☆ 4.7 Article

Three-dimensional multiphase simulation of a partially narrowed flow field configuration for a high-performance polymer electrolyte membrane fuel cell

APPLIED THERMAL ENGINEERING (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Chemistry, Physical

Lattice Boltzmann simulation of the structural degradation of a gas diffusion layer for a proton exchange membrane fuel cell

Yulin Wang et al.

Summary: This study reconstructs the microstructure of carbon fiber-type GDL with different degrees of aging using a stochastic algorithm, and investigates water transport within the reconstructed GDLs using a multiphase lattice Boltzmann method. The results show that as the GDL ages, its water elimination performance decreases significantly, leading to water retention. The degradation of polytetrafluoroethylene (PTFE) makes the GDL more hydrophilic, causing a more severe water flooding problem. A moderate increase in PTFE content improves GDL antiaging performance, while excessive content reduces the effective porosity and fuel cell performance.

JOURNAL OF POWER SOURCES (2023)

添加到收藏夹

Article Energy & Fuels

Numerical Investigation of Tapered Flow Field Configurations for Enhanced Polymer Electrolyte Membrane Fuel Cell Performance

Yulin Wang et al.

Summary: The study proposed a tapered flow field configuration to enhance the performance of polymer electrolyte membrane fuel cells by improving oxygen transport and water removal. Numerical investigations showed that different LI/O ratios had varying effects on oxygen transport, water removal, and overall cell performance, with an optimal design exhibiting more uniform distributions and improved performance.

APPLIED ENERGY (2022)

添加到收藏夹

Article Thermodynamics

Multi-sub-inlets at cathode flow-field plate for current density homogenization and enhancement of PEM fuel cells in low relative humidity

Yulin Wang et al.

Summary: This article investigates the use of multi-sub-inlet designs on the cathode flow-field plate of a polymer electrolyte membrane fuel cell to improve current density uniformity and overall cell performance. The results show that compared to conventional designs, the multi-sub-inlet design can improve oxygen distribution, enhance water removal capacity, and maintain a low pressure drop, leading to improved cell performance. Additionally, increasing the flow rate of the sub-inlets can further enhance the maximum power density while maintaining oxygen distribution uniformity.

ENERGY CONVERSION AND MANAGEMENT (2022)

添加到收藏夹

Article Thermodynamics

Experimental investigation of heat pipe thermoelectric generator

Yulong Zhao et al.

Summary: Thermoelectric generators can generate electricity from low-temperature energy sources like solar and geothermal energy. Heat pipes are used to increase the hot end temperature of thermoelectric modules to improve conversion efficiency. Increasing heating power reduces thermal resistance and enhances efficiency, while adding more modules increases thermal resistance and decreases hot end temperature.

ENERGY CONVERSION AND MANAGEMENT (2022)

添加到收藏夹

Review Chemistry, Physical

Bio-inspired flow channel designs for proton exchange membrane fuel cells: A review

Shuanyang Zhang et al.

Summary: Bipolar plates in proton exchange membrane fuel cells play important roles, and flow channel design is a highly active research field. This paper classifies bio-inspired flow channels into four types based on different bionic prototypes and analyzes their pros and cons. Furthermore, SWOT analysis is conducted on bio-inspired flow channel designs, and the research directions and prospects are summarized.

JOURNAL OF POWER SOURCES (2022)

添加到收藏夹

Article Thermodynamics

Three-dimensional numerical study of a cathode gas diffusion layer with a through/in plane synergetic gradient porosity distribution for PEM fuel cells

Yong Wang et al.

Summary: This study proposes a novel gradient porosity distribution technology in the cathode gas diffusion layer of a polymer electrolyte membrane fuel cell to enhance mass transfer and water removal. The results show that this technology has a greater advantage in improving cell performance and achieving more uniform internal physical quantity profiles.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2022)

添加到收藏夹

Article Thermodynamics

Numerical simulation of the PEM fuel cell performance enhancement by various blockage arrangement of the cathode serpentine gas flow channel outlets/inlets

A. Hamrang et al.

Summary: This paper investigates the performance enhancement of polymer electrolyte membrane fuel cells by changing the outlet/inlet configuration of parallel-serpentine flow field. The results show that geometric changes in the channel outlets/inlets can amplify the effects of transverse over-rib convection, leading to improved oxygen concentration and liquid water saturation. The findings suggest that the serpentine-baffled configuration yields the highest net power, achieving a performance increase of 38.5% compared to the parallel-serpentine case. This study provides insights for optimizing fuel cell design and performance.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2022)

添加到收藏夹

Article Energy & Fuels

Lattice Boltzmann simulation of a gas diffusion layer with a gradient polytetrafluoroethylene distribution for a proton exchange membrane fuel cell

Yulin Wang et al.

