☆ 4.7 Article

Tension-compression asymmetry and Bauschinger-like effect of AZ31 magnesium alloy bars processed by ambient extrusion

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Nanoscience & Nanotechnology

Ambient extrusion induced working hardening and their effect on mechanical properties in AZ31 hot-extrusion bar

Jinhua Peng et al.

Summary: The effect of working hardening on deformation mechanisms and strain hardening behavior was revealed by imposing varying degrees of strain on AZ31 hot-extrusion bars through ambient extrusion. It was found that as the extrusion strain increased, the yield strength increased gradually while the ductility sacrificed. The working hardening had varying effects on different loading directions.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

The effect of strain rate asymmetry on the Bauschinger effect: A discrete dislocation plasticity analysis

Zebang Zheng et al.

Summary: This study employs a two-dimensional discrete dislocation plasticity model to investigate the effect of strain rate asymmetry on the Bauschinger effect. The results show that increasing the source density enhances the rate dependence of the Bauschinger effect in obstacle-free specimens, while obstacles reduce the rate dependence. In low strain rate regimes, grain boundaries and obstacles with high activation energies enhance the rate dependence of the Bauschinger effect, suggesting that decreasing the grain size or reducing the activation energy can strengthen the rate dependence.

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Twins and grain boundaries-dominated the reverse Bauschinger effect and tension- compression asymmetry

Jinjie Zhou et al.

Summary: This study investigates the tension-compression asymmetry and Bauschinger effect of single and polycrystalline aluminum under different loads using molecular dynamics methods. The results show that both types of aluminum exhibit work hardening under tensile and compressive loads, but the characteristics differ between single and polycrystalline aluminum. Additionally, the tension-compression asymmetry and Bauschinger effect are more pronounced in polycrystalline aluminum, with a reverse tension-compression asymmetry observed. The Bauschinger effect is caused by defects introduced through preloading, and the asymmetry is attributed to different microscopic defects.

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2022)

添加到收藏夹

Article Multidisciplinary Sciences

Rejuvenation of plasticity via deformation graining in magnesium

Bo-Yu Liu et al.

Summary: This study reports the large plasticity in c-axis compression of submicron magnesium single crystal achieved by a dual-stage deformation. The plastic flow strain-hardens the magnesium crystal to gigapascal level, resulting in the formation of multiple grains. This grain formation rejuvenates dislocation activities and enables large plasticity.

NATURE COMMUNICATIONS (2022)

添加到收藏夹

Article Chemistry, Physical

Investigation on the anisotropy of mechanical properties along different orientations of an AZ31 hot-extrusion bar

Jinhua Peng et al.

Summary: This study systematically investigates the texture-induced anisotropy of magnesium, showing that the microstructure, texture, and mechanical properties vary with the sample direction. Different deformation mechanisms are favored by grains at different angles, with tensile and compression yield planes being fitted by linear and exponential equations, respectively. Mechanical properties and strain hardening anisotropy are discussed through comparative analyses between experimental and calculated results.

JOURNAL OF ALLOYS AND COMPOUNDS (2021)

添加到收藏夹

Review Metallurgy & Metallurgical Engineering

Research advances in magnesium and magnesium alloys worldwide in 2020

Yan Yang et al.

Summary: Research on magnesium alloys remains a significant focus, with a strong emphasis on microstructure control, mechanical properties, corrosion and protection, and functional magnesium materials. Future research will concentrate on synergistic microstructure control, development of functional materials, corrosion protection measures, and advanced processing technology improvements.

JOURNAL OF MAGNESIUM AND ALLOYS (2021)

添加到收藏夹

Article Engineering, Industrial

Improving the plastic homogeneity of a magnesium alloy by introducing high volume fraction of twins during ambient extrusion

Jinhua Peng et al.

JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2020)

添加到收藏夹

Review Metallurgy & Metallurgical Engineering

Latest research advances on magnesium and magnesium alloys worldwide

Jiangfeng Song et al.

JOURNAL OF MAGNESIUM AND ALLOYS (2020)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Effect of pre-deformation on the activation stress of {10–12} twinning in Mg–3Al–1Zn alloy

Xiaoqian Guo et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Detwinning-related Bauschinger effect of an extruded magnesium alloy AZ31B

Linghui Song et al.

