☆ 4.7 Article

Multi-objective performance optimization of target surface of bionic blue whale-skin impinged by array jet

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Thermodynamics

Performance analysis of phase-change material in battery thermal management with bionic leaf vein structure

Fen Liu et al.

Summary: This study proposes a battery thermal management system that combines leaf vein fins with PCM. By optimizing the structure and topology parameters of the leaf vein fins, the overall thermal conductivity is improved and the cell temperature is uniformly reduced.

APPLIED THERMAL ENGINEERING (2022)

添加到收藏夹

Article Thermodynamics

A case study on thermo-hydraulic performance of jet plate solar air heater using response surface methodology

Mahalingam Murugesan Matheswaran et al.

Summary: In this study, the multi-hole jet impingement approach was used to improve the performance of the jet plate solar air heater by enhancing the heat transfer coefficient between the absorber plate and the impinging air. The system's usefulness was analyzed and the effects of airflow rate, length of the collector, jet diameter, pitch distances, and spanwise directions on thermo-hydraulic efficiency were investigated using Response Surface Methodology (RSM). A quadratic equation was generated to predict the thermohydraulic efficiency. The results showed optimized design parameters for the airflow rate, collector length, jet diameter, stream-wise pitch distance, and span-wise pitch distance.

CASE STUDIES IN THERMAL ENGINEERING (2022)

添加到收藏夹

Article Engineering, Mechanical

Investigation of fluid flow and heat transfer in a narrow channel with micro barchan-dune-shaped humps

Xin-Jun Li et al.

Summary: This paper proposes an innovative bionic heat sink with micro barchan-dune-shaped humps for improving flow and heat transfer performance. The effects of Reynolds number and pitch distance on thermal-hydraulic performance are investigated, and the results show promising improvements.

INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES (2022)

添加到收藏夹

Article Thermodynamics

Energy efficiency optimization of an integrated heat pipe cooling system in data center based on genetic algorithm

Zhiguang He et al.

Summary: This paper studied the optimization of the integrated heat pipe cooling system in terms of energy consumption, establishing heat transfer and energy consumption models as well as calculating energy efficiency optimization strategies using genetic algorithms. The energy efficiency of the system was significantly improved through the optimization process, demonstrating the potential for energy savings in data center cooling systems.

APPLIED THERMAL ENGINEERING (2021)

添加到收藏夹

Article Thermodynamics

A study on heat transfer characteristics by impinging jet with several velocities distribution

Seydou Nourou Diop et al.

Summary: Efficient cooling of a heated surface can be achieved by enhancing the heat transfer coefficient through properly adjusting the air jet flow velocity and collision distances.

CASE STUDIES IN THERMAL ENGINEERING (2021)

添加到收藏夹

Article Thermodynamics

Multi-objective optimization of finned metal foam heat sinks: Tradeoff between heat transfer and pressure drop

Nicola Bianco et al.

Summary: In this paper, numerical analysis is used to study optimized design of metal foam heat sinks, proposing a method to simultaneously maximize heat rate and minimize pumping power.

APPLIED THERMAL ENGINEERING (2021)

添加到收藏夹

Article Thermodynamics

Finned heat sinks with phase change materials and metal foams: Pareto optimization to address cost and operation time

Nicola Bianco et al.

Summary: The study optimized the design of a heat sink using a mathematical model and genetic algorithm to achieve a balance between maximizing operation time and minimizing cost. The optimal solution features an operation time of 4000 s with a cost of about 225 euro per device.

APPLIED THERMAL ENGINEERING (2021)

添加到收藏夹

Article Thermodynamics

On the thermal management of a power electronics system: Optimization of the cooling system using genetic algorithm and response surface method

Farzad Pourfattah et al.

Summary: The study developed a new cooling system incorporating jet impinging, pin fins, and vortex generators to reduce the operating temperature of a power electronics module to an average of 75 degrees Celsius. Results showed that the temperature of the power module was most sensitive to changes in coolant flow rate and the vertical position of the vortex generator.