Summary: In this study, the influence of polytetrafluoroethylene content and distribution on liquid transport behaviors in gas diffusion layers and the performance of proton exchange membrane fuel cells was investigated. The results indicate that an increased content of polytetrafluoroethylene favors liquid removal, but an extremely high content could weaken cell performance. Additionally, a reasonably higher polytetrafluoroethylene content in the inlet region of the gas diffusion layer benefits water drainage enhancement.

APPLIED ENERGY (2022)

添加到收藏夹

Article Chemistry, Physical

Forchheimer's inertial effect on liquid water removal in proton exchange membrane fuel cells with baffled flow channels

Hao Chen et al.

Summary: The study shows that using baffles with different shapes in the flow channels of fuel cells can effectively improve the removal of liquid water, thereby enhancing cell performance. In addition, the flow channel design can avoid excessive pressure drops and facilitate the removal of liquid water.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2021)

添加到收藏夹

Article Thermodynamics

Bio-inspired design of an auxiliary fishbone-shaped cathode flow field pattern for polymer electrolyte membrane fuel cells

Yulin Wang et al.

Summary: The bio-inspired auxiliary fishbone-shaped flow field pattern in fuel cells significantly enhances under-rib mass transport and water removal, improving fuel efficiency and operational stability. However, a balance between increased number and width of sub-branch channels for better transport and potential higher electrical contact resistance needs to be considered.

ENERGY CONVERSION AND MANAGEMENT (2021)

添加到收藏夹

Article Thermodynamics

Analysis of the impact of flow field arrangement on the performance of PEMFC with zigzag-shaped channels

Zihao Liao et al.

Summary: The flow field configuration of a PEMFC is crucial for performance enhancement, and the study found that the contrary arrangement design provides more uniform distributions of reactants and reaction products compared to traditional designs. Additionally, the contrary arrangement design reduces mass transport resistance and boosts heat/mass transfer rates, especially under higher relative humidity and larger operating pressure conditions.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2021)

添加到收藏夹

Review Chemistry, Multidisciplinary

Performance Studies of Proton Exchange Membrane Fuel Cells with Different Flow Field Designs - Review

Muthukumar Marappan et al.

Summary: PEMFC is a fuel cell used for power generation without emissions. Better water management and flow field design are crucial for enhanced performance. Various flow field designs' effects on PEMFC performance have been studied in detail.

CHEMICAL RECORD (2021)

添加到收藏夹

Article Energy & Fuels

Performance analysis of an innovative parallel flow field design of proton exchange membrane fuel cells using multiphysics simulation

Mehrdad Ghasabehi et al.

Summary: The study introduces a novel parallel flow field design to enhance the electrochemical performance and reduce the parasitic power loss of proton exchange membrane fuel cells. By comparing different structures and utilizing techniques such as tapered main channels and manipulating manifolds, the best flow field design is determined, with increasing cathode stoichiometry identified as the most effective factor in enhancing power density.

FUEL (2021)

添加到收藏夹

Article Thermodynamics

Experimental study on thermoelectric power generation based on cryogenic liquid cold energy

Minghui Ge et al.

Summary: This study designed and built a thermoelectric power generation system for cold energy. The experimental results showed that the temperature difference between the hot and cold ends increased in the liquid-phase and two-phase regions, but decreased and then increased in the gas-phase region. The poor heat transfer capacity at the hot end of the generator restricted the improvement of the temperature difference at the hot and cold ends.

ENERGY (2021)

添加到收藏夹

Article Thermodynamics

Performance enhancement in a proton exchange membrane fuel cell with a novel 3D flow field

Jun Shen et al.

APPLIED THERMAL ENGINEERING (2020)

添加到收藏夹

Article Chemistry, Physical

Numerical and experimental investigation of baffle plate arrangement on proton exchange membrane fuel cell performance

Xuefeng Wang et al.

JOURNAL OF POWER SOURCES (2020)

添加到收藏夹

Article Electrochemistry

Experimental Study of Three Channel Designs with Model Comparison in a PEM Fuel Cell

F. Mojica et al.

FUEL CELLS (2020)

添加到收藏夹

Article Thermodynamics

Large-scale multi-phase simulation of proton exchange membrane fuel cell

Guobin Zhang et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2019)

添加到收藏夹

Article Chemistry, Physical

Numerical simulation for metal foam two-phase flow field of proton exchange membrane fuel cell

Zhiming Bao et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2019)

添加到收藏夹

Article Thermodynamics

Flow field design with 3D geometry for proton exchange membrane fuel cells

Xiaohui Yan et al.

