4.7 Article

Role of yttrium content in twinning behavior of extruded Mg-Y sheets under tension/compression

相关参考文献

注意:仅列出部分参考文献,下载原文获取全部文献信息。
Article Nanoscience & Nanotechnology

Significantly enhanced grain boundary Zn and Ca co-segregation of dilute Mg alloy via trace Sm addition

Zhi Zhang et al.

Summary: The addition of trace Sm can significantly increase the grain boundary segregation concentration in the dilute Mg-Zn-Ca-Mn alloy, improve its yield strength, inhibit grain growth during annealing, and contribute to the design of advanced Mg alloys.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2022)

Article Nanoscience & Nanotechnology

Developing a low-alloyed fine-grained Mg alloy with high strength-ductility based on dislocation evolution and grain boundary segregation

Zhi Zhang et al.

Summary: A new low-alloyed Mg-2Sm-0.8Mn-0.6Ca-0.5Zn alloy is prepared by low-temperature and low-speed extrusion, which exhibits high strength but low ductility. After annealing, the alloy shows both high strength and high ductility due to the effective inhibition of grain growth by grain boundary co-segregation and decreased dislocation density. The evolution of immovable long dislocations towards new grain boundaries is a key factor for the remarkable increase of ductility in the annealed alloy.

SCRIPTA MATERIALIA (2022)

Article Engineering, Mechanical

Tension-compression asymmetry and the underlying slip/twinning activity in extruded Mg - Y sheets

D. D. Yin et al.

Summary: The addition of different concentrations of Y significantly affected the mechanical properties, grain-scale slip activity, and orientation heterogeneity of extruded Mg alloys during tension and compression. Increasing Y content led to noticeable changes in slip activity, while tension-compression asymmetry also showed variations.

INTERNATIONAL JOURNAL OF PLASTICITY (2021)

Article Materials Science, Multidisciplinary

Anomalous Tension Twinning Activity in Extruded Mg Sheet During Hard-Orientation Loading at Room Temperature

Y. Q. Chai et al.

Summary: The study found that surface twins in a strongly basal-textured Mg sheet deformed under tension exhibit tension twins, with a significant number showing negative Schmid factor and Luster-Morris parameter values. The twinning behavior was more dependent on local conditions than globally applied stress, limiting correlations between m and m'.

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2021)

Article Nanoscience & Nanotechnology

Origin of profuse {11(2)over-bar1} deformation twins in Mg-Gd alloys

Cong He et al.

Summary: With the increase in Gd concentration, the dominant twinning mode in Mg-Gd alloys changes, and this twinning mode may be activated in other Mg alloys with a high concentration of solute atoms larger than Mg.

SCRIPTA MATERIALIA (2021)

Article Materials Science, Multidisciplinary

{10(1)over-bar2} twinning mechanism during in situ micro-tensile loading of pure Mg: Role of basal slip and twin-twin interactions

Nicolo M. Della Ventura et al.

Summary: The study of extension twinning mechanism in magnesium at the micron scale revealed that basal slip triggers {10(1) over bar2} twin nucleation and favors twin growth, while pyramidal slip leads to limited {10(1) over bar2} twin growth. The critical resolved shear stress for {10(1) over bar2} twinning was found to be ten times higher than in bulk material, indicating higher ductility in the tested samples.

MATERIALS & DESIGN (2021)

Article Nanoscience & Nanotechnology

Effects of precipitate on the slip activity and plastic heterogeneity of Mg-11Y-5Gd-2Zn-0.5Zr (wt. %) during room temperature compression

R. Ni et al.

Summary: The study revealed that the precipitates had an impact on the plastic deformation mechanisms and plastic heterogeneity of a cast Mg alloy, particularly showing a stronger hardening effect on the slip modes.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2021)

Article Metallurgy & Metallurgical Engineering

Basal stacking fault induced twin boundary gliding, twinning disconnection and twin growth in hcp Ti from the first-principles

Qi Qian et al.

Summary: First-principles calculations were used to investigate the formation mechanism of GTBs in hcp Ti, revealing that GTBs can form from the gliding of CTBs and eventually restore CTB structures by forming twinning disconnections. The pile-up of twinning disconnections at twin boundaries can promote twin growth. Additionally, the study evaluated the possible effects of alloying elements on pinning twin boundaries in Ti alloys.

TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2021)

Review Materials Science, Multidisciplinary

Local microstructure and micromechanical stress evolution during deformation twinning in hexagonal polycrystals

Mariyappan Arul Kumar et al.

JOURNAL OF MATERIALS RESEARCH (2020)

Article Nanoscience & Nanotechnology

Twinning-induced anisotropy of mechanical response of AZ31B extruded rods

Karol Frydrych et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)

Article Materials Science, Multidisciplinary

Effects of Y on the Deformation Mechanisms of Extruded Mg-Y Sheets During Room-Temperature Compression

L. J. Long et al.

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2020)

Article Physics, Multidisciplinary

Embracing the Chaos: Alloying Adds Stochasticity to Twin Embryo Growth

Yang Hu et al.

