☆ 4.7 Article

A double-glazed solar air-phase change material collector for nocturnal heating: Model development and sensitivity analysis

ENERGY AND BUILDINGS (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Energy & Fuels

A new operating model for improving thermal efficiency of double-glazed solar air-phase change material collector: An experimental study

Li Yang et al.

Summary: An experiment was conducted on a double-glazed solar air-phase change material (PCM) collector to improve the thermal efficiency of heat storage type solar air collectors. A new operating model that performs air heating simultaneously in the energy storage stage was proposed.

JOURNAL OF ENERGY STORAGE (2023)

添加到收藏夹

Article Energy & Fuels

Application and analysis of flip mechanism in the melting process of a triplex-tube latent heat energy storage unit

Fangfei Li et al.

Summary: In this study, the flip mechanism is applied to improve the characteristics of uneven melting in the melting process of the triplex-tube latent heat energy storage unit. Numerical simulation is used and verified by experimental data. The results show that a single flip can significantly improve the melting performance of the unit under different dimensionless times. However, the flip has a negative effect on the total heat absorption in one melting cycle. The addition of flip effectively reduces the negative influence of the hard-to-melt zone during the melting process.

ENERGY REPORTS (2023)

添加到收藏夹

Article Construction & Building Technology

Experimental and numerical study of PCM storage integrated with HVAC system for energy flexibility

Yue Hu et al.

Summary: This paper presents experimental and numerical studies on PCM storage integrated with an HVAC system. The research found that the temperature effectiveness of the PCM storage depends more on the PCM quantity rather than the discharge inlet air temperature and airflow rate. Additionally, the study concluded that the energy cost can be reduced by implementing PCM storage while maintaining indoor thermal comfort, with a payback time of seven years compared to HVAC system without PCM.

ENERGY AND BUILDINGS (2022)

添加到收藏夹

Article Green & Sustainable Science & Technology

Experimental investigation of an enhanced transpired air solar collector with embodied phase changing materials

Cristiana Croitoru et al.

Summary: This study investigates an innovative enhanced solar air collector with integrated phase changing materials (PCM) through experimental approach, aiming to increase the operating period and overall efficiency. The experimental data shows that the collector with PCM can achieve a higher temperature increase of 8.8% and a higher coefficient of performance by 10.6% compared to the collector without PCM. Additionally, the collector with PCM has a longer operating time and a higher coefficient of performance.

JOURNAL OF CLEANER PRODUCTION (2022)

添加到收藏夹

Article Construction & Building Technology

Application of phase change materials in building components and the use of nanotechnology for its improvement

Kwok Wei Shah et al.

Summary: Phase change materials with significant latent heat of phase transition have been widely used for thermal storage applications, and nanotechnology has been incorporated to improve their performance and compatibility for efficient thermal regulation in buildings.

ENERGY AND BUILDINGS (2022)

添加到收藏夹

Article Energy & Fuels

Design and thermal performance evaluation of a new solar air collector with comprehensive consideration of five factors of phase-change materials

Wentao Hu et al.

Summary: In this study, a new solar air collector model with a heat storage device was designed to solve the issue of solar energy intermittency. Comparative analysis showed that the new model had good performance in terms of heat storage time, heat release time, and heat peak migration, which can help address the contradiction between solar energy intermittency and user's heating demands.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2022)

添加到收藏夹

Article Green & Sustainable Science & Technology

Effect of using a solar hot air collector installed on the inclined roof of a building for cooling and heating system in the presence of polymeric PCM

Saeed Alqaed

Summary: This paper investigates the effect of using a polymeric phase change material (PCM) in a solar hot air collector on residential heating and cooling. The results show that increasing the collector length can raise the outflow air temperature, and the inlet air temperature has a significant effect on the outlet temperature. The use of PCM can reduce the outlet air temperature in the early hours of the day but enhance it in the last hours of the day. The system can heat a 95-m2 residential unit and provide 41% of the energy required.

