☆ 4.5 Article

Thermoelectric Field Analysis of Trapezoidal Thermoelectric Generator Based on the Explicit Analytical Solution of Annular Thermoelectric Generator

ENERGIES (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Chemistry, Physical

High-performance in n-type PbTe-based thermoelectric materials achieved by synergistically dynamic doping and energy filtering

Hang-Tian Liu et al.

Summary: By introducing Ag2Te and dynamically doping silver into n-type Pb0.975Cr0.025Te, a peak figure of merit of 1.5 at 773K was achieved. The high value is attributed to the synergistic optimization of carrier and phonon transports. Ag2Te nanoprecipitates establish coherent interfaces with the matrix to induce energy-dependent carrier scattering and maintain relatively high carrier mobility, leading to optimal electrical-transport properties over a wide temperature range.

NANO ENERGY (2022)

添加到收藏夹

Article Green & Sustainable Science & Technology

Achieving extensive lossless coupling of photovoltaic and thermoelectric devices through parallel connection

Ershuai Yin et al.

Summary: This paper investigates lossless coupling methods for photovoltaic and thermoelectric devices in hybrid systems. The performance of three connection modes (electrically separated, series, and parallel) are experimentally compared, and the electrical-thermal interaction characteristics are investigated with theoretical methods. The results demonstrate that parallel connection achieves extensive lossless coupling and is more stable compared to series connection.

RENEWABLE ENERGY (2022)

添加到收藏夹

Article Green & Sustainable Science & Technology

Stochastic-Weighted Robust Optimization Based Bilayer Operation of a Multi-Energy Building Microgrid Considering Practical Thermal Loads and Battery Degradation

Zhengmao Li et al.

Summary: This paper proposes a bilayer coordinated operation scheme for the multi-energy building microgrid (MEBM) that considers comprehensive uncertainty sources. The approach utilizes a building model and a bilayer model to manage uncertainties and numerical case studies demonstrate its effectiveness.

IEEE TRANSACTIONS ON SUSTAINABLE ENERGY (2022)

添加到收藏夹

Article Multidisciplinary Sciences

High figure-of-merit and power generation in high-entropy GeTe-based thermoelectrics

Binbin Jiang et al.

Summary: By manipulating the localization of electrons and phonons through entropy manipulation, we provide a new approach to improve the performance of high-entropy thermoelectric materials.

SCIENCE (2022)

添加到收藏夹

Article Green & Sustainable Science & Technology

Economic configuration optimization of onboard annual thermoelectric generators under multiple operating conditions

WenChao Zhu et al.

Summary: This paper establishes an advanced non-isothermal mathematical model of automobile annular thermoelectric generators (ATEGs) using the finite element method. The effects of different vehicle operating conditions on the optimal thermoelectric semiconductor volume are investigated, and the optimal range for selecting the thermocouple volume is determined. Two new schemes are proposed to optimize the system configuration and a new method for assessing the power generation cost is proposed. The optimal design is obtained and the results show its advantages in net power and efficiency.

RENEWABLE ENERGY (2022)

添加到收藏夹

Article Thermodynamics

A novel proposed flexible thin-film solar annular thermoelectric generator

Yan Cao et al.

Summary: This paper proposes a thin-film flexible annular solar thermoelectric generator for curved and variable surfaces, and conducts a comprehensive simulation to investigate the impact of various parameters on the generator's performance. The study reveals insights such as the optimal number of legs and inner radius for maximizing output power.

APPLIED THERMAL ENGINEERING (2021)

添加到收藏夹

Article Engineering, Electrical & Electronic

Approximate Analytical Solution to the Temperature Field in Annular Thermoelectric Generator Made of Temperature- Dependent Material

Wei Niu et al.

Summary: This paper investigates the efficiency of annular thermoelectric generators (ATEG) considering temperature-dependent material parameters, proposing a power series iteration approximation (PSIA) method to solve the weak nonlinear thermoelectric coupling equation. The results show that the PSIA solution in the cylindrical coordinate system has high precision and rapid convergence, effectively addressing the impact of temperature-dependent material parameters.

IEEE TRANSACTIONS ON ELECTRON DEVICES (2021)

添加到收藏夹

Article Green & Sustainable Science & Technology

Economic Dispatch of Integrated Energy Systems With Robust Thermal Comfort Management

Shuai Lu et al.

Summary: This article comprehensively models the uncertainties affecting the thermal comfort of end-users in the HE-IESs and proposes a two-stage adaptive robust economic dispatch (ARED) model with a robust thermal comfort management strategy, demonstrating the effectiveness of the approach through simulation results.

IEEE TRANSACTIONS ON SUSTAINABLE ENERGY (2021)

添加到收藏夹

Article Nanoscience & Nanotechnology

Theoretical analysis of annular thermoelectric generators made of functionally graded materials

Wei Niu et al.

Summary: This study investigates the temperature field distribution and thermoelectric conversion efficiency of annular thermoelectric generators with functionally graded materials. Using the power series method, numerical studies were conducted on FGM TE generators with different variations in material parameters, providing theoretical guidance for optimization of such generators. The results showed that material parameters play a significant role in the efficiency of the generators.

AIP ADVANCES (2021)

添加到收藏夹

Article Thermodynamics

An optimized design approach concerning thermoelectric generators with frustum-shaped legs based on three-dimensional multiphysics model

Xuejian Wang et al.

Summary: This paper presents a size-optimized scheme of thermoelectric generator with frustum-shaped legs to improve output electrical performance and energy conversion efficiency, validated through experiments and self-built simulation models. Two optimization schemes are proposed to enhance output power without sacrificing conversion efficiency.