PHYSICAL REVIEW LETTERS (2020)

Article Chemistry, Multidisciplinary

Denoising of crystal orientation maps

R. Hielscher et al.

JOURNAL OF APPLIED CRYSTALLOGRAPHY (2019)

Article Materials Science, Multidisciplinary

Role of microstructure on twin nucleation and growth in HCP titanium: A statistical study

M. Arul Kumar et al.

ACTA MATERIALIA (2018)

Article Materials Science, Multidisciplinary

What is going on in magnesium alloys?

X. J. Wang et al.

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2018)

Article Nanoscience & Nanotechnology

Microstructure, texture and mechanical properties evolution of extruded fine-grained Mg-Y sheets during annealing

G. H. Huang et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)

Article Metallurgy & Metallurgical Engineering

Atomistic simulations of interactions between screw dislocation and twin boundaries in zirconium

Xiao-zhi Tang et al.

TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2018)

Article Materials Science, Multidisciplinary

Deformation twinning in rolled WE43-T5 rare earth magnesium alloy: Influence on strain hardening and texture evolution

Mohammad Jahedi et al.

ACTA MATERIALIA (2017)

Article Materials Science, Multidisciplinary

Mechanical Properties of Mg-Gd and Mg-Y Solid Solutions

Anna Kula et al.

METALLURGICAL AND MATERIALS TRANSACTIONS B-PROCESS METALLURGY AND MATERIALS PROCESSING SCIENCE (2016)

Article Materials Science, Multidisciplinary

Microplasticity-based rationalization of the room temperature yield asymmetry in conventional polycrystalline Mg alloys

C. M. Cepeda-Jimenez et al.

ACTA MATERIALIA (2016)

Article Materials Science, Multidisciplinary

Tensile and compressive deformation behavior of peak-aged cast Mg-11Y-5Gd-2Zn-0.5Zr (wt%) alloy at elevated temperatures

J. W. Lu et al.

JOURNAL OF MATERIALS SCIENCE (2016)

Article Multidisciplinary Sciences

Strength and ductility with {10(1)over-bar1} - {10(1)over-bar2} double twinning in a magnesium alloy

M. Lentz et al.

NATURE COMMUNICATIONS (2016)

Article Materials Science, Multidisciplinary

On the selection of extension twin variants with low Schmid factors in a deformed Mg alloy

Zhang-Zhi Shi et al.

ACTA MATERIALIA (2015)

Article Materials Science, Multidisciplinary

Fracture behavior of magnesium alloys - Role of tensile twinning

N. Subrahmanya Prasad et al.

ACTA MATERIALIA (2015)

Article Materials Science, Multidisciplinary

The effect of high yttrium solute concentration on the twinning behaviour of magnesium alloys

N. Stanford et al.

ACTA MATERIALIA (2015)

Article Chemistry, Physical

Influence of aluminum content on twinning and texture development of cast Mg-Al-Zn alloy during compression

N. Tahreen et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2015)

Article Materials Science, Multidisciplinary

In situ observation of collective grain-scale mechanics in Mg and Mg-rare earth alloys

F. Wang et al.

ACTA MATERIALIA (2014)

Article Metallurgy & Metallurgical Engineering

Primary and secondary modes of deformation twinning in HCP Mg based on atomistic simulations

Hong-lu Xu et al.

TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2014)

Article Materials Science, Multidisciplinary

Slip transfer and plastic strain accumulation across grain boundaries in Hastelloy X

Wael Z. Abuzaid et al.

JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS (2012)

Article Materials Science, Multidisciplinary

Temperature dependency of slip and twinning in plane strain compressed magnesium single crystals

Adrien Chapuis et al.

ACTA MATERIALIA (2011)

Article Materials Science, Multidisciplinary

Deformation twinning in AZ31: Influence on strain hardening and texture evolution

Marko Knezevic et al.

ACTA MATERIALIA (2010)

Article Microscopy

Automatic twin statistics from electron backscattered diffraction data

P. E. Marshall et al.

JOURNAL OF MICROSCOPY (2010)

Article Materials Science, Multidisciplinary

Statistical analyses of deformation twinning in magnesium

I. J. Beyerlein et al.

PHILOSOPHICAL MAGAZINE (2010)

Editorial Material Multidisciplinary Sciences

Weight Loss with Magnesium Alloys

Tresa M. Pollock

SCIENCE (2010)

Article Nanoscience & Nanotechnology

The role of twinning-detwinning on fatigue fracture morphology of Mg-3%Al-1%Zn alloy

S. M. Yin et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2008)

Article Materials Science, Multidisciplinary

Origin of the Anomalous {10(1)over-bar2} Twinning during Tensile Deformation of Mg Alloy Sheet

J. Koike et al.

MATERIALS TRANSACTIONS (2008)

Article Nanoscience & Nanotechnology

Influence of {10-12} extension twinning on the flow behavior of AZ31 Mg alloy

Lan Jiang et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2007)

Article Materials Science, Multidisciplinary

Enhanced deformation mechanisms by anisotropic plasticity in polycrystalline Mg alloys at room temperature

J Koike

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2005)

Article Nanoscience & Nanotechnology

Internal strain and texture evolution during deformation twinning in magnesium

DW Brown et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2005)