☆ 4.7 Article

Role of protein in crevice corrosion of CoCrMo alloy: An investigation using wire beam electrodes

CORROSION SCIENCE (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Materials Science, Multidisciplinary

Crevice corrosion behaviors of CoCrMo alloy and stainless steel 316L artificial joint materials in physiological saline

Xin Huang et al.

Summary: The width of crevices has different effects on corrosion for different alloys, with narrower crevices leading to more severe corrosion. CoCrMo alloy does not exhibit typical crevice corrosion, but the exterior of the crevices shows varying degrees of corrosion due to mass transfer effect caused by different widths of the crevices.

CORROSION SCIENCE (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Corrosion propagation of steel reinforcement in pre-cracked mortar attacked by seawater using wire beam electrode

Guangyan Feng et al.

Summary: A novel custom-designed wire beam electrode (WBE) covered by uncracked and cracked mortar was used to study corrosion propagation behavior of steel reinforcement. The results demonstrated that the WBE technique can effectively monitor both passivation and pitting corrosion, especially the propagation process. It was also observed that cracks in the mortar can facilitate the initial corrosion of the steel reinforcement, and wider cracks dramatically enhance the corrosion tendency. The chloride distribution, which changes with increasing crack width, was found to primarily determine the corrosion propagation of the wire electrodes.

CORROSION SCIENCE (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

A discussion on evaluation criteria for crevice corrosion of various stainless steels

Xuan Wu et al.

Summary: The study investigates and compares the crevice corrosion performances of different stainless steels, suggesting that the behavior may be influenced by the phase composition of the materials. The introduction of critical chloride concentration measurement proves to be a valuable criterion for evaluating crevice corrosion in stainless steels.

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Electrochemical characterization of some cobalt base alloys in Ringer solution

C. M. Garcia-Falcon et al.

Summary: Biomaterials must be thoroughly studied to ensure they do not harm the human body and meet strict biocompatibility criteria. Cobalt-based alloys, particularly Co-Cr alloys, are preferred options in dentistry due to their biocompatibility, wear resistance, mechanical properties, and corrosion resistance. Investigating the microstructural characterization and corrosion behavior of Co-Cr dental alloys revealed a high passivation tendency and formation of protective layers that substantially improve their biocompatibility.

MATERIALS CHEMISTRY AND PHYSICS (2021)

添加到收藏夹

Article Engineering, Mechanical

Fretting crevice corrosion of 316 L stainless steel in physiological phosphate buffered saline: Load, potential and alloy counterface effects

Sachin A. Mali et al.

Summary: This study found that normal load and electrode potential have significant effects on fretting crevice corrosion and fretting initiated crevice corrosion of SS316L and its mix-alloy couples.

TRIBOLOGY INTERNATIONAL (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Crevice corrosion behavior of X70 steel in NaCl solution with different pH

J. Mu et al.

Summary: The crevice corrosion of X70 steel varies in different pH solutions, with pH=2 and pH=12 solutions promoting crevice corrosion while pH=6.8 solution prevents it. The increase of pH and Cl- inside crevice contribute to crevice corrosion in pH=2 solution, while the decrease of pH and increase of Cl- inside crevice lead to crevice corrosion in pH=12 solution.

CORROSION SCIENCE (2021)

添加到收藏夹

Article Construction & Building Technology

Crevice corrosion of steel rebar in chloride-contaminated concrete

Lei Yan et al.

Summary: This paper investigates the impact of crevice corrosion on the damage of steel rebar in concrete and confirms the effects of chloride concentration and temperature on crevice corrosion. It is found that chloride contamination and temperature elevation can significantly accelerate crevice corrosion.

CONSTRUCTION AND BUILDING MATERIALS (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

A new experimental method to simulate dynamic crevice corrosion in modular hip arthroplasty

Edgar Hornus et al.

Summary: A new method was developed to study the complex corrosion mechanism found in modular hip arthroplasty, which showed severe corrosion of 316L stainless steel under dynamic conditions. The method was able to reproduce the extent and morphology of attack found in a retrieved implant.

CORROSION SCIENCE (2021)

添加到收藏夹

Article Engineering, Biomedical

Analysis of Chemisorbed Tribo-Film for Ceramic-on-Ceramic Hip Joint Prostheses by Raman Spectroscopy

Risha Rufaqua et al.