APPLIED THERMAL ENGINEERING (2019)

添加到收藏夹

Article Thermodynamics

Optimization design of the cathode flow channel for proton exchange membrane fuel cells

Linhao Fan et al.

ENERGY CONVERSION AND MANAGEMENT (2018)

添加到收藏夹

Article Chemistry, Physical

Numerical study of a new cathode flow-field design with a sub-channel for a parallel flow-field polymer electrolyte membrane fuel cell

Yulin Wang et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2018)

添加到收藏夹

Article Energy & Fuels

Multi-phase simulation of proton exchange membrane fuel cell with 3D fine mesh flow field

Guobin Zhang et al.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2018)

添加到收藏夹

Review Engineering, Electrical & Electronic

Development of the fuel cell vehicle mirai

Yasuhiro Nonobe

IEEJ TRANSACTIONS ON ELECTRICAL AND ELECTRONIC ENGINEERING (2017)

添加到收藏夹

Article Thermodynamics

Characteristics of PEMFC operating at high current density with low external humidification

Linhao Fan et al.

ENERGY CONVERSION AND MANAGEMENT (2017)

添加到收藏夹

Article Thermodynamics

The optimization of channels for a proton exchange membrane fuel cell applying genetic algorithm

Xiangbing Zeng et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2017)

添加到收藏夹

Article Chemistry, Physical

Designing, modeling and performance investigation of bio-inspired flow field based DMFCs

Adnan Ozden et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2017)

添加到收藏夹

Article Chemistry, Physical

Modeling two-phase flow in three-dimensional complex flow-fields of proton exchange membrane fuel cells

Jinyong Kim et al.

JOURNAL OF POWER SOURCES (2017)

添加到收藏夹

Article Chemistry, Physical

New design of a cathode flow-field with a sub-channel to improve the polymer electrolyte membrane fuel cell performance

Yulin Wang et al.

JOURNAL OF POWER SOURCES (2017)

添加到收藏夹

Article Chemistry, Physical

Experimental investigation of in-line and staggered blockages in parallel flowfield channels of PEM fuel cells

Hadi Heidary et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2016)

添加到收藏夹

Article Chemistry, Physical

The effect of pulsating pressure on the performance of a PEM fuel cell with a wavy cathode surface

Hamid Reza Ashorynejad et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2016)

添加到收藏夹

Article Chemistry, Physical

Representative model and flow characteristics of open pore cellular foam and potential use in proton exchange membrane fuel cells

J. G. Carton et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2015)

添加到收藏夹

Article Transportation Science & Technology

Development of Compact and High-Performance Fuel Cell Stack

Norishige Konno et al.

SAE INTERNATIONAL JOURNAL OF ALTERNATIVE POWERTRAINS (2015)

添加到收藏夹

Article Chemistry, Physical

Numerical study of two-phase flow patterns in the gas channel of PEM fuel cells with tapered flow field design

Erasmo Mancusi et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2014)

添加到收藏夹

Article Energy & Fuels

Numerical investigation of the coupled water and thermal management in PEM fuel cell

Tao-Feng Cao et al.

APPLIED ENERGY (2013)

添加到收藏夹

Article Chemistry, Physical

Optimization of PEM fuel cell flow channel dimensions-Mathematic modeling analysis and experimental verification

Hong Liu et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2013)

添加到收藏夹

Article Energy & Fuels

Experimental and numerical study of proton exchange membrane fuel cell with spiral flow channels

Jiin-Yuh Jang et al.

APPLIED ENERGY (2012)

添加到收藏夹

Article Thermodynamics

Water droplet accumulation and motion in PEM (Proton Exchange Membrane) fuel cell mini-channels

J. G. Carton et al.

ENERGY (2012)

添加到收藏夹

Article Computer Science, Interdisciplinary Applications

CFD simulation of PEM fuel cell performance: Effect of straight and serpentine flow fields

Fatemeh Hashemi et al.

MATHEMATICAL AND COMPUTER MODELLING (2012)

添加到收藏夹

Article Green & Sustainable Science & Technology

Simulation of an innovative flow-field design based on a bio inspired pattern for PEM fuel cells

R. Roshandel et al.

RENEWABLE ENERGY (2012)

添加到收藏夹

Article Chemistry, Physical

Numerical analysis of the influence of the channel cross-section aspect ratio on the performance of a PEM fuel cell with serpentine flow field design

A. P. Manso et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2011)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.