4.7 Article

Ag Alloying in Cu2-yAgyBa(Ge,Sn)Se4 Films and Photovoltaic Devices

相关参考文献

注意:仅列出部分参考文献,下载原文获取全部文献信息。
Article Chemistry, Physical

Charge Carrier Lifetime Fluctuations and Performance Evaluation of Cu(In,Ga)Se2 Absorbers via Time-Resolved-Photoluminescence Microscopy

Mario Ochoa et al.

Summary: The study demonstrates that material quality is still limited by nonradiative recombination, and postdeposition treatments can reduce minority carrier lifetime fluctuations. Time-resolved photoluminescence microscopy can accurately measure solar cells under different treatment conditions and validate the accuracy of device performance metrics.

ADVANCED ENERGY MATERIALS (2022)

Article Chemistry, Physical

Predicting Solar Cell Performance from Terahertz and Microwave Spectroscopy

Hannes Hempel et al.

Summary: This article combines the expertise of fifteen laboratories to quantitatively model the current-voltage characteristics of photovoltaic materials, using (Cs,FA,MA)Pb(I,Br)(3) halide perovskite thin-film as a case study. The study examines the impact of measurement conditions, alternate interpretations, and experimental inter-laboratory variations. The results show that terahertz, microwave, and photoluminescence measurements can provide consistent information on the mobility and lifetime of charge carriers in the material, which is crucial for the efficiency of solar cells.

ADVANCED ENERGY MATERIALS (2022)

Article Chemistry, Physical

Top Stack Optimization for Cu2BaSn(S, Se)4 Photovoltaic Cell Leads to Improved Device Power Conversion Efficiency beyond 6%

Betul Teymur et al.

Summary: This study demonstrates an improvement in the performance of CBTSSe solar cells by introducing a new thin-film structure and solution deposition technique, achieving higher open-circuit voltage and conversion efficiency. By optimizing the band offsets of the buffer and window layers, interfacial recombination is mitigated, leading to enhanced solar cell performance.

ADVANCED ENERGY MATERIALS (2022)

Article Energy & Fuels

Elemental de-mixing-induced epitaxial kesterite/CdS interface enabling 13%-efficiency kesterite solar cells

Yuancai Gong et al.

Summary: The efficiency of kesterite solar cells has been stuck at 12.6% since 2013 due to challenges in controlling defects. Now Gong et al. present a low-temperature annealing of the kesterite/CdS junction to form an epitaxial interface with a low defect density, enabling 13%-efficiency devices.

NATURE ENERGY (2022)

Article Chemistry, Physical

Influence of Copper Composition on Cu2BaSn(S,Se)4 Solution- Deposited Films and Photovoltaic Devices with Over 5% Efficiency

Betul Teymur et al.

Summary: Cu2BaSn(S,Se)4 is a promising environmentally friendly and stable thin-film solar cell material. The copper composition of Cu2BaSn(S,Se)4 was systematically modified and it was found that the material is less sensitive to copper stoichiometry, providing a more stable material platform for thin-film solar cells.

ACS APPLIED ENERGY MATERIALS (2022)

Article Chemistry, Physical

Optoelectronic and material properties of solution-processed Earth-abundant Cu2BaSn(S, Se)4 films for solar cell applications

Betul Teymur et al.

Summary: Copper barium thioselenostannate (CBTSSe) absorbers utilize low-toxicity and abundant metals, offering low-cost manufacturing, controllable stoichiometry, and tunable band gap. The performance of solution-deposited CBTSSe films is influenced by defects, charge carrier mobility, and lifetime. Surface recombination issues impact efficiency, highlighting the need for improvement in the fabrication process.

NANO ENERGY (2021)

Article Chemistry, Physical

Large-Grain Double Cation Perovskites with 18 μs Lifetime and High Luminescence Yield for Efficient Inverted Perovskite Solar Cells

Emilio Gutierrez-Partida et al.

Summary: Recent advancements in perovskite solar cell research have focused on improving efficiency and stability by developing high-quality double cation perovskite materials. The low-bandgap cells exhibited high fill factor and short-circuit current, showcasing reduced charge transport losses. The implied efficiency in the neat material reached 28.4% through minimizing interfacial recombination and optical losses.

ACS ENERGY LETTERS (2021)

Article Chemistry, Physical

Growth and Photovoltaic Device Application of Cu2BaGe1-xSnxSe4 Films Prepared by Selenization of Sequentially Deposited Precursors

Yongshin Kim et al.

Summary: The study demonstrates a method to suppress the formation of anti-site defects in kesterite Cu2ZnSnS4-xSex (CZTS) absorber films, with the introduction of Cu-2-II-IV-X-4 compounds. The first solar cells based on Cu2BaGe1-xSnxSe4 (CBGTSe) as a light absorber have been reported, achieving a maximum power conversion efficiency of 3.06%.

ACS APPLIED ENERGY MATERIALS (2021)

Article Chemistry, Physical

Optoelectronic property comparison for isostructural Cu2BaGeSe4 and Cu2BaSnS4 solar absorbers

Yongshin Kim et al.

Summary: A new class of chalcogenides, Cu2BaGeSe4 (CBGSe) and Cu2BaSnS4 (CBTS), has been introduced to mitigate anti-site defect formation in Cu2ZnSnS4-xSex. CBGSe films exhibit higher hole carrier concentration, lower mobility, and pronounced deep-level emission compared to CBTS films. The prototype CBGSe solar cells show an efficiency of 1.5% with a 0.62 V open-circuit voltage, pointing to possible limiting factors for CBGSe and related films in PV and optoelectronics applications.