ENERGY (2021)

添加到收藏夹

Article Engineering, Civil

A comprehensive uncertainty analysis of model-estimated longitudinal and lateral dispersion coefficients in open channels

Mohammad Najafzadeh et al.

Summary: The complexity of pollutant-mixing mechanism in rivers leads to large uncertainty in estimating longitudinal and lateral dispersion coefficients (K-x and K-y). By introducing a method based on thorough analysis of calibration datasets, it was found that different intelligent models have varying levels of uncertainty in K-x and K-y estimation. Incorporating uncertainty determination methods into empirical studies is suggested due to significant uncertainty in model estimations.

JOURNAL OF HYDROLOGY (2021)

添加到收藏夹

Article Thermodynamics

Weight and performance optimization of rectangular staggered fins heat exchangers for miniaturized hydraulic power units using genetic algorithm

Yayun Zhang et al.

Summary: This study investigates an ideal lightweight heat exchanger for miniaturized hydraulic power units and optimizes its key parameters using genetic algorithm, resulting in a significant improvement in heat transfer performance. The optimized heat exchanger has a reduced total weight of 25.49% and increased heat transfer capacity of 24.22%, which is a great advancement for the miniaturization and lightweight of hydraulic power units.

CASE STUDIES IN THERMAL ENGINEERING (2021)

添加到收藏夹

Article Thermodynamics

Heat exchange enhancement of jet impingement cooling with the novel humped-cone heat sink

Marcin Froissart et al.

Summary: This study focused on improving jet impingement cooling efficiency by modifying the heat sink geometry, resulting in an 11% increase in cooling capability compared to a reference flat surface.

CASE STUDIES IN THERMAL ENGINEERING (2021)

添加到收藏夹

Article Thermodynamics

Structural optimization of phase change material based heat exchanger for breathing air cooling

You Lv et al.

Summary: The study focuses on the design of a heat exchanger based on phase change materials to provide suitable breathing air temperature for civilians during fires. By optimizing the design with twin heat exchangers, the breathing resistance is reduced by up to 65% and weight is decreased by 30%, improving the comfort of wearing the respirator.

APPLIED THERMAL ENGINEERING (2021)

添加到收藏夹

Article Thermodynamics

Investigation of convective heat transfer and flow hydrodynamics in rectangular grooved channels

Harun Zontul et al.

Summary: An experimental and numerical investigation was conducted to study convective heat transfer and flow characteristics in a channel with rectangular grooved walls. Results showed that using grooved channels increased Nusselt number but also resulted in pressure loss.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2021)

添加到收藏夹

Article Thermodynamics

Response surface methodology based optimization of air-film blade cooled gas turbine cycle for thermal performance prediction

Shivam Mishra et al.

APPLIED THERMAL ENGINEERING (2020)

添加到收藏夹

Article Thermodynamics

Heat transfer enhancement, entropy generation and temperature uniformity analyses of shark-skin bionic modified microchannel heat sink

Ping Li et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2020)

添加到收藏夹

Article Thermodynamics

Enhancement of jet impingement heat transfer using surface roughness elements at different heat inputs

K. Nagesha et al.

EXPERIMENTAL THERMAL AND FLUID SCIENCE (2020)

添加到收藏夹

Article Engineering, Chemical

Effect of squid fin bionic surface and magnetic nanofluids on CPU cooling performance under magnetic field

Cong Qi et al.

ASIA-PACIFIC JOURNAL OF CHEMICAL ENGINEERING (2020)

添加到收藏夹

Article Thermodynamics

Effect of micro-roughness shapes on jet impingement heat transfer and fin-effectiveness

Prashant Singh et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2019)

添加到收藏夹

Article Thermodynamics

Numerical study on the flow and heat transfer characteristics in a dimple cooling channel with a wedge-shaped vortex generator

Jae Sung Yang et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2019)

添加到收藏夹

Article Thermodynamics

Effect of dimple pitch and depth on jet impingement heat transfer over dimpled surface impinged by multiple jets

Ravish Vinze et al.

INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2019)

添加到收藏夹

Article Thermodynamics

Heat transfer of impinging jet arrays onto half-smooth, half-rough target surfaces

Yuan-Hsiang Lo et al.

APPLIED THERMAL ENGINEERING (2018)

添加到收藏夹

Article Thermodynamics

Numerical investigations of impingement cooling performance on flat and non-flat targets with dimple/protrusion and triangular rib

Qi Jing et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2018)

添加到收藏夹

Article Thermodynamics

Arrangement effects of inclined teardrop-shaped dimples on film cooling performance of dimpled cutback surface at airfoil trailing edge

Akira Murata et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2017)

添加到收藏夹

Article Thermodynamics

Heat transfer enhancement on a microchannel heat sink with impinging jets and dimples

Xiaoming Huang et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2017)

添加到收藏夹

Article Thermodynamics

Influences of target surface small-scale rectangle roughness on impingement jet array heat transfer

Warren C. Buzzard et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2017)

添加到收藏夹

Article Thermodynamics

Sensitivity analysis and multi-objective optimization of a heat exchanger tube with conical strip vortex generators

Nianben Zheng et al.

APPLIED THERMAL ENGINEERING (2017)

添加到收藏夹

Article Thermodynamics

Modeling and Pareto based multi-objective optimization of wavy fin-and-elliptical tube heat exchangers using CFD and NSGA-II algorithm

Mohammad Darvish Damavandi et al.

APPLIED THERMAL ENGINEERING (2017)

添加到收藏夹

Article Thermodynamics

Evaluation of cooling performance of impinging jet array over various dimpled surfaces

Sun-Min Kim et al.

HEAT AND MASS TRANSFER (2016)

添加到收藏夹

Article Thermodynamics

Multi-objective optimization of heat exchanger in an automotive exhaust thermoelectric generator

C. Liu et al.

APPLIED THERMAL ENGINEERING (2016)

添加到收藏夹

Article Thermodynamics

Optimization of shape and angle of attack of winglet vortex generator in a rectangular channel for heat transfer enhancement

Azita Abdollahi et al.

APPLIED THERMAL ENGINEERING (2015)

添加到收藏夹

Article Thermodynamics

Optimum thermal design of triangular, trapezoidal and rectangular grooved microchannel heat sinks

Hamdi E. Ahmed et al.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2015)

添加到收藏夹

Article Thermodynamics

Turbulent flow and heat transfer enhancement in rectangular channels with novel cylindrical grooves

Jian Liu et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2015)

添加到收藏夹

Article Thermodynamics

Numerical study on characteristics of flow and heat transfer in a cooling passage with a tear-drop dimple surface

Hyun Sik Yoon et al.

INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2015)

添加到收藏夹

Proceedings Paper Thermodynamics

Steady State Jet Impingement Heat Transfer from Axisymmetric Plates with and without Grooves

B. T. Kannan et al.

INTERNATIONAL CONFERENCE ON COMPUTATIONAL HEAT AND MASS TRANSFER (ICCHMT) - 2015 (2015)

添加到收藏夹

Article Thermodynamics

Flow and heat transfer characteristics of single jet impinging on protrusioned surface

Di Zhang et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2013)

添加到收藏夹

Article Thermodynamics

Jet impingement heat transfer on target surfaces with longitudinal and transverse grooves

Yao-Hsien Liu et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2013)

添加到收藏夹

Article Thermodynamics

Heat transfer correlations of perpendicularly impinging jets on a hemispherical-dimpled surface

Koonlaya Kanokjaruvijit et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2010)

添加到收藏夹

Article Thermodynamics

LES OF IMPINGEMENT HEAT TRANSFER ON A CONCAVE SURFACE

R. J. Jefferson-Loveday et al.

NUMERICAL HEAT TRANSFER PART A-APPLICATIONS (2010)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.