MATERIALS CHARACTERIZATION (2019)

添加到收藏夹

Article Nanoscience & Nanotechnology

Formation of macroscopic twin bands and inhomogeneous deformation during cyclic tension-compression loading of the Mg-wrought alloy AZ31

Kerstin Anten et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)

添加到收藏夹

Review Materials Science, Multidisciplinary

Texture control by {10-12} twinning to improve the formability of Mg alloys: A review

Bo Song et al.

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2019)

添加到收藏夹

Article Nanoscience & Nanotechnology

Role of twinning on the stress and strain behaviors during reverse loading in rolled magnesium alloy sheets

Takayuki Hama et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)

添加到收藏夹

Article Nanoscience & Nanotechnology

Contribution of extension twinning to plastic strain at low stress stage deformation of a Mg-3Al-1Zn alloy

P. Chen et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)

添加到收藏夹

Article Nanoscience & Nanotechnology

Extraordinary Bauschinger effect in gradient structured copper

Xiaolong Liu et al.

SCRIPTA MATERIALIA (2018)

添加到收藏夹

Article Nanoscience & Nanotechnology

Mechanism of the Bauschinger effect in Al-Ge-Si alloys

Wei Gan et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)

添加到收藏夹

Article Nanoscience & Nanotechnology

Origin of the Bauschinger effect in a polycrystalline material

A. A. Mamun et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)

添加到收藏夹

Article Materials Science, Multidisciplinary

In situ investigation of extension twinning-detwinning and its effect on the mechanical behavior of AZ31B magnesium alloy

B. L. Wu et al.

MATERIALS & DESIGN (2017)

添加到收藏夹

Article Engineering, Mechanical

An experimental study of cyclic plastic deformation of extruded ZK60 magnesium alloy under uniaxial loading at room temperature

Ying Xiong et al.

INTERNATIONAL JOURNAL OF PLASTICITY (2014)

添加到收藏夹

Article Mathematics, Applied

A practical constitutive model for AZ31B Mg alloy sheets with unusual stress-strain response

Ngoc-Trung Nguyen et al.

FINITE ELEMENTS IN ANALYSIS AND DESIGN (2013)

添加到收藏夹

Article Nanoscience & Nanotechnology

Twinning and its related work hardening during the ambient extrusion of a magnesium alloy

Zhen Zhang

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2013)

添加到收藏夹

Article Materials Science, Multidisciplinary

Temperature dependency of slip and twinning in plane strain compressed magnesium single crystals

Adrien Chapuis et al.

ACTA MATERIALIA (2011)

添加到收藏夹

Article Materials Science, Multidisciplinary

Role of {10-12} twinning characteristics in the deformation behavior of a polycrystalline magnesium alloy

Seong-Gu Hong et al.

ACTA MATERIALIA (2010)

添加到收藏夹

Article Chemistry, Physical

On tension-compression yield asymmetry in an extruded Mg-3Al-1Zn alloy

De Liang Yin et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2009)

添加到收藏夹

Article Nanoscience & Nanotechnology

Twinning and the ductility of magnesium alloys Part I: Tension twins

M. R. Barnett

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2007)

添加到收藏夹

Article Nanoscience & Nanotechnology

Twinning and the ductility of magnesium alloys Part II. Contraction twins

M. R. Barnett

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2007)

添加到收藏夹

Article Nanoscience & Nanotechnology

Influence of {10-12} extension twinning on the flow behavior of AZ31 Mg alloy

Lan Jiang et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2007)

添加到收藏夹

Article Engineering, Mechanical

Hardening evolution of AZ31B Mg sheet

X. Y. Lou et al.

INTERNATIONAL JOURNAL OF PLASTICITY (2007)

添加到收藏夹

Article Materials Science, Multidisciplinary

A semianalytical Sachs model for the flow stress of a magnesium alloy

M. R. Barnett et al.

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2006)

添加到收藏夹

Article Nanoscience & Nanotechnology

Magnesium - Properties - applications - potential

BL Mordike et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2001)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.