ENERGY (2021)

添加到收藏夹

Article Energy & Fuels

Performance comparison of annular and flat-plate thermoelectric generators for cylindrical hot source

Mengjun Zhang et al.

Summary: This study compares the performances of annular thermoelectric generator (ATEG) and flat-plate thermoelectric generator (FTEG) with varying inlet temperature, velocity, and convective heat transfer coefficient when applied to cylindrical heat sources. The results show that both the output power and conversion efficiency of ATEG and FTEG increase with higher inlet velocity, temperature, and convective heat transfer coefficient. ATEG consistently exhibits higher conversion efficiency than FTEG, especially when the inlet temperature and/or convective heat transfer coefficient are relatively larger.

ENERGY REPORTS (2021)

添加到收藏夹

Article Energy & Fuels

Experimental investigation of a novel heat pipe thermoelectric generator for waste heat recovery and electricity generation

Simiao Tang et al.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2020)

添加到收藏夹

Article Engineering, Electrical & Electronic

Power Series Iterative Approximation Solution to the Temperature Field in Thermoelectric Generators Made of a Functionally Graded Temperature-Dependent Material

Xiaoshan Cao et al.

JOURNAL OF ELECTRONIC MATERIALS (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

A Textile-Integrated Polymer Thermoelectric Generator for Body Heat Harvesting

Hend M. Elmoughni et al.

ADVANCED MATERIALS TECHNOLOGIES (2019)

添加到收藏夹

Article Engineering, Electrical & Electronic

Analysis of Thermoelectric Generators with General Material Property Variations

X. S. Cao et al.

JOURNAL OF ELECTRONIC MATERIALS (2019)

添加到收藏夹

Article Thermodynamics

A new design of solar thermoelectric generator with combination of segmented materials and asymmetrical legs

Hai-Bo Liu et al.

ENERGY CONVERSION AND MANAGEMENT (2018)

添加到收藏夹

Article Thermodynamics

Thermoelectric heat recovery from glass melt processes

Kazuaki Yazawa et al.

ENERGY (2017)

添加到收藏夹

Article Thermodynamics

Enhanced performance thermoelectric module having asymmetrical legs

A. Fabian-Mijarigos et al.

ENERGY CONVERSION AND MANAGEMENT (2017)

添加到收藏夹

Article Physics, Applied

Thermoelectric ZT enhanced by asymmetric configuration in single-molecule-magnet junctions

Pengbin Niu et al.

JOURNAL OF PHYSICS D-APPLIED PHYSICS (2016)

添加到收藏夹

Article Engineering, Electrical & Electronic

Efficiency of a Sandwiched Thermoelectric Material with a Graded Interlayer and Temperature-Dependent Properties

T. T. Wallace et al.

JOURNAL OF ELECTRONIC MATERIALS (2016)

添加到收藏夹

Article Thermodynamics

Nominal power density analysis of thermoelectric pins with non-constant cross sections

Yaoguang Shi et al.

ENERGY CONVERSION AND MANAGEMENT (2015)

添加到收藏夹

Article Thermodynamics

Thermoelectric generator performance analysis: Influence of pin tapering on the first and second law efficiencies

B. S. Yilbas et al.

ENERGY CONVERSION AND MANAGEMENT (2015)

添加到收藏夹

Article Energy & Fuels

High fidelity finite difference model for exploring multi-parameter thermoelectric generator design space

Haiyan Fateh et al.

APPLIED ENERGY (2014)

添加到收藏夹

Article Thermodynamics

Investigation and design optimization of exhaust-based thermoelectric generator system for internal combustion engine

Zhiqiang Niu et al.

ENERGY CONVERSION AND MANAGEMENT (2014)

添加到收藏夹

Article Thermodynamics

Thermodynamic analysis of a thermoelectric power generator in relation to geometric configuration device pins

Haider Ali et al.

ENERGY CONVERSION AND MANAGEMENT (2014)

添加到收藏夹

Article Engineering, Electrical & Electronic

Energy Conversion Efficiency of an Exponentially Graded Thermoelectric Material

Zhi-He Jin et al.

JOURNAL OF ELECTRONIC MATERIALS (2014)

添加到收藏夹

Article Thermodynamics

Experiment on thermal uniformity and pressure drop of exhaust heat exchanger for automotive thermoelectric generator

Hongliang Lu et al.

ENERGY (2013)

添加到收藏夹

Article Nanoscience & Nanotechnology

Submicron Features in Higher Manganese Silicide

Yatir Sadia et al.

JOURNAL OF NANOMATERIALS (2013)

添加到收藏夹

Article Energy & Fuels

Multi-objective genetic algorithm optimization of thermoelectric heat exchanger for waste heat recovery

Simon Belanger et al.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2012)

添加到收藏夹

Article Engineering, Electrical & Electronic

Wireless sensor node powered by aircraft specific thermoelectric energy harvesting

D. Samson et al.

SENSORS AND ACTUATORS A-PHYSICAL (2011)

添加到收藏夹

Article Nanoscience & Nanotechnology

Nucleation of nanosize particles following the spinodal decomposition in the pseudo-ternary Ge0.6Sn0.1Pb0.3Te compound

Boaz Dado et al.

SCRIPTA MATERIALIA (2010)

添加到收藏夹

Review Thermodynamics

Review of recent advances of radioisotope power systems

Robert G. Lange et al.

ENERGY CONVERSION AND MANAGEMENT (2008)

添加到收藏夹

Article Materials Science, Multidisciplinary

High performance functionally graded and segmented Bi2Te3-based materials for thermoelectric power generation

VL Kuznetsov et al.

JOURNAL OF MATERIALS SCIENCE (2002)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.