SUSTAINABLE ENERGY TECHNOLOGIES AND ASSESSMENTS (2022)

添加到收藏夹

Article Materials Science, Composites

Polyimide/boron nitride composite aerogel fiber-based phase-changeable textile for intelligent personal thermoregulation

Qiaoran Zhang et al.

Summary: Polyimide/boron nitride composite aerogel fibers with high thermal conductivity and porosity were prepared for phase-changeable textiles, showing quick thermal response and liquid leakage prevention. The resulting PI-BN/PEG textile exhibited high thermal conductivity, enthalpy, and work stability, with potential for personal thermal management.

COMPOSITES SCIENCE AND TECHNOLOGY (2022)

添加到收藏夹

Article Energy & Fuels

Thermal management of a battery pack using a layer of phase change material around the batteries: Changes in the airflow through the battery

Mohammed N. Ajour et al.

Summary: This study uses numerical simulation to investigate the relationship between the temperature change of phase change materials in battery packs with Reynolds number and time. The results show that ambient temperature cannot control the battery temperature, while the output air temperature decreases with increasing Reynolds number, and extending the time can reduce the amount of molten material.

JOURNAL OF ENERGY STORAGE (2022)

添加到收藏夹

Article Green & Sustainable Science & Technology

Robust, double-layered phase-changing microcapsules with superior solar-thermal conversion capability and extremely high energy storage density for efficient solar energy storage

Shunpan Yuan et al.

Summary: The novel double layered organic phase-changing microcapsules designed in this study showed extremely high phase change enthalpies and excellent thermal durability. Solar irradiation experiments indicated a significant improvement in solar-thermal conversion efficiency. The introduction of polydopamine effectively reduced leakage rate and strengthened the shell layer of the microcapsules, showing great potential for efficient solar energy storage.

RENEWABLE ENERGY (2021)

添加到收藏夹

Article Energy & Fuels

Performance investigation of a passive battery thermal management system applied with phase change material

Yanan Wang et al.

Summary: An effective thermal management system for lithium-ion batteries is crucial to control the temperature and increase the safety of the batteries. The use of phase change material units can effectively decrease the maximum temperature and temperature difference within the battery, providing good heat storage and temperature equalization capabilities. Further investigation into the design parameters of the phase change material unit can optimize the performance of the thermal management system.

JOURNAL OF ENERGY STORAGE (2021)

添加到收藏夹

Review Energy & Fuels

A comprehensive review of heat transfer intensification methods for latent heat storage units

Raja Elarem et al.

Summary: Latent heat thermal energy storage (LHTES) systems are crucial for the development of energy science and engineering, with efficiency depending on the thermal conductivity of phase change materials (PCMs) and heat transfer mechanisms. This review focuses on enhancing heat transfer in LHTES systems through various methods, such as applying nanomaterials additives and using cascaded or encapsulated PCMs. The study also discusses the designs of PCM-based heat exchangers with active and passive heat transfer techniques to improve the efficiency of LHTES systems.

ENERGY STORAGE (2021)

添加到收藏夹

Article Green & Sustainable Science & Technology

Discharge of a composite metal foam/phase change material to air heat exchanger for a domestic thermal storage unit

Pouyan Talebizadeh Sardari et al.

RENEWABLE ENERGY (2020)

添加到收藏夹

Article Thermodynamics

Thermal performance evaluation of glass window combining silica aerogels and phase change materials for cold climate of China

Dong Li et al.

APPLIED THERMAL ENGINEERING (2020)

添加到收藏夹

Article Thermodynamics

Thermal performance of dual S-channel air-type phase change energy storage device

Kailiang Huang et al.

APPLIED THERMAL ENGINEERING (2020)

添加到收藏夹

Article Energy & Fuels

Photo-to-thermal conversion and energy storage of lauric acid/expanded graphite composite phase change materials

Li Yang et al.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2020)

添加到收藏夹

Article Construction & Building Technology

Comparative study of solar hot air heating systems with phase change materials in plateau areas

Rui Fan et al.

