in the refrigeration cycle

Mehdi Pouyan Rad et al.

Summary: This study investigates the influence of primary nozzle surface roughness on wet steam ejectors in the refrigeration cycle. The Eulerian-Eulerian model is validated and the effect of different surface roughness on the flow is shown. The results indicate that increasing roughness shifts the shock chain, weakens shock strength, and increases temperature. Moreover, an increase in primary nozzle surface roughness decreases the efficiency ratio and cooling capacity of the refrigeration cycle.

HEAT AND MASS TRANSFER (2022)

添加到收藏夹

Article Thermodynamics

Analysis of Heterogeneous Nucleation and Erosion Behavior Considering the Injection of Impurities into Wet Steam Flow Using Poly-dispersed Method

Amir Momeni Dolatabadi et al.

Summary: Solid salt injection in steam turbines can cause heterogeneous nucleation, leading to changes in turbine operation and power. This study calculates and considers the effects of heterogeneous nucleation by injecting NaCl into wet-steam flow parameters, erosion rate, and turbine power. Numerical results show a reduction in condensation shock, a decrease in erosion rate, and an increase in steam turbine power due to the presence of solid particles.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2022)

添加到收藏夹

Article Thermodynamics

The droplets and film behaviors in supersonic separator by using three-field two-fluid model with heterogenous condensation

Hongbing Ding et al.

Summary: In this study, a novel three-field two-fluid model for supersonic separator considering heat and mass transfer was developed. The model was validated and revealed important parameters such as slip velocity, latent heat, film thickness, and temperature. The study provides valuable insights for the design of supersonic separators.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2022)

添加到收藏夹

Article Physics, Multidisciplinary

Investigation of the effect of water droplet injection on condensation flow of different nozzles geometry

Esmail Lakzian et al.

Summary: This study compared the effects of droplet injection on Moore A (MA) and De Laval nozzles, finding that droplet injection can weaken the condensation shock in the MA nozzle and eliminate the shock in the De nozzle. Additionally, spraying droplets can increase the Mach number at the nozzle output and have varying effects on the wetness fraction.

EUROPEAN PHYSICAL JOURNAL PLUS (2022)

添加到收藏夹

Article Thermodynamics

Investigating the wet-to-dry expansion of organic fluids for power generation

Martin T. White

Summary: The successful conversion of waste heat into electricity requires the development of new, innovative power cycles. The wet-to-dry cycle, which allows the working fluid to transition across the saturation dome during expansion, has shown significant thermodynamic advantages. However, the feasibility of achieving wet-to-dry expansion with non-equilibrium effects has not been established. This study introduces a method to assess the thermodynamic potential of a fluid for the wet-to-dry cycle, and presents a nozzle design tool that accounts for non-equilibrium effects. The results confirm the potential of the wet-to-dry cycle to enhance waste-heat recovery systems. Further investigation, including experimental research, is needed to explore this concept.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2022)

添加到收藏夹

Article Thermodynamics

Unsteady non-equilibrium condensation flow of 3-D wet steam stage of steam turbine with mesh method

Hongbing Ding et al.

Summary: This research develops a non-equilibrium condensation model with sliding mesh technology to solve the unsteady condensing flow inside a 3D wet steam stage of a steam turbine. The results quantitatively evaluate the condensation loss and entropy generation considering off-design operation and rough blades, and identify the occurrence of secondary expansion and condensation near the rotor trailing edge.

INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2022)

添加到收藏夹

Article Thermodynamics

Optimization of the pitch to chord ratio for a cascade turbine blade in wet steam flow

Mohammad Reza Aghdasi et al.

Summary: This study used genetic algorithm for shape optimization and obtained the suitable pitch to axial chord ratio for a cascade turbine blade. The modification of the Zweifel coefficient was innovatively employed to improve the performance of wet steam flow passing through the steam turbine cascade.

APPLIED THERMAL ENGINEERING (2022)

添加到收藏夹

Article Thermodynamics

Experimental and numerical research on the effect of the inlet steam superheat degree on the spontaneous condensation in the IWSEP nozzle

Guojie Zhang et al.

Summary: This study experimentally and numerically investigated the effect of inlet steam superheat degree on steam condensing flow through the IWSEP nozzle, providing new experimental data for validating numerical models. The results show that the condensation model using the Benson surface tension model can accurately predict the spontaneous condensation process with an error of less than 5%.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2021)

添加到收藏夹

Article Thermodynamics

A blackbox optimization of volumetric heating rate for reducing the wetness of the steam flow through turbine blades

Davood Hoseinzade et al.

Summary: This paper proposes using blackbox optimization to obtain the optimal volumetric heating required to reduce wetness at the last stages of steam turbines, achieving improved turbine performance by optimizing the volumetric heating rate. The numerical results show that the optimal rate can significantly enhance turbine performance by improving droplet number and average radius.

ENERGY (2021)

添加到收藏夹

Article Environmental Studies

Dynamic frequency relationships and volatility spillovers in natural gas, crude oil, gas oil, gasoline, and heating oil markets: Implications for portfolio management

Walid Mensi et al.

Summary: This study examines the volatility spillovers among energy futures markets during the global financial crisis, oil crisis, and COVID-19 pandemic crisis. Results show significant risk spillovers among the major energy futures markets, with natural gas offering better diversification benefits in the short term. The optimal weight, hedge ratios, and hedging effectiveness vary over time and are sensitive to crises, providing important implications for energy traders and policymakers.

RESOURCES POLICY (2021)

添加到收藏夹

Article Thermodynamics

Optimization volumetric heating in condensing steam flow by a novel method

Reza Hosseini et al.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2020)

添加到收藏夹

Article Thermodynamics

A comprehensive investigation of finding the best location for hot steam injection into the wet steam turbine blade cascade

Mohammad Ali Faghih Aliabadi et al.