Summary: The study investigated the lubricant mechanism in ceramic-on-ceramic hip joint prostheses by examining the biochemical reactions of synovial fluid and frictional coefficients. The results showed that the BIOLOXdelta surface had less reactivity to proteins and model fluid lubricants, while the BIOLOXforte ball surface exhibited chemisorption with proteins, hyaluronic acid, and model fluids. The study also revealed that there was no direct correlation between the measured frictional coefficient and the observed chemical reactions.

JOURNAL OF FUNCTIONAL BIOMATERIALS (2021)

添加到收藏夹

Article Chemistry, Physical

The influence of protein concentration, temperature and cathodic polarization on the surface status of CoCrMo biomedical grade alloys

Righdan Namus et al.

APPLIED SURFACE SCIENCE (2020)

添加到收藏夹

Article Orthopedics

Outcome of Re-Revision Surgery for Adverse Local Tissue Reaction in Metal-on-Polyethylene and Metal-on-Metal Total Hip Arthroplasty

Bryant Bonner et al.

JOURNAL OF ARTHROPLASTY (2020)

添加到收藏夹

Article Engineering, Biomedical

In vitro fretting crevice corrosion damage of CoCrMo alloys in phosphate buffered saline: Debris generation, chemistry and distribution

Dongkai Zhu et al.

ACTA BIOMATERIALIA (2020)

添加到收藏夹

Review Engineering, Multidisciplinary

A state-of-the-art review on Ag/AgCl ion-selective electrode used for non-destructive chloride detection in concrete

Zhangmin Zhang et al.

COMPOSITES PART B-ENGINEERING (2020)

添加到收藏夹

Article Radiology, Nuclear Medicine & Medical Imaging

Diagnostic accuracy of MRI with metal artifact reduction for the detection of periprosthetic joint infection and aseptic loosening of total hip arthroplasty

Benedikt J. Schwaiger et al.

EUROPEAN JOURNAL OF RADIOLOGY (2020)

添加到收藏夹

Article Orthopedics

Fretting and Corrosion Damage of Retrieved Dual-Mobility Total Hip Arthroplasty Systems

Daniel J. Lombardo et al.

JOURNAL OF ARTHROPLASTY (2019)

添加到收藏夹

Article Materials Science, Multidisciplinary

The influence of the crevice induced IR drop on polarization measurement of localized corrosion behavior of 316L stainless steel

E. Shojaei et al.

CORROSION SCIENCE (2019)

添加到收藏夹

Article Engineering, Biomedical

Fretting initiated crevice corrosion of 316LVM stainless steel in physiological phosphate buffered saline: Potential and cycles to initiation

Yangping Liu et al.

ACTA BIOMATERIALIA (2019)

添加到收藏夹

Article Orthopedics

Sensitivity and Specificity of Metal Ion Level in Predicting Adverse Local Tissue Reactions Due to Head-Neck Taper Corrosion in Primary Metal-on-Polyethylene Total Hip Arthroplasty

Young-Min Kwon et al.

JOURNAL OF ARTHROPLASTY (2018)

添加到收藏夹

Article Orthopedics

Risk Factors Associated With Early Complications of Revision Surgery for Head-Neck Taper Corrosion in Metal-on-Polyethylene Total Hip Arthroplasty

Young-Min Kwon et al.

JOURNAL OF ARTHROPLASTY (2018)

添加到收藏夹

Article Materials Science, Biomaterials

A new finding on the in-vivo crevice corrosion damage in a CoCrMo hip implant

Reza H. Oskouei et al.

MATERIALS SCIENCE AND ENGINEERING C-MATERIALS FOR BIOLOGICAL APPLICATIONS (2017)

添加到收藏夹

Article Engineering, Mechanical

The effect of simulated inflammatory conditions and pH on fretting corrosion of CoCrMo alloy surfaces

Yangping Liu et al.

WEAR (2017)

添加到收藏夹

Article Materials Science, Multidisciplinary

In situ monitoring of crevice corrosion morphology of Type 316L stainless steel and repassivation behavior induced by sulfate ions

Takahito Aoyama et al.

CORROSION SCIENCE (2017)

添加到收藏夹

Article Engineering, Biomedical

In vivo electrochemical corrosion study of a CoCrMo biomedical alloy in human synovial fluids

A. Igual Munoz et al.

ACTA BIOMATERIALIA (2015)

添加到收藏夹

Article Engineering, Biomedical

The composition of tribofilms produced on metal-on-metal hip bearings

James Hesketh et al.

