4.7 Article

Relationship between oxidation behavior and tribological properties of Mo-V-Cu-N coatings

相关参考文献

注意:仅列出部分参考文献,下载原文获取全部文献信息。
Article Engineering, Mechanical

Structural, mechanical and tribological properties of Cr-V-N coatings deposited by cathodic arc evaporation

A. S. Kuprin et al.

Summary: Cr1-xVxN monolayer coatings were synthesized using vacuum arc plasma flux method with different properties compared to CrN and VN. The (Cr,V)N coatings were investigated using various analysis techniques, showing increased hardness and elastic modulus with higher vanadium concentration, while VN coating exhibited lower wear rate and friction coefficient among the coatings investigated.

TRIBOLOGY INTERNATIONAL (2022)

Article Materials Science, Ceramics

Effects of V and Cu codoping on the tribological properties and oxidation behavior of AlTiN coatings

Haijuan Mei et al.

Summary: This study investigated the effects of V and Cu codoping on the tribological properties and oxidation behavior of AlTiN coatings. It was found that increasing Cu content and decreasing V content led to higher wear rates of the coatings. However, at 600 degrees C, the oxidation and diffusion of Cu resulted in a lower friction coefficient and wear rate for the coatings.

CERAMICS INTERNATIONAL (2022)

Article Materials Science, Coatings & Films

Effect of Cu content on high-temperature tribological properties and oxidation behavior of Al-Ti-V-Cu-N coatings deposited by HIPIMS

Haijuan Mei et al.

Summary: The effect of copper content on the high-temperature tribological properties and oxidation behavior of Cu-containing coatings was studied. It was found that increasing copper content decreased the oxidation resistance of the coatings, but also reduced the friction coefficient and achieved a low wear rate.

SURFACE & COATINGS TECHNOLOGY (2022)

Article Materials Science, Multidisciplinary

The Additions of V and Cu on the Microstructure and Mechanical Properties of Mo-N Coatings

Haijuan Mei et al.

Summary: Mo-V-Cu-N coatings were deposited by high power impulse magnetron sputtering (HIPIMS), and the effects of V and Cu on the microstructure and mechanical properties of the coatings were investigated. With increasing V/Cu content ratio, the surface roughness decreased, the adhesion strength increased, and the hardness reached a maximum value, accompanied by high compressive residual stress.

COATINGS (2022)

Article Engineering, Mechanical

Investigation of tribological and functional properties of Cr,Mo-(Cr,Mo) N-(Cr,Mo,Al)N multilayer composite coating

Alexey Vereschaka et al.

Summary: The article investigated the properties of a Cr,Mo-(Cr,Mo)N-(Cr,Mo,Al)N multilayer composite coating, finding that the adhesion component of the coefficient of friction varied with temperature and the diffusion layer thickness was significantly lower during cutting with the coated tool, indicating better cutting performance.

TRIBOLOGY INTERNATIONAL (2021)

Article Materials Science, Coatings & Films

Microstructure, mechanical and tribological properties of Mo-V-N films by reactive magnetron sputtering

Wenzhe Wang et al.

SURFACE & COATINGS TECHNOLOGY (2020)

Article Materials Science, Coatings & Films

Effect of Cu doping on the microstructure and mechanical properties of AlTiVN-Cu nanocomposite coatings

Haijuan Mei et al.

SURFACE & COATINGS TECHNOLOGY (2020)

Article Materials Science, Coatings & Films

Influence of lubricious oxides formation on the tribological behavior of Mo-V-Cu-N coatings deposited by HIPIMS

Haijuan Mei et al.

SURFACE & COATINGS TECHNOLOGY (2019)

Article Materials Science, Ceramics

Effect of V-addition on the thermal stability and oxidation resistance of CrAlN coatings

Yu X. Xu et al.

CERAMICS INTERNATIONAL (2018)

Article Materials Science, Coatings & Films

Effect of nitrogen partial pressure on microstructure and mechanical properties of Mo-Cu-V-N composite coatings deposited by HIPIMS

Haijuan Mei et al.

SURFACE & COATINGS TECHNOLOGY (2017)

Review Materials Science, Coatings & Films

Vanadium containing self-adaptive low-friction hard coatings for high-temperature applications: A review

Robert Franz et al.

SURFACE & COATINGS TECHNOLOGY (2013)

Article Materials Science, Multidisciplinary

Microstructural evolution and tribological behavior of Mo-Cu-N coatings as a function of Cu content

Jung Ho Shin et al.

MATERIALS CHEMISTRY AND PHYSICS (2011)

Article Materials Science, Multidisciplinary

Wear and friction of TiAlN/VN coatings against Al2O3 in air at room and elevated temperatures

Z. Zhou et al.

ACTA MATERIALIA (2010)

Article Engineering, Mechanical

Comparative tribological behaviors of TiN-, CrN- and MoN-Cu nanocomposite coatings

A. Oeztuerk et al.

TRIBOLOGY INTERNATIONAL (2008)

Article Materials Science, Coatings & Films

Magneli phase formation of PVD Mo-N and W-N coatings

G. Gassner et al.

SURFACE & COATINGS TECHNOLOGY (2006)

Article Materials Science, Coatings & Films

A crystal chemical approach to the formulation of self-lubricating nanocomposite coatings

A Erdemir

SURFACE & COATINGS TECHNOLOGY (2005)

Article Materials Science, Coatings & Films

Influence of oxide phase formation on the tribological behaviour of Ti-Al-V-N coatings

K Kutschej et al.

SURFACE & COATINGS TECHNOLOGY (2005)

Article Materials Science, Coatings & Films

The role of surface oxidation in friction processes on molybdenum nitride thin films

T Suszko et al.

SURFACE & COATINGS TECHNOLOGY (2005)

Article Engineering, Mechanical

Genesis and role of wear debris in sliding wear of ceramics

TE Fischer et al.

Article Nanoscience & Nanotechnology

Structure and properties of hard and superhard Zr-Cu-N nanocomposite coatings

P Zeman et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2000)

Article Engineering, Chemical

A crystal-chemical approach to lubrication by solid oxides

A Erdemir

TRIBOLOGY LETTERS (2000)