ENERGY (2020)

添加到收藏夹

Article Thermodynamics

Prediction of non-equilibrium homogeneous condensation in supersonic nozzle flows using Eulerian-Eulerian models

Jabir Edathol et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2020)

添加到收藏夹

Article Thermodynamics

Numerical study on two-phase expansion performance and quantitative analysis of wetness loss in cryogenic turbo-expander

Lu Niu et al.

CRYOGENICS (2020)

添加到收藏夹

Article Thermodynamics

Numerical approaches for moist air condensing flows modelling in the transonic regime

P. Wisniewski et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2020)

添加到收藏夹

Article Thermodynamics

Numerical investigation of wet inflow in steam turbine cascades using NURBS-based mesh generation method

Amir Ebrahimi-Fizik et al.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2020)

添加到收藏夹

Article Engineering, Chemical

Investigation on the erosion characteristics of martensitic blade steel material 1Cr12W1MoV by micro-particle swarm with high velocity

Juan Di et al.

POWDER TECHNOLOGY (2019)

添加到收藏夹

Article Thermodynamics

Entropy generation and exergy destruction in condensing steam flow through turbine blade with surface roughness

Hongbing Ding et al.

ENERGY CONVERSION AND MANAGEMENT (2019)

添加到收藏夹

Article Thermodynamics

Visualization experimental study of the condensing flow regime in the transonic mixing process of desalination-oriented steam ejector

Yongzhi Tang et al.

ENERGY CONVERSION AND MANAGEMENT (2019)

添加到收藏夹

Article Mechanics

Control of wetness fraction and liquid droplet size in wet steam two phase flows with hot steam injection

Mohadeseh Sadat Mirhoseini et al.

MECCANICA (2018)

添加到收藏夹

Article Thermodynamics

Investigating the entropy generation in condensing steam flow in turbine blades with volumetric heating

Masoud Vatanmakan et al.

ENERGY (2018)

添加到收藏夹

Article Thermodynamics

Local heat transfer of vortex cooling with multiple tangential nozzles in a gas turbine blade leading edge cooling passage

Xiaojun Fan et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2018)

添加到收藏夹

Article Thermodynamics

Effect of wall surface roughness on condensation shock

Aditya Pillai et al.

INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2018)

添加到收藏夹

Article Thermodynamics

Multi-objective optimization of hot steam injection variables to control wetness parameters of steam flow within nozzles

Mohadeseh Sadat Mirhoseini et al.

ENERGY (2017)

添加到收藏夹

Article Thermodynamics

Two-fluid model with droplet size distribution for condensing steam flows

Wlodzimierz Wroblewski et al.

ENERGY (2016)

添加到收藏夹

Article Thermodynamics

Effects of surface roughness on deviation angle and performance losses in wet steam turbines

H. Bagheri Esfe et al.

APPLIED THERMAL ENGINEERING (2015)

添加到收藏夹

Article Thermodynamics

Online application oriented calculation of the exhaust steam wetness fraction of the low pressure cylinder in thermal power plant

Liang Xu et al.

APPLIED THERMAL ENGINEERING (2015)

添加到收藏夹

Article Thermodynamics

Influence of turbulence modelling on non-equilibrium condensing flows in nozzle and turbine cascade

Yogini Patel et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2015)

添加到收藏夹

Article Multidisciplinary Sciences

Effect of Inlet and Outlet Flow Conditions on Natural Gas Parameters in Supersonic Separation Process

Yan Yang et al.

PLOS ONE (2014)

添加到收藏夹

Article Thermodynamics

Development of Moisture Loss Models in Steam Turbines

Hiroyuki Kawagishi et al.

HEAT TRANSFER-ASIAN RESEARCH (2013)

添加到收藏夹

Article Materials Science, Multidisciplinary

Numerical analysis of spontaneously condensing phenomena in nozzle of steam-jet vacuum pump

Xiao-Dong Wang et al.

VACUUM (2012)

添加到收藏夹

Article Engineering, Chemical

Modeling of H2O/D2O Condensation in Supersonic Nozzles

Somnath Sinha et al.

AEROSOL SCIENCE AND TECHNOLOGY (2009)

添加到收藏夹

Article Engineering, Mechanical

Erosion-fatigue of steam turbine blades

C. R. F. Azevedo et al.

ENGINEERING FAILURE ANALYSIS (2009)

添加到收藏夹

Article Thermodynamics

Film cooling on a gas turbine blade pressure side or suction side with axial shaped holes

Zhihong Gao et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2008)

添加到收藏夹

Article Thermodynamics

Effects of Hot Steam Injection from the Slot at the Trailing Edge on Turbine Nozzle Vane Flow Field

Liang Xu et al.

JOURNAL OF THERMAL SCIENCE (2008)

添加到收藏夹

Article Engineering, Mechanical

Classical nucleation theory and its application to condensing steam flow calculations

F Bakhtar et al.

PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE (2005)

添加到收藏夹

Article Mechanics

Solution of the general dynamic equation along approximate fluid trajectories generated by the method of moments

R Hagmeijer et al.

PHYSICS OF FLUIDS (2005)

添加到收藏夹

Article Thermodynamics

Film-cooling effectiveness on a gas turbine blade tip using pressure-sensitive paint

J Ahn et al.

JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME (2005)

添加到收藏夹

Article Engineering, Mechanical

Development of a water droplet erosion model for large steam turbine blades

BE Lee et al.

KSME INTERNATIONAL JOURNAL (2003)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.