JOURNAL OF MATERIALS CHEMISTRY A (2021)

Article Nanoscience & Nanotechnology

High Efficiency CIGS Solar Cells by Bulk Defect Passivation through Ag Substituting Strategy

Yunhai Zhao et al.

ACS APPLIED MATERIALS & INTERFACES (2020)

Article Chemistry, Physical

Structural Tolerance Factor Approach to Defect-Resistant I2-II-IV-X4 Semiconductor Design

Jon-Paul Sun et al.

CHEMISTRY OF MATERIALS (2020)

Article Energy & Fuels

Comparison of Ag and Ga alloying in low bandgap CuInSe2-based solar cells

Nicholas Valdes et al.

SOLAR ENERGY MATERIALS AND SOLAR CELLS (2019)

Article Chemistry, Physical

Origins of ultralow thermal conductivity in 1-2-1-4 quaternary selenides

Jimmy Jiahong Kuo et al.

JOURNAL OF MATERIALS CHEMISTRY A (2019)

Article Chemistry, Physical

Solution-Processed Earth-Abundant Cu2BaSn(S,Se)4 Solar Absorber Using a Low-Toxicity Solvent

Betul Teymur et al.

CHEMISTRY OF MATERIALS (2018)

Article Chemistry, Physical

Band Gap Tailoring and Structure-Composition Relationship within the Alloyed Semiconductor Cu2BaGe1-xSnxSe4

Garrett C. Wessler et al.

CHEMISTRY OF MATERIALS (2018)

Article Multidisciplinary Sciences

Minority and Majority Charge Carrier Mobility in Cu2ZnSnSe4 revealed by Terahertz Spectroscopy

Hannes Hempel et al.

SCIENTIFIC REPORTS (2018)

Review Chemistry, Physical

Defect Engineering in Multinary Earth-Abundant Chalcogenide Photovoltaic Materials

Donghyeop Shin et al.

ADVANCED ENERGY MATERIALS (2017)

Article Nanoscience & Nanotechnology

Elemental Precursor Solution Processed (Cu1-xAgx)2ZnSn(S,Se)4 Photovoltaic Devices with over 10% Efficiency

Yafang Qi et al.

ACS APPLIED MATERIALS & INTERFACES (2017)

Article Chemistry, Multidisciplinary

Earth-Abundant Chalcogenide Photovoltaic Devices with over 5% Efficiency Based on a Cu2BaSn(S,Se)4 Absorber

Donghyeop Shin et al.

ADVANCED MATERIALS (2017)

Article Physics, Applied

Intragrain charge transport in kesterite thin films-Limits arising from carrier localization

Hannes Hempel et al.

JOURNAL OF APPLIED PHYSICS (2016)

Article Chemistry, Physical

Trigonal Cu2-II-Sn-VI4 (II = Ba, Sr and VI = S, Se) quaternary compounds for earth-abundant photovoltaics

Feng Hong et al.

PHYSICAL CHEMISTRY CHEMICAL PHYSICS (2016)

Article Chemistry, Physical

Is the Cu/Zn Disorder the Main Culprit for the Voltage Deficit in Kesterite Solar Cells?

Stephane Bourdais et al.

ADVANCED ENERGY MATERIALS (2016)

Article Chemistry, Physical

Photovoltaic Materials and Devices Based on the Alloyed Kesterite Absorber (AgxCu1-x)2ZnSnSe4

Talia Gershon et al.

ADVANCED ENERGY MATERIALS (2016)

Article Physics, Applied

A parallel dipole line system

Oki Gunawan et al.

APPLIED PHYSICS LETTERS (2015)

Article Chemistry, Physical

Impact of Nanoscale Elemental Distribution in High-Performance Kesterite Solar Cells

Kasra Sardashti et al.

ADVANCED ENERGY MATERIALS (2015)

Article Physics, Applied

Observed damage during Argon gas cluster depth profiles of compound semiconductors

Anders J. Barlow et al.

JOURNAL OF APPLIED PHYSICS (2014)

Article Physics, Applied

Band tailing and efficiency limitation in kesterite solar cells

Tayfun Gokmen et al.

APPLIED PHYSICS LETTERS (2013)

Review Multidisciplinary Sciences

Prospects and performance limitations for Cu-Zn-Sn-S-Se photovoltaic technology

David B. Mitzi et al.

PHILOSOPHICAL TRANSACTIONS OF THE ROYAL SOCIETY A-MATHEMATICAL PHYSICAL AND ENGINEERING SCIENCES (2013)

Article Physics, Applied

Abundance of CuZn + SnZn and 2CuZn + SnZn defect clusters in kesterite solar cells

Shiyou Chen et al.

APPLIED PHYSICS LETTERS (2012)

Review Physics, Applied

Kesterite thin films for photovoltaics: a review

S. Delbos

EPJ PHOTOVOLTAICS (2012)

Article Materials Science, Multidisciplinary

The electronic structure of Cu(In1-xGax)Se2 alloyed with silver

Peter T. Erslev et al.

THIN SOLID FILMS (2011)

Article Physics, Applied

Long lifetimes in high-efficiency Cu(In,Ga)Se2 solar cells

Wyatt K. Metzger et al.

APPLIED PHYSICS LETTERS (2008)

Article Materials Science, Multidisciplinary

Effect of back-contact barrier on thin-film CdTe solar cells

S. H. Demtsu et al.

THIN SOLID FILMS (2006)