ENERGY AND BUILDINGS (2020)

添加到收藏夹

Article Construction & Building Technology

Study on heat transfer performance of a solar double-slope PCM glazed roof with different physical parameters

Qianjun Mao et al.

ENERGY AND BUILDINGS (2020)

添加到收藏夹

Article Thermodynamics

Development of paraffin wax as phase change material based latent heat storage in heat exchanger

Ruslan Sabah Abdulrahman et al.

APPLIED THERMAL ENGINEERING (2019)

添加到收藏夹

Review Energy & Fuels

Opportunities and challenges of PCM-to-air heat exchangers (PAHXs) for building free cooling applications-A comprehensive review

Mohamed Dardir et al.

JOURNAL OF ENERGY STORAGE (2019)

添加到收藏夹

Article Construction & Building Technology

Simulation and performance analysis of an active PCM-heat exchanger intended for building operation optimization

Navid Morovat et al.

ENERGY AND BUILDINGS (2019)

添加到收藏夹

Article Energy & Fuels

Development of PCM-to-air heat exchanger for integration in building envelope-modeling and validation

Mohamed Dardir et al.

SOLAR ENERGY (2019)

添加到收藏夹

Article Construction & Building Technology

Experimental and mathematical modeling of an air-PCM heat exchanger operating under static and dynamic loads

Gohar Gholamibozanjani et al.

ENERGY AND BUILDINGS (2019)

添加到收藏夹

Article Thermodynamics

Comparative study based on energy and exergy analyses of a baffled solar air heater with latent storage collector

Amir Ghiami et al.

APPLIED THERMAL ENGINEERING (2018)

添加到收藏夹

Article Green & Sustainable Science & Technology

Thermal behavior of indirect solar dryer: Nocturnal usage of solar air collector with PCM

Aymen El Khadraoui et al.

JOURNAL OF CLEANER PRODUCTION (2017)

添加到收藏夹

Article Thermodynamics

Solar air heater with phase change material: An energy analysis and a comparative study

Aymen El Khadraoui et al.

APPLIED THERMAL ENGINEERING (2016)

添加到收藏夹

Article Energy & Fuels

Air-PCM heat exchanger for peak load management: Experimental and simulation

N. Stathopoulos et al.

SOLAR ENERGY (2016)

添加到收藏夹

Article Construction & Building Technology

Expanding Heisler chart to characterize heat transfer phenomena in a building envelope integrated with phase change materials

Arash Bastani et al.

ENERGY AND BUILDINGS (2015)

添加到收藏夹

Article Construction & Building Technology

Optimization of an Air-PCM heat exchanger and elaboration of peak power reduction strategies

Mohamed El Mankibi et al.

ENERGY AND BUILDINGS (2015)

添加到收藏夹

Article Construction & Building Technology

Design of a PCM to air heat exchanger using dimensionless analysis: Application to electricity peak shaving in buildings

Frederic Kuznik et al.

ENERGY AND BUILDINGS (2015)

添加到收藏夹

Review Green & Sustainable Science & Technology

Designing building envelope with PCM wallboards: Design tool development

Arash Bastani et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2014)

添加到收藏夹

Article Construction & Building Technology

Coupled TRNSYS-CFD simulations evaluating the performance of PCM plate heat exchangers in an airport terminal building displacement conditioning system

B. L. Gowreesunker et al.

BUILDING AND ENVIRONMENT (2013)

添加到收藏夹

Review Green & Sustainable Science & Technology

A review on phase change materials integrated in building walls

Frederic Kuznik et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2011)

添加到收藏夹

Review Green & Sustainable Science & Technology

Review on thermal energy storage with phase change materials and applications

Atul Sharma et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2009)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.