BIOMATERIALS (2014)

添加到收藏夹

Article Engineering, Biomedical

Galvanically enhanced fretting-crevice corrosion of cemented femoral stems

M. Bryant et al.

JOURNAL OF THE MECHANICAL BEHAVIOR OF BIOMEDICAL MATERIALS (2014)

添加到收藏夹

Article Construction & Building Technology

Application of wire beam electrode technique to investigate initiation and propagation of rebar corrosion

Wei Shi et al.

CEMENT AND CONCRETE RESEARCH (2013)

添加到收藏夹

Article Materials Science, Multidisciplinary

In situ investigation of crevice corrosion on UNS S32101 duplex stainless steel in sodium chloride solution

Y. Z. Yang et al.

CORROSION SCIENCE (2013)

添加到收藏夹

Article Engineering, Biomedical

Fretting corrosion of CoCrMo and Ti6Al4V interfaces

Viswanathan Swaminathan et al.

BIOMATERIALS (2012)

添加到收藏夹

Article Materials Science, Multidisciplinary

Evaluating localised corrosion intensity using the wire beam electrode

Yongjun Tan et al.

CORROSION SCIENCE (2012)

添加到收藏夹

Article Materials Science, Multidisciplinary

Electrochemical evaluation of under-deposit corrosion and its inhibition using the wire beam electrode method

Yongjun Tan et al.

CORROSION SCIENCE (2011)

添加到收藏夹

Review Materials Science, Multidisciplinary

Experimental methods designed for measuring corrosion in highly resistive and inhomogeneous media

Yongjun Tan

CORROSION SCIENCE (2011)

添加到收藏夹

Article Materials Science, Multidisciplinary

Study of localized corrosion of 304 stainless steel under chloride solution droplets using the wire beam electrode

Yanhua Wang et al.

CORROSION SCIENCE (2011)

添加到收藏夹

Article Engineering, Mechanical

Fretting-corrosion between 316L SS and PMMA: Influence of ionic strength, protein and electrochemical conditions on material wear. Application to orthopaedic implants

J. Pellier et al.

WEAR (2011)

添加到收藏夹

Article Engineering, Biomedical

The chemical form of metallic debris in tissues surrounding metal-on-metal hips with unexplained failure

Alister J. Hart et al.

ACTA BIOMATERIALIA (2010)

添加到收藏夹

Article Biophysics

Adsorption of bovine serum albumin on CoCrMo surface: Effect of temperature and protein concentration

C. Valero Vidal et al.

COLLOIDS AND SURFACES B-BIOINTERFACES (2010)

添加到收藏夹

Review Electrochemistry

The influence of local glucose oxidase activity on the potential/current distribution on stainless steel: A study by the wire beam electrode method

Wei Wang et al.

ELECTROCHIMICA ACTA (2009)

添加到收藏夹

Article Engineering, Mechanical

Fretting in prosthetic devices related to human body

M. H. Zhu et al.

TRIBOLOGY INTERNATIONAL (2009)

添加到收藏夹

Article Orthopedics

Long-term results of bipolar hemiarthroplasty for osteoarthritis of the hip and idiopathic osteonecrosis of the femoral head

Makoto Muraki et al.

JOURNAL OF ORTHOPAEDIC SCIENCE (2008)

添加到收藏夹

Article Materials Science, Multidisciplinary

Novel corrosion experiments using the wire beam electrode: (II) Monitoring the effects of ions transportation on electrochemical corrosion processes

NN Aung et al.

CORROSION SCIENCE (2006)

添加到收藏夹

Article Materials Science, Multidisciplinary

An experimental comparison of three wire beam electrode based methods for determining corrosion rates and patterns

YJ Tan

CORROSION SCIENCE (2005)

添加到收藏夹

Article Materials Science, Multidisciplinary

Emulation and study of the corrosion behavior of Al alloy 2024-T3 using a wire beam electrode (WBE) in conjunction with scanning vibrating electrode technique (SVET)

D Battocchi et al.

CORROSION SCIENCE (2005)

添加到收藏夹

Article Chemistry, Analytical

Corrosion due to differential aeration reconsidered

J De Gruyter et al.

JOURNAL OF ELECTROANALYTICAL CHEMISTRY (2001)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.